1 /* 2 * Configuation settings for the Renesas Solutions AP-325RXA board 3 * 4 * Copyright (C) 2008 Renesas Solutions Corp. 5 * Copyright (C) 2008 Nobuhiro Iwamatsu <iwamatsu.nobuhiro@renesas.com> 6 * 7 * SPDX-License-Identifier: GPL-2.0+ 8 */ 9 10 #ifndef __AP325RXA_H 11 #define __AP325RXA_H 12 13 #define CONFIG_CPU_SH7723 1 14 #define CONFIG_AP325RXA 1 15 16 #define CONFIG_DISPLAY_BOARDINFO 17 #undef CONFIG_SHOW_BOOT_PROGRESS 18 19 /* MEMORY */ 20 #define AP325RXA_SDRAM_BASE (0x88000000) 21 #define AP325RXA_FLASH_BASE_1 (0xA0000000) 22 #define AP325RXA_FLASH_BANK_SIZE (128 * 1024 * 1024) 23 24 #define CONFIG_SYS_TEXT_BASE 0x8FFC0000 25 26 /* undef to save memory */ 27 #define CONFIG_SYS_LONGHELP 28 /* Monitor Command Prompt */ 29 /* Buffer size for Console output */ 30 #define CONFIG_SYS_PBSIZE 256 31 /* List of legal baudrate settings for this board */ 32 #define CONFIG_SYS_BAUDRATE_TABLE { 38400 } 33 34 /* SCIF */ 35 #define CONFIG_SCIF_A 1 /* SH7723 has SCIF and SCIFA */ 36 #define CONFIG_CONS_SCIF5 1 37 38 /* Suppress display of console information at boot */ 39 40 #define CONFIG_SYS_MEMTEST_START (AP325RXA_SDRAM_BASE) 41 #define CONFIG_SYS_MEMTEST_END (CONFIG_SYS_MEMTEST_START + (60 * 1024 * 1024)) 42 43 /* Enable alternate, more extensive, memory test */ 44 #undef CONFIG_SYS_ALT_MEMTEST 45 /* Scratch address used by the alternate memory test */ 46 #undef CONFIG_SYS_MEMTEST_SCRATCH 47 48 /* Enable temporary baudrate change while serial download */ 49 #undef CONFIG_SYS_LOADS_BAUD_CHANGE 50 51 #define CONFIG_SYS_SDRAM_BASE (AP325RXA_SDRAM_BASE) 52 /* maybe more, but if so u-boot doesn't know about it... */ 53 #define CONFIG_SYS_SDRAM_SIZE (128 * 1024 * 1024) 54 /* default load address for scripts ?!? */ 55 #define CONFIG_SYS_LOAD_ADDR (CONFIG_SYS_SDRAM_BASE + 16 * 1024 * 1024) 56 57 /* Address of u-boot image in Flash (NOT run time address in SDRAM) ?!? */ 58 #define CONFIG_SYS_MONITOR_BASE (AP325RXA_FLASH_BASE_1) 59 /* Monitor size */ 60 #define CONFIG_SYS_MONITOR_LEN (128 * 1024) 61 /* Size of DRAM reserved for malloc() use */ 62 #define CONFIG_SYS_MALLOC_LEN (256 * 1024) 63 #define CONFIG_SYS_BOOTMAPSZ (8 * 1024 * 1024) 64 65 /* FLASH */ 66 #define CONFIG_FLASH_CFI_DRIVER 1 67 #define CONFIG_SYS_FLASH_CFI 68 #undef CONFIG_SYS_FLASH_QUIET_TEST 69 /* print 'E' for empty sector on flinfo */ 70 #define CONFIG_SYS_FLASH_EMPTY_INFO 71 /* Physical start address of Flash memory */ 72 #define CONFIG_SYS_FLASH_BASE (AP325RXA_FLASH_BASE_1) 73 /* Max number of sectors on each Flash chip */ 74 #define CONFIG_SYS_MAX_FLASH_SECT 512 75 76 /* 77 * IDE support 78 */ 79 #define CONFIG_IDE_RESET 1 80 #define CONFIG_SYS_PIO_MODE 1 81 #define CONFIG_SYS_IDE_MAXBUS 1 /* IDE bus */ 82 #define CONFIG_SYS_IDE_MAXDEVICE 1 83 #define CONFIG_SYS_ATA_BASE_ADDR 0xB4180000 84 #define CONFIG_SYS_ATA_STRIDE 2 /* 1bit shift */ 85 #define CONFIG_SYS_ATA_DATA_OFFSET 0x200 /* data reg offset */ 86 #define CONFIG_SYS_ATA_REG_OFFSET 0x200 /* reg offset */ 87 #define CONFIG_SYS_ATA_ALT_OFFSET 0x210 /* alternate register offset */ 88 #define CONFIG_IDE_SWAP_IO 89 90 /* if you use all NOR Flash , you change dip-switch. Please see Manual. */ 91 #define CONFIG_SYS_MAX_FLASH_BANKS 1 92 #define CONFIG_SYS_FLASH_BANKS_LIST { CONFIG_SYS_FLASH_BASE + (0 * AP325RXA_FLASH_BANK_SIZE)} 93 94 /* Timeout for Flash erase operations (in ms) */ 95 #define CONFIG_SYS_FLASH_ERASE_TOUT (3 * 1000) 96 /* Timeout for Flash write operations (in ms) */ 97 #define CONFIG_SYS_FLASH_WRITE_TOUT (3 * 1000) 98 /* Timeout for Flash set sector lock bit operations (in ms) */ 99 #define CONFIG_SYS_FLASH_LOCK_TOUT (3 * 1000) 100 /* Timeout for Flash clear lock bit operations (in ms) */ 101 #define CONFIG_SYS_FLASH_UNLOCK_TOUT (3 * 1000) 102 103 /* 104 * Use hardware flash sectors protection instead 105 * of U-Boot software protection 106 */ 107 #undef CONFIG_SYS_FLASH_PROTECTION 108 #undef CONFIG_SYS_DIRECT_FLASH_TFTP 109 110 /* ENV setting */ 111 #define CONFIG_ENV_OVERWRITE 1 112 #define CONFIG_ENV_SECT_SIZE (128 * 1024) 113 #define CONFIG_ENV_SIZE (CONFIG_ENV_SECT_SIZE) 114 #define CONFIG_ENV_ADDR (CONFIG_SYS_FLASH_BASE + CONFIG_SYS_MONITOR_LEN) 115 /* Offset of env Flash sector relative to CONFIG_SYS_FLASH_BASE */ 116 #define CONFIG_ENV_OFFSET (CONFIG_ENV_ADDR - CONFIG_SYS_FLASH_BASE) 117 #define CONFIG_ENV_SIZE_REDUND (CONFIG_ENV_SECT_SIZE) 118 119 /* Board Clock */ 120 #define CONFIG_SYS_CLK_FREQ 33333333 121 #define CONFIG_SH_TMU_CLK_FREQ CONFIG_SYS_CLK_FREQ 122 #define CONFIG_SH_SCIF_CLK_FREQ CONFIG_SYS_CLK_FREQ 123 #define CONFIG_SYS_TMU_CLK_DIV (4) /* 4 (default), 16, 64, 256 or 1024 */ 124 125 #endif /* __AP325RXA_H */ 126