1 /* 2 * Configuation settings for the Freescale MCF5329 FireEngine board. 3 * 4 * Copyright (C) 2004-2007 Freescale Semiconductor, Inc. 5 * TsiChung Liew (Tsi-Chung.Liew@freescale.com) 6 * 7 * SPDX-License-Identifier: GPL-2.0+ 8 */ 9 10 /* 11 * board/config.h - configuration options, board specific 12 */ 13 14 #ifndef _M5329EVB_H 15 #define _M5329EVB_H 16 17 /* 18 * High Level Configuration Options 19 * (easy to change) 20 */ 21 22 #define CONFIG_MCFUART 23 #define CONFIG_SYS_UART_PORT (0) 24 25 #undef CONFIG_WATCHDOG 26 #define CONFIG_WATCHDOG_TIMEOUT 5000 /* timeout in milliseconds, max timeout is 6.71sec */ 27 28 #define CONFIG_SYS_UNIFY_CACHE 29 30 #define CONFIG_MCFFEC 31 #ifdef CONFIG_MCFFEC 32 # define CONFIG_MII 1 33 # define CONFIG_MII_INIT 1 34 # define CONFIG_SYS_DISCOVER_PHY 35 # define CONFIG_SYS_RX_ETH_BUFFER 8 36 # define CONFIG_SYS_FAULT_ECHO_LINK_DOWN 37 38 # define CONFIG_SYS_FEC0_PINMUX 0 39 # define CONFIG_SYS_FEC0_MIIBASE CONFIG_SYS_FEC0_IOBASE 40 # define MCFFEC_TOUT_LOOP 50000 41 /* If CONFIG_SYS_DISCOVER_PHY is not defined - hardcoded */ 42 # ifndef CONFIG_SYS_DISCOVER_PHY 43 # define FECDUPLEX FULL 44 # define FECSPEED _100BASET 45 # else 46 # ifndef CONFIG_SYS_FAULT_ECHO_LINK_DOWN 47 # define CONFIG_SYS_FAULT_ECHO_LINK_DOWN 48 # endif 49 # endif /* CONFIG_SYS_DISCOVER_PHY */ 50 #endif 51 52 #define CONFIG_MCFRTC 53 #undef RTC_DEBUG 54 55 /* Timer */ 56 #define CONFIG_MCFTMR 57 #undef CONFIG_MCFPIT 58 59 /* I2C */ 60 #define CONFIG_SYS_I2C 61 #define CONFIG_SYS_I2C_FSL 62 #define CONFIG_SYS_FSL_I2C_SPEED 80000 63 #define CONFIG_SYS_FSL_I2C_SLAVE 0x7F 64 #define CONFIG_SYS_FSL_I2C_OFFSET 0x58000 65 #define CONFIG_SYS_IMMR CONFIG_SYS_MBAR 66 67 #define CONFIG_UDP_CHECKSUM 68 69 #ifdef CONFIG_MCFFEC 70 # define CONFIG_IPADDR 192.162.1.2 71 # define CONFIG_NETMASK 255.255.255.0 72 # define CONFIG_SERVERIP 192.162.1.1 73 # define CONFIG_GATEWAYIP 192.162.1.1 74 #endif /* FEC_ENET */ 75 76 #define CONFIG_HOSTNAME M5329EVB 77 #define CONFIG_EXTRA_ENV_SETTINGS \ 78 "netdev=eth0\0" \ 79 "loadaddr=40010000\0" \ 80 "u-boot=u-boot.bin\0" \ 81 "load=tftp ${loadaddr) ${u-boot}\0" \ 82 "upd=run load; run prog\0" \ 83 "prog=prot off 0 3ffff;" \ 84 "era 0 3ffff;" \ 85 "cp.b ${loadaddr} 0 ${filesize};" \ 86 "save\0" \ 87 "" 88 89 #define CONFIG_PRAM 512 /* 512 KB */ 90 #define CONFIG_SYS_LONGHELP /* undef to save memory */ 91 92 #ifdef CONFIG_CMD_KGDB 93 # define CONFIG_SYS_CBSIZE 1024 /* Console I/O Buffer Size */ 94 #else 95 # define CONFIG_SYS_CBSIZE 256 /* Console I/O Buffer Size */ 96 #endif 97 98 #define CONFIG_SYS_PBSIZE (CONFIG_SYS_CBSIZE+sizeof(CONFIG_SYS_PROMPT)+16) /* Print Buffer Size */ 99 #define CONFIG_SYS_MAXARGS 16 /* max number of command args */ 100 #define CONFIG_SYS_BARGSIZE CONFIG_SYS_CBSIZE /* Boot Argument Buffer Size */ 101 #define CONFIG_SYS_LOAD_ADDR 0x40010000 102 103 #define CONFIG_SYS_CLK 80000000 104 #define CONFIG_SYS_CPU_CLK CONFIG_SYS_CLK * 3 105 106 #define CONFIG_SYS_MBAR 0xFC000000 107 108 #define CONFIG_SYS_LATCH_ADDR (CONFIG_SYS_CS1_BASE + 0x80000) 109 110 /* 111 * Low Level Configuration Settings 112 * (address mappings, register initial values, etc.) 113 * You should know what you are doing if you make changes here. 114 */ 115 /*----------------------------------------------------------------------- 116 * Definitions for initial stack pointer and data area (in DPRAM) 117 */ 118 #define CONFIG_SYS_INIT_RAM_ADDR 0x80000000 119 #define CONFIG_SYS_INIT_RAM_SIZE 0x8000 /* Size of used area in internal SRAM */ 120 #define CONFIG_SYS_INIT_RAM_CTRL 0x221 121 #define CONFIG_SYS_GBL_DATA_OFFSET ((CONFIG_SYS_INIT_RAM_SIZE - GENERATED_GBL_DATA_SIZE) - 0x10) 122 #define CONFIG_SYS_INIT_SP_OFFSET CONFIG_SYS_GBL_DATA_OFFSET 123 124 /*----------------------------------------------------------------------- 125 * Start addresses for the final memory configuration 126 * (Set up by the startup code) 127 * Please note that CONFIG_SYS_SDRAM_BASE _must_ start at 0 128 */ 129 #define CONFIG_SYS_SDRAM_BASE 0x40000000 130 #define CONFIG_SYS_SDRAM_SIZE 32 /* SDRAM size in MB */ 131 #define CONFIG_SYS_SDRAM_CFG1 0x53722730 132 #define CONFIG_SYS_SDRAM_CFG2 0x56670000 133 #define CONFIG_SYS_SDRAM_CTRL 0xE1092000 134 #define CONFIG_SYS_SDRAM_EMOD 0x40010000 135 #define CONFIG_SYS_SDRAM_MODE 0x018D0000 136 137 #define CONFIG_SYS_MEMTEST_START CONFIG_SYS_SDRAM_BASE + 0x400 138 #define CONFIG_SYS_MEMTEST_END ((CONFIG_SYS_SDRAM_SIZE - 3) << 20) 139 140 #define CONFIG_SYS_MONITOR_BASE (CONFIG_SYS_FLASH_BASE + 0x400) 141 #define CONFIG_SYS_MONITOR_LEN (256 << 10) /* Reserve 256 kB for Monitor */ 142 143 #define CONFIG_SYS_BOOTPARAMS_LEN 64*1024 144 #define CONFIG_SYS_MALLOC_LEN (128 << 10) /* Reserve 128 kB for malloc() */ 145 146 /* 147 * For booting Linux, the board info and command line data 148 * have to be in the first 8 MB of memory, since this is 149 * the maximum mapped by the Linux kernel during initialization ?? 150 */ 151 #define CONFIG_SYS_BOOTMAPSZ (CONFIG_SYS_SDRAM_BASE + (CONFIG_SYS_SDRAM_SIZE << 20)) 152 #define CONFIG_SYS_BOOTM_LEN (CONFIG_SYS_SDRAM_SIZE << 20) 153 154 /*----------------------------------------------------------------------- 155 * FLASH organization 156 */ 157 #define CONFIG_SYS_FLASH_CFI 158 #ifdef CONFIG_SYS_FLASH_CFI 159 # define CONFIG_FLASH_CFI_DRIVER 1 160 # define CONFIG_SYS_FLASH_SIZE 0x800000 /* Max size that the board might have */ 161 # define CONFIG_SYS_FLASH_CFI_WIDTH FLASH_CFI_16BIT 162 # define CONFIG_SYS_MAX_FLASH_BANKS 1 /* max number of memory banks */ 163 # define CONFIG_SYS_MAX_FLASH_SECT 137 /* max number of sectors on one chip */ 164 # define CONFIG_SYS_FLASH_PROTECTION /* "Real" (hardware) sectors protection */ 165 #endif 166 167 #ifdef CONFIG_NANDFLASH_SIZE 168 # define CONFIG_SYS_MAX_NAND_DEVICE 1 169 # define CONFIG_SYS_NAND_BASE CONFIG_SYS_CS2_BASE 170 # define CONFIG_SYS_NAND_SIZE 1 171 # define CONFIG_SYS_NAND_BASE_LIST { CONFIG_SYS_NAND_BASE } 172 # define NAND_ALLOW_ERASE_ALL 1 173 # define CONFIG_JFFS2_NAND 1 174 # define CONFIG_JFFS2_DEV "nand0" 175 # define CONFIG_JFFS2_PART_SIZE (CONFIG_SYS_CS2_MASK & ~1) 176 # define CONFIG_JFFS2_PART_OFFSET 0x00000000 177 #endif 178 179 #define CONFIG_SYS_FLASH_BASE CONFIG_SYS_CS0_BASE 180 181 /* Configuration for environment 182 * Environment is embedded in u-boot in the second sector of the flash 183 */ 184 #define CONFIG_ENV_OFFSET 0x4000 185 #define CONFIG_ENV_SECT_SIZE 0x2000 186 187 #define LDS_BOARD_TEXT \ 188 . = DEFINED(env_offset) ? env_offset : .; \ 189 env/embedded.o(.text*); 190 191 /*----------------------------------------------------------------------- 192 * Cache Configuration 193 */ 194 #define CONFIG_SYS_CACHELINE_SIZE 16 195 196 #define ICACHE_STATUS (CONFIG_SYS_INIT_RAM_ADDR + \ 197 CONFIG_SYS_INIT_RAM_SIZE - 8) 198 #define DCACHE_STATUS (CONFIG_SYS_INIT_RAM_ADDR + \ 199 CONFIG_SYS_INIT_RAM_SIZE - 4) 200 #define CONFIG_SYS_ICACHE_INV (CF_CACR_CINVA) 201 #define CONFIG_SYS_CACHE_ACR0 (CONFIG_SYS_SDRAM_BASE | \ 202 CF_ADDRMASK(CONFIG_SYS_SDRAM_SIZE) | \ 203 CF_ACR_EN | CF_ACR_SM_ALL) 204 #define CONFIG_SYS_CACHE_ICACR (CF_CACR_EC | CF_CACR_CINVA | \ 205 CF_CACR_DCM_P) 206 207 /*----------------------------------------------------------------------- 208 * Chipselect bank definitions 209 */ 210 /* 211 * CS0 - NOR Flash 1, 2, 4, or 8MB 212 * CS1 - CompactFlash and registers 213 * CS2 - NAND Flash 16, 32, or 64MB 214 * CS3 - Available 215 * CS4 - Available 216 * CS5 - Available 217 */ 218 #define CONFIG_SYS_CS0_BASE 0 219 #define CONFIG_SYS_CS0_MASK 0x007f0001 220 #define CONFIG_SYS_CS0_CTRL 0x00001fa0 221 222 #define CONFIG_SYS_CS1_BASE 0x10000000 223 #define CONFIG_SYS_CS1_MASK 0x001f0001 224 #define CONFIG_SYS_CS1_CTRL 0x002A3780 225 226 #ifdef CONFIG_NANDFLASH_SIZE 227 #define CONFIG_SYS_CS2_BASE 0x20000000 228 #define CONFIG_SYS_CS2_MASK ((CONFIG_NANDFLASH_SIZE << 20) | 1) 229 #define CONFIG_SYS_CS2_CTRL 0x00001f60 230 #endif 231 232 #endif /* _M5329EVB_H */ 233