xref: /openbmc/u-boot/include/configs/M5235EVB.h (revision a79854a9)
1 /*
2  * Configuation settings for the Freescale MCF5329 FireEngine board.
3  *
4  * Copyright (C) 2004-2007 Freescale Semiconductor, Inc.
5  * TsiChung Liew (Tsi-Chung.Liew@freescale.com)
6  *
7  * SPDX-License-Identifier:	GPL-2.0+
8  */
9 
10 /*
11  * board/config.h - configuration options, board specific
12  */
13 
14 #ifndef _M5235EVB_H
15 #define _M5235EVB_H
16 
17 /*
18  * High Level Configuration Options
19  * (easy to change)
20  */
21 #define CONFIG_MCF523x		/* define processor family */
22 #define CONFIG_M5235		/* define processor type */
23 
24 #define CONFIG_MCFUART
25 #define CONFIG_SYS_UART_PORT		(0)
26 #define CONFIG_BAUDRATE		115200
27 
28 #undef CONFIG_WATCHDOG
29 #define CONFIG_WATCHDOG_TIMEOUT	5000	/* timeout in milliseconds, max timeout is 6.71sec */
30 
31 /*
32  * BOOTP options
33  */
34 #define CONFIG_BOOTP_BOOTFILESIZE
35 #define CONFIG_BOOTP_BOOTPATH
36 #define CONFIG_BOOTP_GATEWAY
37 #define CONFIG_BOOTP_HOSTNAME
38 
39 /* Command line configuration */
40 #include <config_cmd_default.h>
41 
42 #define CONFIG_CMD_BOOTD
43 #define CONFIG_CMD_CACHE
44 #define CONFIG_CMD_DHCP
45 #define CONFIG_CMD_ELF
46 #define CONFIG_CMD_FLASH
47 #define CONFIG_CMD_I2C
48 #define CONFIG_CMD_MEMORY
49 #define CONFIG_CMD_MISC
50 #define CONFIG_CMD_MII
51 #define CONFIG_CMD_NET
52 #define CONFIG_CMD_PCI
53 #define CONFIG_CMD_PING
54 #define CONFIG_CMD_REGINFO
55 
56 #undef CONFIG_CMD_LOADB
57 #undef CONFIG_CMD_LOADS
58 
59 #define CONFIG_MCFFEC
60 #ifdef CONFIG_MCFFEC
61 #	define CONFIG_MII		1
62 #	define CONFIG_MII_INIT		1
63 #	define CONFIG_SYS_DISCOVER_PHY
64 #	define CONFIG_SYS_RX_ETH_BUFFER	8
65 #	define CONFIG_SYS_FAULT_ECHO_LINK_DOWN
66 
67 #	define CONFIG_SYS_FEC0_PINMUX		0
68 #	define CONFIG_SYS_FEC0_MIIBASE		CONFIG_SYS_FEC0_IOBASE
69 #	define MCFFEC_TOUT_LOOP		50000
70 /* If CONFIG_SYS_DISCOVER_PHY is not defined - hardcoded */
71 #	ifndef CONFIG_SYS_DISCOVER_PHY
72 #		define FECDUPLEX	FULL
73 #		define FECSPEED		_100BASET
74 #	else
75 #		ifndef CONFIG_SYS_FAULT_ECHO_LINK_DOWN
76 #			define CONFIG_SYS_FAULT_ECHO_LINK_DOWN
77 #		endif
78 #	endif			/* CONFIG_SYS_DISCOVER_PHY */
79 #endif
80 
81 /* Timer */
82 #define CONFIG_MCFTMR
83 #undef CONFIG_MCFPIT
84 
85 /* I2C */
86 #define CONFIG_SYS_I2C
87 #define CONFIG_SYS_i2C_FSL
88 #define CONFIG_SYS_FSL_I2C_SPEED	80000
89 #define CONFIG_SYS_FSL_I2C_SLAVE	0x7F
90 #define CONFIG_SYS_FSL_I2C_OFFSET	0x00000300
91 #define CONFIG_SYS_IMMR		CONFIG_SYS_MBAR
92 #define CONFIG_SYS_I2C_PINMUX_REG	(gpio->par_qspi)
93 #define CONFIG_SYS_I2C_PINMUX_CLR	~(GPIO_PAR_FECI2C_SCL_MASK | GPIO_PAR_FECI2C_SDA_MASK)
94 #define CONFIG_SYS_I2C_PINMUX_SET	(GPIO_PAR_FECI2C_SCL_I2CSCL | GPIO_PAR_FECI2C_SDA_I2CSDA)
95 
96 /* this must be included AFTER the definition of CONFIG_COMMANDS (if any) */
97 #define CONFIG_BOOTDELAY	1	/* autoboot after 5 seconds */
98 #define CONFIG_BOOTFILE		"u-boot.bin"
99 #ifdef CONFIG_MCFFEC
100 #	define CONFIG_ETHADDR	00:e0:0c:bc:e5:60
101 #	define CONFIG_IPADDR	192.162.1.2
102 #	define CONFIG_NETMASK	255.255.255.0
103 #	define CONFIG_SERVERIP	192.162.1.1
104 #	define CONFIG_GATEWAYIP	192.162.1.1
105 #	define CONFIG_OVERWRITE_ETHADDR_ONCE
106 #endif				/* FEC_ENET */
107 
108 #define CONFIG_HOSTNAME		M5235EVB
109 #define CONFIG_EXTRA_ENV_SETTINGS		\
110 	"netdev=eth0\0"				\
111 	"loadaddr=10000\0"			\
112 	"u-boot=u-boot.bin\0"			\
113 	"load=tftp ${loadaddr) ${u-boot}\0"	\
114 	"upd=run load; run prog\0"		\
115 	"prog=prot off ffe00000 ffe3ffff;"	\
116 	"era ffe00000 ffe3ffff;"		\
117 	"cp.b ${loadaddr} ffe00000 ${filesize};"\
118 	"save\0"				\
119 	""
120 
121 #define CONFIG_PRAM		512	/* 512 KB */
122 #define CONFIG_SYS_PROMPT		"-> "
123 #define CONFIG_SYS_LONGHELP		/* undef to save memory */
124 
125 #if defined(CONFIG_KGDB)
126 #	define CONFIG_SYS_CBSIZE		1024	/* Console I/O Buffer Size */
127 #else
128 #	define CONFIG_SYS_CBSIZE		256	/* Console I/O Buffer Size */
129 #endif
130 
131 #define CONFIG_SYS_PBSIZE		(CONFIG_SYS_CBSIZE+sizeof(CONFIG_SYS_PROMPT)+16)	/* Print Buffer Size */
132 #define CONFIG_SYS_MAXARGS		16	/* max number of command args */
133 #define CONFIG_SYS_BARGSIZE		CONFIG_SYS_CBSIZE	/* Boot Argument Buffer Size    */
134 #define CONFIG_SYS_LOAD_ADDR		(CONFIG_SYS_SDRAM_BASE+0x20000)
135 
136 #define CONFIG_SYS_HZ			1000
137 #define CONFIG_SYS_CLK			75000000
138 #define CONFIG_SYS_CPU_CLK		CONFIG_SYS_CLK * 2
139 
140 #define CONFIG_SYS_MBAR		0x40000000
141 
142 /*
143  * Low Level Configuration Settings
144  * (address mappings, register initial values, etc.)
145  * You should know what you are doing if you make changes here.
146  */
147 /*-----------------------------------------------------------------------
148  * Definitions for initial stack pointer and data area (in DPRAM)
149  */
150 #define CONFIG_SYS_INIT_RAM_ADDR	0x20000000
151 #define CONFIG_SYS_INIT_RAM_SIZE	0x10000	/* Size of used area in internal SRAM */
152 #define CONFIG_SYS_INIT_RAM_CTRL	0x21
153 #define CONFIG_SYS_GBL_DATA_OFFSET	(CONFIG_SYS_INIT_RAM_SIZE - GENERATED_GBL_DATA_SIZE - 0x10)
154 #define CONFIG_SYS_INIT_SP_OFFSET	CONFIG_SYS_GBL_DATA_OFFSET
155 
156 /*-----------------------------------------------------------------------
157  * Start addresses for the final memory configuration
158  * (Set up by the startup code)
159  * Please note that CONFIG_SYS_SDRAM_BASE _must_ start at 0
160  */
161 #define CONFIG_SYS_SDRAM_BASE		0x00000000
162 #define CONFIG_SYS_SDRAM_SIZE		16	/* SDRAM size in MB */
163 
164 #define CONFIG_SYS_MEMTEST_START	CONFIG_SYS_SDRAM_BASE + 0x400
165 #define CONFIG_SYS_MEMTEST_END		((CONFIG_SYS_SDRAM_SIZE - 3) << 20)
166 
167 #define CONFIG_SYS_MONITOR_BASE	(CONFIG_SYS_FLASH_BASE + 0x400)
168 #define CONFIG_SYS_MONITOR_LEN		(256 << 10)	/* Reserve 256 kB for Monitor */
169 
170 #define CONFIG_SYS_BOOTPARAMS_LEN	64*1024
171 #define CONFIG_SYS_MALLOC_LEN		(128 << 10)	/* Reserve 128 kB for malloc() */
172 
173 /*
174  * For booting Linux, the board info and command line data
175  * have to be in the first 8 MB of memory, since this is
176  * the maximum mapped by the Linux kernel during initialization ??
177  */
178 /* Initial Memory map for Linux */
179 #define CONFIG_SYS_BOOTMAPSZ		(CONFIG_SYS_SDRAM_BASE + (CONFIG_SYS_SDRAM_SIZE << 20))
180 #define CONFIG_SYS_BOOTM_LEN		(CONFIG_SYS_SDRAM_SIZE << 20)
181 
182 /*-----------------------------------------------------------------------
183  * FLASH organization
184  */
185 #define CONFIG_SYS_FLASH_CFI
186 #ifdef CONFIG_SYS_FLASH_CFI
187 #	define CONFIG_FLASH_CFI_DRIVER	1
188 #	define CONFIG_SYS_FLASH_SIZE		0x800000	/* Max size that the board might have */
189 #ifdef NORFLASH_PS32BIT
190 #	define CONFIG_SYS_FLASH_CFI_WIDTH	FLASH_CFI_32BIT
191 #else
192 #	define CONFIG_SYS_FLASH_CFI_WIDTH	FLASH_CFI_16BIT
193 #endif
194 #	define CONFIG_SYS_MAX_FLASH_BANKS	1	/* max number of memory banks */
195 #	define CONFIG_SYS_MAX_FLASH_SECT	137	/* max number of sectors on one chip */
196 #	define CONFIG_SYS_FLASH_PROTECTION	/* "Real" (hardware) sectors protection */
197 #endif
198 
199 #define CONFIG_SYS_FLASH_BASE		(CONFIG_SYS_CS0_BASE)
200 
201 /* Configuration for environment
202  * Environment is embedded in u-boot in the second sector of the flash
203  */
204 #define CONFIG_ENV_IS_IN_FLASH	1
205 #ifdef NORFLASH_PS32BIT
206 #	define CONFIG_ENV_OFFSET		(0x8000)
207 #	define CONFIG_ENV_SIZE		0x4000
208 #	define CONFIG_ENV_SECT_SIZE	0x4000
209 #else
210 #	define CONFIG_ENV_OFFSET		(0x4000)
211 #	define CONFIG_ENV_SIZE		0x2000
212 #	define CONFIG_ENV_SECT_SIZE	0x2000
213 #endif
214 
215 /*-----------------------------------------------------------------------
216  * Cache Configuration
217  */
218 #define CONFIG_SYS_CACHELINE_SIZE	16
219 
220 #define ICACHE_STATUS			(CONFIG_SYS_INIT_RAM_ADDR + \
221 					 CONFIG_SYS_INIT_RAM_SIZE - 8)
222 #define DCACHE_STATUS			(CONFIG_SYS_INIT_RAM_ADDR + \
223 					 CONFIG_SYS_INIT_RAM_SIZE - 4)
224 #define CONFIG_SYS_ICACHE_INV		(CF_CACR_CINV)
225 #define CONFIG_SYS_CACHE_ACR0		(CONFIG_SYS_SDRAM_BASE | \
226 					 CF_ADDRMASK(CONFIG_SYS_SDRAM_SIZE) | \
227 					 CF_ACR_EN | CF_ACR_SM_ALL)
228 #define CONFIG_SYS_CACHE_ICACR		(CF_CACR_CENB | CF_CACR_DISD | \
229 					 CF_CACR_CEIB | CF_CACR_DCM | \
230 					 CF_CACR_EUSP)
231 
232 /*-----------------------------------------------------------------------
233  * Chipselect bank definitions
234  */
235 /*
236  * CS0 - NOR Flash 1, 2, 4, or 8MB
237  * CS1 - Available
238  * CS2 - Available
239  * CS3 - Available
240  * CS4 - Available
241  * CS5 - Available
242  * CS6 - Available
243  * CS7 - Available
244  */
245 #ifdef NORFLASH_PS32BIT
246 #	define CONFIG_SYS_CS0_BASE	0xFFC00000
247 #	define CONFIG_SYS_CS0_MASK	0x003f0001
248 #	define CONFIG_SYS_CS0_CTRL	0x00001D00
249 #else
250 #	define CONFIG_SYS_CS0_BASE	0xFFE00000
251 #	define CONFIG_SYS_CS0_MASK	0x001f0001
252 #	define CONFIG_SYS_CS0_CTRL	0x00001D80
253 #endif
254 
255 #endif				/* _M5329EVB_H */
256