1 /* 2 * Configuation settings for the Freescale MCF5329 FireEngine board. 3 * 4 * Copyright (C) 2004-2007 Freescale Semiconductor, Inc. 5 * TsiChung Liew (Tsi-Chung.Liew@freescale.com) 6 * 7 * SPDX-License-Identifier: GPL-2.0+ 8 */ 9 10 /* 11 * board/config.h - configuration options, board specific 12 */ 13 14 #ifndef _M5235EVB_H 15 #define _M5235EVB_H 16 17 /* 18 * High Level Configuration Options 19 * (easy to change) 20 */ 21 22 #define CONFIG_MCFUART 23 #define CONFIG_SYS_UART_PORT (0) 24 25 #undef CONFIG_WATCHDOG 26 #define CONFIG_WATCHDOG_TIMEOUT 5000 /* timeout in milliseconds, max timeout is 6.71sec */ 27 28 /* 29 * BOOTP options 30 */ 31 #define CONFIG_BOOTP_BOOTFILESIZE 32 33 #define CONFIG_MCFFEC 34 #ifdef CONFIG_MCFFEC 35 # define CONFIG_MII 1 36 # define CONFIG_MII_INIT 1 37 # define CONFIG_SYS_DISCOVER_PHY 38 # define CONFIG_SYS_RX_ETH_BUFFER 8 39 # define CONFIG_SYS_FAULT_ECHO_LINK_DOWN 40 41 # define CONFIG_SYS_FEC0_PINMUX 0 42 # define CONFIG_SYS_FEC0_MIIBASE CONFIG_SYS_FEC0_IOBASE 43 # define MCFFEC_TOUT_LOOP 50000 44 /* If CONFIG_SYS_DISCOVER_PHY is not defined - hardcoded */ 45 # ifndef CONFIG_SYS_DISCOVER_PHY 46 # define FECDUPLEX FULL 47 # define FECSPEED _100BASET 48 # else 49 # ifndef CONFIG_SYS_FAULT_ECHO_LINK_DOWN 50 # define CONFIG_SYS_FAULT_ECHO_LINK_DOWN 51 # endif 52 # endif /* CONFIG_SYS_DISCOVER_PHY */ 53 #endif 54 55 /* Timer */ 56 #define CONFIG_MCFTMR 57 #undef CONFIG_MCFPIT 58 59 /* I2C */ 60 #define CONFIG_SYS_I2C 61 #define CONFIG_SYS_i2C_FSL 62 #define CONFIG_SYS_FSL_I2C_SPEED 80000 63 #define CONFIG_SYS_FSL_I2C_SLAVE 0x7F 64 #define CONFIG_SYS_FSL_I2C_OFFSET 0x00000300 65 #define CONFIG_SYS_IMMR CONFIG_SYS_MBAR 66 #define CONFIG_SYS_I2C_PINMUX_REG (gpio->par_qspi) 67 #define CONFIG_SYS_I2C_PINMUX_CLR ~(GPIO_PAR_FECI2C_SCL_MASK | GPIO_PAR_FECI2C_SDA_MASK) 68 #define CONFIG_SYS_I2C_PINMUX_SET (GPIO_PAR_FECI2C_SCL_I2CSCL | GPIO_PAR_FECI2C_SDA_I2CSDA) 69 70 /* this must be included AFTER the definition of CONFIG_COMMANDS (if any) */ 71 #define CONFIG_BOOTFILE "u-boot.bin" 72 #ifdef CONFIG_MCFFEC 73 # define CONFIG_IPADDR 192.162.1.2 74 # define CONFIG_NETMASK 255.255.255.0 75 # define CONFIG_SERVERIP 192.162.1.1 76 # define CONFIG_GATEWAYIP 192.162.1.1 77 #endif /* FEC_ENET */ 78 79 #define CONFIG_HOSTNAME M5235EVB 80 #define CONFIG_EXTRA_ENV_SETTINGS \ 81 "netdev=eth0\0" \ 82 "loadaddr=10000\0" \ 83 "u-boot=u-boot.bin\0" \ 84 "load=tftp ${loadaddr) ${u-boot}\0" \ 85 "upd=run load; run prog\0" \ 86 "prog=prot off ffe00000 ffe3ffff;" \ 87 "era ffe00000 ffe3ffff;" \ 88 "cp.b ${loadaddr} ffe00000 ${filesize};"\ 89 "save\0" \ 90 "" 91 92 #define CONFIG_PRAM 512 /* 512 KB */ 93 94 #define CONFIG_SYS_LOAD_ADDR (CONFIG_SYS_SDRAM_BASE+0x20000) 95 96 #define CONFIG_SYS_CLK 75000000 97 #define CONFIG_SYS_CPU_CLK CONFIG_SYS_CLK * 2 98 99 #define CONFIG_SYS_MBAR 0x40000000 100 101 /* 102 * Low Level Configuration Settings 103 * (address mappings, register initial values, etc.) 104 * You should know what you are doing if you make changes here. 105 */ 106 /*----------------------------------------------------------------------- 107 * Definitions for initial stack pointer and data area (in DPRAM) 108 */ 109 #define CONFIG_SYS_INIT_RAM_ADDR 0x20000000 110 #define CONFIG_SYS_INIT_RAM_SIZE 0x10000 /* Size of used area in internal SRAM */ 111 #define CONFIG_SYS_INIT_RAM_CTRL 0x21 112 #define CONFIG_SYS_GBL_DATA_OFFSET (CONFIG_SYS_INIT_RAM_SIZE - GENERATED_GBL_DATA_SIZE - 0x10) 113 #define CONFIG_SYS_INIT_SP_OFFSET CONFIG_SYS_GBL_DATA_OFFSET 114 115 /*----------------------------------------------------------------------- 116 * Start addresses for the final memory configuration 117 * (Set up by the startup code) 118 * Please note that CONFIG_SYS_SDRAM_BASE _must_ start at 0 119 */ 120 #define CONFIG_SYS_SDRAM_BASE 0x00000000 121 #define CONFIG_SYS_SDRAM_SIZE 16 /* SDRAM size in MB */ 122 123 #define CONFIG_SYS_MEMTEST_START CONFIG_SYS_SDRAM_BASE + 0x400 124 #define CONFIG_SYS_MEMTEST_END ((CONFIG_SYS_SDRAM_SIZE - 3) << 20) 125 126 #define CONFIG_SYS_MONITOR_BASE (CONFIG_SYS_FLASH_BASE + 0x400) 127 #define CONFIG_SYS_MONITOR_LEN (256 << 10) /* Reserve 256 kB for Monitor */ 128 129 #define CONFIG_SYS_BOOTPARAMS_LEN 64*1024 130 #define CONFIG_SYS_MALLOC_LEN (128 << 10) /* Reserve 128 kB for malloc() */ 131 132 /* 133 * For booting Linux, the board info and command line data 134 * have to be in the first 8 MB of memory, since this is 135 * the maximum mapped by the Linux kernel during initialization ?? 136 */ 137 /* Initial Memory map for Linux */ 138 #define CONFIG_SYS_BOOTMAPSZ (CONFIG_SYS_SDRAM_BASE + (CONFIG_SYS_SDRAM_SIZE << 20)) 139 #define CONFIG_SYS_BOOTM_LEN (CONFIG_SYS_SDRAM_SIZE << 20) 140 141 /*----------------------------------------------------------------------- 142 * FLASH organization 143 */ 144 #define CONFIG_SYS_FLASH_CFI 145 #ifdef CONFIG_SYS_FLASH_CFI 146 # define CONFIG_FLASH_CFI_DRIVER 1 147 # define CONFIG_SYS_FLASH_SIZE 0x800000 /* Max size that the board might have */ 148 #ifdef NORFLASH_PS32BIT 149 # define CONFIG_SYS_FLASH_CFI_WIDTH FLASH_CFI_32BIT 150 #else 151 # define CONFIG_SYS_FLASH_CFI_WIDTH FLASH_CFI_16BIT 152 #endif 153 # define CONFIG_SYS_MAX_FLASH_BANKS 1 /* max number of memory banks */ 154 # define CONFIG_SYS_MAX_FLASH_SECT 137 /* max number of sectors on one chip */ 155 # define CONFIG_SYS_FLASH_PROTECTION /* "Real" (hardware) sectors protection */ 156 #endif 157 158 #define CONFIG_SYS_FLASH_BASE (CONFIG_SYS_CS0_BASE) 159 160 /* Configuration for environment 161 * Environment is embedded in u-boot in the second sector of the flash 162 */ 163 164 #define LDS_BOARD_TEXT \ 165 . = DEFINED(env_offset) ? env_offset : .; \ 166 env/embedded.o(.text); 167 168 #ifdef NORFLASH_PS32BIT 169 # define CONFIG_ENV_OFFSET (0x8000) 170 # define CONFIG_ENV_SIZE 0x4000 171 # define CONFIG_ENV_SECT_SIZE 0x4000 172 #else 173 # define CONFIG_ENV_OFFSET (0x4000) 174 # define CONFIG_ENV_SIZE 0x2000 175 # define CONFIG_ENV_SECT_SIZE 0x2000 176 #endif 177 178 /*----------------------------------------------------------------------- 179 * Cache Configuration 180 */ 181 #define CONFIG_SYS_CACHELINE_SIZE 16 182 183 #define ICACHE_STATUS (CONFIG_SYS_INIT_RAM_ADDR + \ 184 CONFIG_SYS_INIT_RAM_SIZE - 8) 185 #define DCACHE_STATUS (CONFIG_SYS_INIT_RAM_ADDR + \ 186 CONFIG_SYS_INIT_RAM_SIZE - 4) 187 #define CONFIG_SYS_ICACHE_INV (CF_CACR_CINV) 188 #define CONFIG_SYS_CACHE_ACR0 (CONFIG_SYS_SDRAM_BASE | \ 189 CF_ADDRMASK(CONFIG_SYS_SDRAM_SIZE) | \ 190 CF_ACR_EN | CF_ACR_SM_ALL) 191 #define CONFIG_SYS_CACHE_ICACR (CF_CACR_CENB | CF_CACR_DISD | \ 192 CF_CACR_CEIB | CF_CACR_DCM | \ 193 CF_CACR_EUSP) 194 195 /*----------------------------------------------------------------------- 196 * Chipselect bank definitions 197 */ 198 /* 199 * CS0 - NOR Flash 1, 2, 4, or 8MB 200 * CS1 - Available 201 * CS2 - Available 202 * CS3 - Available 203 * CS4 - Available 204 * CS5 - Available 205 * CS6 - Available 206 * CS7 - Available 207 */ 208 #ifdef NORFLASH_PS32BIT 209 # define CONFIG_SYS_CS0_BASE 0xFFC00000 210 # define CONFIG_SYS_CS0_MASK 0x003f0001 211 # define CONFIG_SYS_CS0_CTRL 0x00001D00 212 #else 213 # define CONFIG_SYS_CS0_BASE 0xFFE00000 214 # define CONFIG_SYS_CS0_MASK 0x001f0001 215 # define CONFIG_SYS_CS0_CTRL 0x00001D80 216 #endif 217 218 #endif /* _M5329EVB_H */ 219