xref: /openbmc/u-boot/include/configs/M53017EVB.h (revision a79854a9)
1 /*
2  * Configuation settings for the Freescale MCF53017EVB.
3  *
4  * Copyright (C) 2004-2008 Freescale Semiconductor, Inc.
5  * TsiChung Liew (Tsi-Chung.Liew@freescale.com)
6  *
7  * SPDX-License-Identifier:	GPL-2.0+
8  */
9 
10 /*
11  * board/config.h - configuration options, board specific
12  */
13 
14 #ifndef _M53017EVB_H
15 #define _M53017EVB_H
16 
17 /*
18  * High Level Configuration Options
19  * (easy to change)
20  */
21 #define CONFIG_MCF5301x		/* define processor family */
22 #define CONFIG_M53015		/* define processor type */
23 
24 #define CONFIG_MCFUART
25 #define CONFIG_SYS_UART_PORT		(0)
26 #define CONFIG_BAUDRATE			115200
27 
28 #undef CONFIG_WATCHDOG
29 #define CONFIG_WATCHDOG_TIMEOUT		5000
30 
31 /* Command line configuration */
32 #include <config_cmd_default.h>
33 
34 #define CONFIG_CMD_CACHE
35 #define CONFIG_CMD_DATE
36 #define CONFIG_CMD_ELF
37 #define CONFIG_CMD_FLASH
38 #undef CONFIG_CMD_I2C
39 #define CONFIG_CMD_MEMORY
40 #define CONFIG_CMD_MISC
41 #define CONFIG_CMD_MII
42 #define CONFIG_CMD_NET
43 #define CONFIG_CMD_PING
44 #define CONFIG_CMD_REGINFO
45 
46 #define CONFIG_SYS_UNIFY_CACHE
47 
48 #define CONFIG_MCFFEC
49 #ifdef CONFIG_MCFFEC
50 #	define CONFIG_MII		1
51 #	define CONFIG_MII_INIT		1
52 #	define CONFIG_SYS_DISCOVER_PHY
53 #	define CONFIG_SYS_RX_ETH_BUFFER	8
54 #	define CONFIG_SYS_TX_ETH_BUFFER	8
55 #	define CONFIG_SYS_FEC_BUF_USE_SRAM
56 #	define CONFIG_SYS_FAULT_ECHO_LINK_DOWN
57 #	define CONFIG_HAS_ETH1
58 
59 #	define CONFIG_SYS_FEC0_PINMUX	0
60 #	define CONFIG_SYS_FEC0_MIIBASE	CONFIG_SYS_FEC0_IOBASE
61 #	define CONFIG_SYS_FEC1_PINMUX	0
62 #	define CONFIG_SYS_FEC1_MIIBASE	CONFIG_SYS_FEC1_IOBASE
63 #	define MCFFEC_TOUT_LOOP		50000
64 
65 #	define CONFIG_BOOTARGS		"root=/dev/mtdblock3 rw rootfstype=jffs2"
66 
67 /* If CONFIG_SYS_DISCOVER_PHY is not defined - hardcoded */
68 #	ifndef CONFIG_SYS_DISCOVER_PHY
69 #		define FECDUPLEX	FULL
70 #		define FECSPEED		_100BASET
71 #	else
72 #		ifndef CONFIG_SYS_FAULT_ECHO_LINK_DOWN
73 #			define CONFIG_SYS_FAULT_ECHO_LINK_DOWN
74 #		endif
75 #	endif			/* CONFIG_SYS_DISCOVER_PHY */
76 #endif
77 
78 #define CONFIG_MCFRTC
79 #undef RTC_DEBUG
80 #define CONFIG_SYS_RTC_CNT		(0x8000)
81 #define CONFIG_SYS_RTC_SETUP		(RTC_OCEN_OSCBYP | RTC_OCEN_CLKEN)
82 
83 /* Timer */
84 #define CONFIG_MCFTMR
85 #undef CONFIG_MCFPIT
86 
87 /* I2C */
88 #define CONFIG_SYS_I2C
89 #define CONFIG_SYS_I2C_FSL
90 #define CONFIG_SYS_FSL_I2C_SPEED	80000
91 #define CONFIG_SYS_FSL_I2C_SLAVE	0x7F
92 #define CONFIG_SYS_FSL_I2C_OFFSET	0x58000
93 #define CONFIG_SYS_IMMR			CONFIG_SYS_MBAR
94 
95 #define CONFIG_BOOTDELAY		1	/* autoboot after 5 seconds */
96 #define CONFIG_UDP_CHECKSUM
97 
98 #ifdef CONFIG_MCFFEC
99 #	define CONFIG_ETHADDR	00:e0:0c:bc:e5:60
100 #	define CONFIG_ETH1ADDR	00:e0:0c:bc:e5:61
101 #	define CONFIG_IPADDR	192.162.1.2
102 #	define CONFIG_NETMASK	255.255.255.0
103 #	define CONFIG_SERVERIP	192.162.1.1
104 #	define CONFIG_GATEWAYIP	192.162.1.1
105 #	define CONFIG_OVERWRITE_ETHADDR_ONCE
106 #endif				/* FEC_ENET */
107 
108 #define CONFIG_HOSTNAME		M53017
109 #define CONFIG_EXTRA_ENV_SETTINGS		\
110 	"netdev=eth0\0"				\
111 	"loadaddr=40010000\0"			\
112 	"u-boot=u-boot.bin\0"			\
113 	"load=tftp ${loadaddr) ${u-boot}\0"	\
114 	"upd=run load; run prog\0"		\
115 	"prog=prot off 0 3ffff;"		\
116 	"era 0 3ffff;"				\
117 	"cp.b ${loadaddr} 0 ${filesize};"	\
118 	"save\0"				\
119 	""
120 
121 #define CONFIG_PRAM		512	/* 512 KB */
122 #define CONFIG_SYS_PROMPT	"-> "
123 #define CONFIG_SYS_LONGHELP	/* undef to save memory */
124 
125 #ifdef CONFIG_CMD_KGDB
126 #	define CONFIG_SYS_CBSIZE	1024	/* Console I/O Buffer Size */
127 #else
128 #	define CONFIG_SYS_CBSIZE	256	/* Console I/O Buffer Size */
129 #endif
130 
131 #define CONFIG_SYS_PBSIZE	(CONFIG_SYS_CBSIZE+sizeof(CONFIG_SYS_PROMPT)+16)	/* Print Buffer Size */
132 #define CONFIG_SYS_MAXARGS	16		/* max number of cmd args */
133 #define CONFIG_SYS_BARGSIZE	CONFIG_SYS_CBSIZE	/* Boot Arg Buf Sz */
134 #define CONFIG_SYS_LOAD_ADDR	0x40010000
135 
136 #define CONFIG_SYS_HZ		1000
137 #define CONFIG_SYS_CLK		80000000
138 #define CONFIG_SYS_CPU_CLK	CONFIG_SYS_CLK * 3
139 
140 #define CONFIG_SYS_MBAR		0xFC000000
141 
142 /*
143  * Low Level Configuration Settings
144  * (address mappings, register initial values, etc.)
145  * You should know what you are doing if you make changes here.
146  */
147 /*
148  * Definitions for initial stack pointer and data area (in DPRAM)
149  */
150 #define CONFIG_SYS_INIT_RAM_ADDR	0x80000000
151 #define CONFIG_SYS_INIT_RAM_SIZE		0x20000	/* Size of used area in internal SRAM */
152 #define CONFIG_SYS_INIT_RAM_CTRL	0x221
153 #define CONFIG_SYS_GBL_DATA_OFFSET	((CONFIG_SYS_INIT_RAM_SIZE - GENERATED_GBL_DATA_SIZE) - 0x10)
154 #define CONFIG_SYS_INIT_SP_OFFSET	CONFIG_SYS_GBL_DATA_OFFSET
155 
156 /*
157  * Start addresses for the final memory configuration
158  * (Set up by the startup code)
159  * Please note that CONFIG_SYS_SDRAM_BASE _must_ start at 0
160  */
161 #define CONFIG_SYS_SDRAM_BASE		0x40000000
162 #define CONFIG_SYS_SDRAM_SIZE		64	/* SDRAM size in MB */
163 #define CONFIG_SYS_SDRAM_CFG1		0x43711630
164 #define CONFIG_SYS_SDRAM_CFG2		0x56670000
165 #define CONFIG_SYS_SDRAM_CTRL		0xE1092000
166 #define CONFIG_SYS_SDRAM_EMOD		0x80010000
167 #define CONFIG_SYS_SDRAM_MODE		0x00CD0000
168 
169 #define CONFIG_SYS_MEMTEST_START	CONFIG_SYS_SDRAM_BASE + 0x400
170 #define CONFIG_SYS_MEMTEST_END		((CONFIG_SYS_SDRAM_SIZE - 3) << 20)
171 
172 #define CONFIG_SYS_MONITOR_BASE		(CONFIG_SYS_FLASH_BASE + 0x400)
173 #define CONFIG_SYS_MONITOR_LEN		(256 << 10)	/* Reserve 256 kB for Monitor */
174 
175 #define CONFIG_SYS_BOOTPARAMS_LEN	64*1024
176 #define CONFIG_SYS_MALLOC_LEN		(128 << 10)	/* Reserve 128 kB for malloc() */
177 
178 /*
179  * For booting Linux, the board info and command line data
180  * have to be in the first 8 MB of memory, since this is
181  * the maximum mapped by the Linux kernel during initialization ??
182  */
183 #define CONFIG_SYS_BOOTMAPSZ		(CONFIG_SYS_SDRAM_BASE + (CONFIG_SYS_SDRAM_SIZE << 20))
184 #define CONFIG_SYS_BOOTM_LEN		(CONFIG_SYS_SDRAM_SIZE << 20)
185 
186 /*-----------------------------------------------------------------------
187  * FLASH organization
188  */
189 #define CONFIG_SYS_FLASH_CFI
190 #ifdef CONFIG_SYS_FLASH_CFI
191 #	define CONFIG_FLASH_CFI_DRIVER		1
192 #	define CONFIG_SYS_FLASH_USE_BUFFER_WRITE	1
193 #	define CONFIG_FLASH_SPANSION_S29WS_N	1
194 #	define CONFIG_SYS_FLASH_SIZE		0x1000000	/* Max size that the board might have */
195 #	define CONFIG_SYS_FLASH_CFI_WIDTH	FLASH_CFI_16BIT
196 #	define CONFIG_SYS_MAX_FLASH_BANKS	1	/* max number of memory banks */
197 #	define CONFIG_SYS_MAX_FLASH_SECT	137	/* max number of sectors on one chip */
198 #	define CONFIG_SYS_FLASH_PROTECTION	/* "Real" (hardware) sectors protection */
199 #endif
200 
201 #define CONFIG_SYS_FLASH_BASE		CONFIG_SYS_CS0_BASE
202 
203 /* Configuration for environment
204  * Environment is embedded in u-boot in the second sector of the flash
205  */
206 #define CONFIG_ENV_OFFSET		0x8000
207 #define CONFIG_ENV_SIZE			0x1000
208 #define CONFIG_ENV_SECT_SIZE		0x8000
209 #define CONFIG_ENV_IS_IN_FLASH		1
210 
211 /*-----------------------------------------------------------------------
212  * Cache Configuration
213  */
214 #define CONFIG_SYS_CACHELINE_SIZE	16
215 
216 #define ICACHE_STATUS			(CONFIG_SYS_INIT_RAM_ADDR + \
217 					 CONFIG_SYS_INIT_RAM_SIZE - 8)
218 #define DCACHE_STATUS			(CONFIG_SYS_INIT_RAM_ADDR + \
219 					 CONFIG_SYS_INIT_RAM_SIZE - 4)
220 #define CONFIG_SYS_ICACHE_INV		(CF_CACR_CINVA)
221 #define CONFIG_SYS_CACHE_ACR0		(CONFIG_SYS_SDRAM_BASE | \
222 					 CF_ADDRMASK(CONFIG_SYS_SDRAM_SIZE) | \
223 					 CF_ACR_EN | CF_ACR_SM_ALL)
224 #define CONFIG_SYS_CACHE_ICACR		(CF_CACR_EC | CF_CACR_CINVA | \
225 					 CF_CACR_DCM_P)
226 
227 /*-----------------------------------------------------------------------
228  * Chipselect bank definitions
229  */
230 /*
231  * CS0 - NOR Flash
232  * CS1 - Ext SRAM
233  * CS2 - Available
234  * CS3 - Available
235  * CS4 - Available
236  * CS5 - Available
237  */
238 #define CONFIG_SYS_CS0_BASE		0
239 #define CONFIG_SYS_CS0_MASK		0x00FF0001
240 #define CONFIG_SYS_CS0_CTRL		0x00001FA0
241 
242 #define CONFIG_SYS_CS1_BASE		0xC0000000
243 #define CONFIG_SYS_CS1_MASK		0x00070001
244 #define CONFIG_SYS_CS1_CTRL		0x00001FA0
245 
246 #endif				/* _M53017EVB_H */
247