1 /* 2 * Configuation settings for the Freescale MCF5329 FireEngine board. 3 * 4 * Copyright (C) 2004-2007 Freescale Semiconductor, Inc. 5 * TsiChung Liew (Tsi-Chung.Liew@freescale.com) 6 * 7 * SPDX-License-Identifier: GPL-2.0+ 8 */ 9 10 /* 11 * board/config.h - configuration options, board specific 12 */ 13 14 #ifndef _M5235EVB_H 15 #define _M5235EVB_H 16 17 /* 18 * High Level Configuration Options 19 * (easy to change) 20 */ 21 22 #define CONFIG_MCFUART 23 #define CONFIG_SYS_UART_PORT (0) 24 #define CONFIG_BAUDRATE 115200 25 26 #undef CONFIG_WATCHDOG 27 #define CONFIG_WATCHDOG_TIMEOUT 5000 /* timeout in milliseconds, max timeout is 6.71sec */ 28 29 /* 30 * BOOTP options 31 */ 32 #define CONFIG_BOOTP_BOOTFILESIZE 33 #define CONFIG_BOOTP_BOOTPATH 34 #define CONFIG_BOOTP_GATEWAY 35 #define CONFIG_BOOTP_HOSTNAME 36 37 /* Command line configuration */ 38 #define CONFIG_CMD_CACHE 39 #define CONFIG_CMD_DHCP 40 #define CONFIG_CMD_ELF 41 #define CONFIG_CMD_I2C 42 #define CONFIG_CMD_MII 43 #define CONFIG_CMD_PCI 44 #define CONFIG_CMD_PING 45 #define CONFIG_CMD_REGINFO 46 47 48 #define CONFIG_MCFFEC 49 #ifdef CONFIG_MCFFEC 50 # define CONFIG_MII 1 51 # define CONFIG_MII_INIT 1 52 # define CONFIG_SYS_DISCOVER_PHY 53 # define CONFIG_SYS_RX_ETH_BUFFER 8 54 # define CONFIG_SYS_FAULT_ECHO_LINK_DOWN 55 56 # define CONFIG_SYS_FEC0_PINMUX 0 57 # define CONFIG_SYS_FEC0_MIIBASE CONFIG_SYS_FEC0_IOBASE 58 # define MCFFEC_TOUT_LOOP 50000 59 /* If CONFIG_SYS_DISCOVER_PHY is not defined - hardcoded */ 60 # ifndef CONFIG_SYS_DISCOVER_PHY 61 # define FECDUPLEX FULL 62 # define FECSPEED _100BASET 63 # else 64 # ifndef CONFIG_SYS_FAULT_ECHO_LINK_DOWN 65 # define CONFIG_SYS_FAULT_ECHO_LINK_DOWN 66 # endif 67 # endif /* CONFIG_SYS_DISCOVER_PHY */ 68 #endif 69 70 /* Timer */ 71 #define CONFIG_MCFTMR 72 #undef CONFIG_MCFPIT 73 74 /* I2C */ 75 #define CONFIG_SYS_I2C 76 #define CONFIG_SYS_i2C_FSL 77 #define CONFIG_SYS_FSL_I2C_SPEED 80000 78 #define CONFIG_SYS_FSL_I2C_SLAVE 0x7F 79 #define CONFIG_SYS_FSL_I2C_OFFSET 0x00000300 80 #define CONFIG_SYS_IMMR CONFIG_SYS_MBAR 81 #define CONFIG_SYS_I2C_PINMUX_REG (gpio->par_qspi) 82 #define CONFIG_SYS_I2C_PINMUX_CLR ~(GPIO_PAR_FECI2C_SCL_MASK | GPIO_PAR_FECI2C_SDA_MASK) 83 #define CONFIG_SYS_I2C_PINMUX_SET (GPIO_PAR_FECI2C_SCL_I2CSCL | GPIO_PAR_FECI2C_SDA_I2CSDA) 84 85 /* this must be included AFTER the definition of CONFIG_COMMANDS (if any) */ 86 #define CONFIG_BOOTDELAY 1 /* autoboot after 5 seconds */ 87 #define CONFIG_BOOTFILE "u-boot.bin" 88 #ifdef CONFIG_MCFFEC 89 # define CONFIG_IPADDR 192.162.1.2 90 # define CONFIG_NETMASK 255.255.255.0 91 # define CONFIG_SERVERIP 192.162.1.1 92 # define CONFIG_GATEWAYIP 192.162.1.1 93 #endif /* FEC_ENET */ 94 95 #define CONFIG_HOSTNAME M5235EVB 96 #define CONFIG_EXTRA_ENV_SETTINGS \ 97 "netdev=eth0\0" \ 98 "loadaddr=10000\0" \ 99 "u-boot=u-boot.bin\0" \ 100 "load=tftp ${loadaddr) ${u-boot}\0" \ 101 "upd=run load; run prog\0" \ 102 "prog=prot off ffe00000 ffe3ffff;" \ 103 "era ffe00000 ffe3ffff;" \ 104 "cp.b ${loadaddr} ffe00000 ${filesize};"\ 105 "save\0" \ 106 "" 107 108 #define CONFIG_PRAM 512 /* 512 KB */ 109 #define CONFIG_SYS_LONGHELP /* undef to save memory */ 110 111 #if defined(CONFIG_KGDB) 112 # define CONFIG_SYS_CBSIZE 1024 /* Console I/O Buffer Size */ 113 #else 114 # define CONFIG_SYS_CBSIZE 256 /* Console I/O Buffer Size */ 115 #endif 116 117 #define CONFIG_SYS_PBSIZE (CONFIG_SYS_CBSIZE+sizeof(CONFIG_SYS_PROMPT)+16) /* Print Buffer Size */ 118 #define CONFIG_SYS_MAXARGS 16 /* max number of command args */ 119 #define CONFIG_SYS_BARGSIZE CONFIG_SYS_CBSIZE /* Boot Argument Buffer Size */ 120 #define CONFIG_SYS_LOAD_ADDR (CONFIG_SYS_SDRAM_BASE+0x20000) 121 122 #define CONFIG_SYS_CLK 75000000 123 #define CONFIG_SYS_CPU_CLK CONFIG_SYS_CLK * 2 124 125 #define CONFIG_SYS_MBAR 0x40000000 126 127 /* 128 * Low Level Configuration Settings 129 * (address mappings, register initial values, etc.) 130 * You should know what you are doing if you make changes here. 131 */ 132 /*----------------------------------------------------------------------- 133 * Definitions for initial stack pointer and data area (in DPRAM) 134 */ 135 #define CONFIG_SYS_INIT_RAM_ADDR 0x20000000 136 #define CONFIG_SYS_INIT_RAM_SIZE 0x10000 /* Size of used area in internal SRAM */ 137 #define CONFIG_SYS_INIT_RAM_CTRL 0x21 138 #define CONFIG_SYS_GBL_DATA_OFFSET (CONFIG_SYS_INIT_RAM_SIZE - GENERATED_GBL_DATA_SIZE - 0x10) 139 #define CONFIG_SYS_INIT_SP_OFFSET CONFIG_SYS_GBL_DATA_OFFSET 140 141 /*----------------------------------------------------------------------- 142 * Start addresses for the final memory configuration 143 * (Set up by the startup code) 144 * Please note that CONFIG_SYS_SDRAM_BASE _must_ start at 0 145 */ 146 #define CONFIG_SYS_SDRAM_BASE 0x00000000 147 #define CONFIG_SYS_SDRAM_SIZE 16 /* SDRAM size in MB */ 148 149 #define CONFIG_SYS_MEMTEST_START CONFIG_SYS_SDRAM_BASE + 0x400 150 #define CONFIG_SYS_MEMTEST_END ((CONFIG_SYS_SDRAM_SIZE - 3) << 20) 151 152 #define CONFIG_SYS_MONITOR_BASE (CONFIG_SYS_FLASH_BASE + 0x400) 153 #define CONFIG_SYS_MONITOR_LEN (256 << 10) /* Reserve 256 kB for Monitor */ 154 155 #define CONFIG_SYS_BOOTPARAMS_LEN 64*1024 156 #define CONFIG_SYS_MALLOC_LEN (128 << 10) /* Reserve 128 kB for malloc() */ 157 158 /* 159 * For booting Linux, the board info and command line data 160 * have to be in the first 8 MB of memory, since this is 161 * the maximum mapped by the Linux kernel during initialization ?? 162 */ 163 /* Initial Memory map for Linux */ 164 #define CONFIG_SYS_BOOTMAPSZ (CONFIG_SYS_SDRAM_BASE + (CONFIG_SYS_SDRAM_SIZE << 20)) 165 #define CONFIG_SYS_BOOTM_LEN (CONFIG_SYS_SDRAM_SIZE << 20) 166 167 /*----------------------------------------------------------------------- 168 * FLASH organization 169 */ 170 #define CONFIG_SYS_FLASH_CFI 171 #ifdef CONFIG_SYS_FLASH_CFI 172 # define CONFIG_FLASH_CFI_DRIVER 1 173 # define CONFIG_SYS_FLASH_SIZE 0x800000 /* Max size that the board might have */ 174 #ifdef NORFLASH_PS32BIT 175 # define CONFIG_SYS_FLASH_CFI_WIDTH FLASH_CFI_32BIT 176 #else 177 # define CONFIG_SYS_FLASH_CFI_WIDTH FLASH_CFI_16BIT 178 #endif 179 # define CONFIG_SYS_MAX_FLASH_BANKS 1 /* max number of memory banks */ 180 # define CONFIG_SYS_MAX_FLASH_SECT 137 /* max number of sectors on one chip */ 181 # define CONFIG_SYS_FLASH_PROTECTION /* "Real" (hardware) sectors protection */ 182 #endif 183 184 #define CONFIG_SYS_FLASH_BASE (CONFIG_SYS_CS0_BASE) 185 186 /* Configuration for environment 187 * Environment is embedded in u-boot in the second sector of the flash 188 */ 189 #define CONFIG_ENV_IS_IN_FLASH 1 190 191 #define LDS_BOARD_TEXT \ 192 . = DEFINED(env_offset) ? env_offset : .; \ 193 common/env_embedded.o (.text); 194 195 #ifdef NORFLASH_PS32BIT 196 # define CONFIG_ENV_OFFSET (0x8000) 197 # define CONFIG_ENV_SIZE 0x4000 198 # define CONFIG_ENV_SECT_SIZE 0x4000 199 #else 200 # define CONFIG_ENV_OFFSET (0x4000) 201 # define CONFIG_ENV_SIZE 0x2000 202 # define CONFIG_ENV_SECT_SIZE 0x2000 203 #endif 204 205 /*----------------------------------------------------------------------- 206 * Cache Configuration 207 */ 208 #define CONFIG_SYS_CACHELINE_SIZE 16 209 210 #define ICACHE_STATUS (CONFIG_SYS_INIT_RAM_ADDR + \ 211 CONFIG_SYS_INIT_RAM_SIZE - 8) 212 #define DCACHE_STATUS (CONFIG_SYS_INIT_RAM_ADDR + \ 213 CONFIG_SYS_INIT_RAM_SIZE - 4) 214 #define CONFIG_SYS_ICACHE_INV (CF_CACR_CINV) 215 #define CONFIG_SYS_CACHE_ACR0 (CONFIG_SYS_SDRAM_BASE | \ 216 CF_ADDRMASK(CONFIG_SYS_SDRAM_SIZE) | \ 217 CF_ACR_EN | CF_ACR_SM_ALL) 218 #define CONFIG_SYS_CACHE_ICACR (CF_CACR_CENB | CF_CACR_DISD | \ 219 CF_CACR_CEIB | CF_CACR_DCM | \ 220 CF_CACR_EUSP) 221 222 /*----------------------------------------------------------------------- 223 * Chipselect bank definitions 224 */ 225 /* 226 * CS0 - NOR Flash 1, 2, 4, or 8MB 227 * CS1 - Available 228 * CS2 - Available 229 * CS3 - Available 230 * CS4 - Available 231 * CS5 - Available 232 * CS6 - Available 233 * CS7 - Available 234 */ 235 #ifdef NORFLASH_PS32BIT 236 # define CONFIG_SYS_CS0_BASE 0xFFC00000 237 # define CONFIG_SYS_CS0_MASK 0x003f0001 238 # define CONFIG_SYS_CS0_CTRL 0x00001D00 239 #else 240 # define CONFIG_SYS_CS0_BASE 0xFFE00000 241 # define CONFIG_SYS_CS0_MASK 0x001f0001 242 # define CONFIG_SYS_CS0_CTRL 0x00001D80 243 #endif 244 245 #endif /* _M5329EVB_H */ 246