1 /* SPDX-License-Identifier: GPL-2.0+ */ 2 /* 3 * Configuation settings for the Renesas Solutions AP-325RXA board 4 * 5 * Copyright (C) 2008 Renesas Solutions Corp. 6 * Copyright (C) 2008 Nobuhiro Iwamatsu <iwamatsu.nobuhiro@renesas.com> 7 */ 8 9 #ifndef __AP325RXA_H 10 #define __AP325RXA_H 11 12 #define CONFIG_CPU_SH7723 1 13 14 #define CONFIG_DISPLAY_BOARDINFO 15 #undef CONFIG_SHOW_BOOT_PROGRESS 16 17 /* MEMORY */ 18 #define AP325RXA_SDRAM_BASE (0x88000000) 19 #define AP325RXA_FLASH_BASE_1 (0xA0000000) 20 #define AP325RXA_FLASH_BANK_SIZE (128 * 1024 * 1024) 21 22 /* undef to save memory */ 23 /* Monitor Command Prompt */ 24 /* Buffer size for Console output */ 25 #define CONFIG_SYS_PBSIZE 256 26 /* List of legal baudrate settings for this board */ 27 #define CONFIG_SYS_BAUDRATE_TABLE { 38400 } 28 29 /* SCIF */ 30 #define CONFIG_SCIF_A 1 /* SH7723 has SCIF and SCIFA */ 31 #define CONFIG_CONS_SCIF5 1 32 33 /* Suppress display of console information at boot */ 34 35 #define CONFIG_SYS_MEMTEST_START (AP325RXA_SDRAM_BASE) 36 #define CONFIG_SYS_MEMTEST_END (CONFIG_SYS_MEMTEST_START + (60 * 1024 * 1024)) 37 38 /* Enable alternate, more extensive, memory test */ 39 /* Scratch address used by the alternate memory test */ 40 #undef CONFIG_SYS_MEMTEST_SCRATCH 41 42 /* Enable temporary baudrate change while serial download */ 43 #undef CONFIG_SYS_LOADS_BAUD_CHANGE 44 45 #define CONFIG_SYS_SDRAM_BASE (AP325RXA_SDRAM_BASE) 46 /* maybe more, but if so u-boot doesn't know about it... */ 47 #define CONFIG_SYS_SDRAM_SIZE (128 * 1024 * 1024) 48 /* default load address for scripts ?!? */ 49 #define CONFIG_SYS_LOAD_ADDR (CONFIG_SYS_SDRAM_BASE + 16 * 1024 * 1024) 50 51 /* Address of u-boot image in Flash (NOT run time address in SDRAM) ?!? */ 52 #define CONFIG_SYS_MONITOR_BASE (AP325RXA_FLASH_BASE_1) 53 /* Monitor size */ 54 #define CONFIG_SYS_MONITOR_LEN (128 * 1024) 55 /* Size of DRAM reserved for malloc() use */ 56 #define CONFIG_SYS_MALLOC_LEN (256 * 1024) 57 #define CONFIG_SYS_BOOTMAPSZ (8 * 1024 * 1024) 58 59 /* FLASH */ 60 #define CONFIG_FLASH_CFI_DRIVER 1 61 #define CONFIG_SYS_FLASH_CFI 62 #undef CONFIG_SYS_FLASH_QUIET_TEST 63 /* print 'E' for empty sector on flinfo */ 64 #define CONFIG_SYS_FLASH_EMPTY_INFO 65 /* Physical start address of Flash memory */ 66 #define CONFIG_SYS_FLASH_BASE (AP325RXA_FLASH_BASE_1) 67 /* Max number of sectors on each Flash chip */ 68 #define CONFIG_SYS_MAX_FLASH_SECT 512 69 70 /* 71 * IDE support 72 */ 73 #define CONFIG_IDE_RESET 1 74 #define CONFIG_SYS_PIO_MODE 1 75 #define CONFIG_SYS_IDE_MAXBUS 1 /* IDE bus */ 76 #define CONFIG_SYS_IDE_MAXDEVICE 1 77 #define CONFIG_SYS_ATA_BASE_ADDR 0xB4180000 78 #define CONFIG_SYS_ATA_STRIDE 2 /* 1bit shift */ 79 #define CONFIG_SYS_ATA_DATA_OFFSET 0x200 /* data reg offset */ 80 #define CONFIG_SYS_ATA_REG_OFFSET 0x200 /* reg offset */ 81 #define CONFIG_SYS_ATA_ALT_OFFSET 0x210 /* alternate register offset */ 82 #define CONFIG_IDE_SWAP_IO 83 84 /* if you use all NOR Flash , you change dip-switch. Please see Manual. */ 85 #define CONFIG_SYS_MAX_FLASH_BANKS 1 86 #define CONFIG_SYS_FLASH_BANKS_LIST { CONFIG_SYS_FLASH_BASE + (0 * AP325RXA_FLASH_BANK_SIZE)} 87 88 /* Timeout for Flash erase operations (in ms) */ 89 #define CONFIG_SYS_FLASH_ERASE_TOUT (3 * 1000) 90 /* Timeout for Flash write operations (in ms) */ 91 #define CONFIG_SYS_FLASH_WRITE_TOUT (3 * 1000) 92 /* Timeout for Flash set sector lock bit operations (in ms) */ 93 #define CONFIG_SYS_FLASH_LOCK_TOUT (3 * 1000) 94 /* Timeout for Flash clear lock bit operations (in ms) */ 95 #define CONFIG_SYS_FLASH_UNLOCK_TOUT (3 * 1000) 96 97 /* 98 * Use hardware flash sectors protection instead 99 * of U-Boot software protection 100 */ 101 #undef CONFIG_SYS_FLASH_PROTECTION 102 #undef CONFIG_SYS_DIRECT_FLASH_TFTP 103 104 /* ENV setting */ 105 #define CONFIG_ENV_OVERWRITE 1 106 #define CONFIG_ENV_SECT_SIZE (128 * 1024) 107 #define CONFIG_ENV_SIZE (CONFIG_ENV_SECT_SIZE) 108 #define CONFIG_ENV_ADDR (CONFIG_SYS_FLASH_BASE + CONFIG_SYS_MONITOR_LEN) 109 /* Offset of env Flash sector relative to CONFIG_SYS_FLASH_BASE */ 110 #define CONFIG_ENV_OFFSET (CONFIG_ENV_ADDR - CONFIG_SYS_FLASH_BASE) 111 #define CONFIG_ENV_SIZE_REDUND (CONFIG_ENV_SECT_SIZE) 112 113 /* Board Clock */ 114 #define CONFIG_SYS_CLK_FREQ 33333333 115 #define CONFIG_SH_TMU_CLK_FREQ CONFIG_SYS_CLK_FREQ 116 #define CONFIG_SH_SCIF_CLK_FREQ CONFIG_SYS_CLK_FREQ 117 118 #endif /* __AP325RXA_H */ 119