xref: /openbmc/u-boot/include/configs/M5208EVBE.h (revision baefb63a)
1 /*
2  * Configuation settings for the Freescale MCF5208EVBe.
3  *
4  * Copyright (C) 2004-2008 Freescale Semiconductor, Inc.
5  * TsiChung Liew (Tsi-Chung.Liew@freescale.com)
6  *
7  * SPDX-License-Identifier:	GPL-2.0+
8  */
9 
10 #ifndef _M5208EVBE_H
11 #define _M5208EVBE_H
12 
13 /*
14  * High Level Configuration Options
15  * (easy to change)
16  */
17 #define CONFIG_MCFUART
18 #define CONFIG_SYS_UART_PORT		(0)
19 
20 #undef CONFIG_WATCHDOG
21 #define CONFIG_WATCHDOG_TIMEOUT		5000
22 
23 #define CONFIG_MCFFEC
24 #ifdef CONFIG_MCFFEC
25 #	define CONFIG_MII		1
26 #	define CONFIG_MII_INIT		1
27 #	define CONFIG_SYS_DISCOVER_PHY
28 #	define CONFIG_SYS_RX_ETH_BUFFER	8
29 #	define CONFIG_SYS_FAULT_ECHO_LINK_DOWN
30 #	define CONFIG_HAS_ETH1
31 
32 #	define CONFIG_SYS_FEC0_PINMUX	0
33 #	define CONFIG_SYS_FEC0_MIIBASE	CONFIG_SYS_FEC0_IOBASE
34 #	define MCFFEC_TOUT_LOOP		50000
35 /* If CONFIG_SYS_DISCOVER_PHY is not defined - hardcoded */
36 #	ifndef CONFIG_SYS_DISCOVER_PHY
37 #		define FECDUPLEX	FULL
38 #		define FECSPEED		_100BASET
39 #	else
40 #		ifndef CONFIG_SYS_FAULT_ECHO_LINK_DOWN
41 #			define CONFIG_SYS_FAULT_ECHO_LINK_DOWN
42 #		endif
43 #	endif			/* CONFIG_SYS_DISCOVER_PHY */
44 #endif
45 
46 /* Timer */
47 #define CONFIG_MCFTMR
48 #undef CONFIG_MCFPIT
49 
50 /* I2C */
51 #define CONFIG_SYS_I2C
52 #define CONFIG_SYS_I2C_FSL
53 #define CONFIG_SYS_FSL_I2C_SPEED	80000
54 #define CONFIG_SYS_FSL_I2C_SLAVE	0x7F
55 #define CONFIG_SYS_FSL_I2C_OFFSET	0x58000
56 #define CONFIG_SYS_IMMR			CONFIG_SYS_MBAR
57 
58 #define CONFIG_UDP_CHECKSUM
59 
60 #ifdef CONFIG_MCFFEC
61 #	define CONFIG_IPADDR	192.162.1.2
62 #	define CONFIG_NETMASK	255.255.255.0
63 #	define CONFIG_SERVERIP	192.162.1.1
64 #	define CONFIG_GATEWAYIP	192.162.1.1
65 #endif				/* CONFIG_MCFFEC */
66 
67 #define CONFIG_HOSTNAME		M5208EVBe
68 #define CONFIG_EXTRA_ENV_SETTINGS		\
69 	"netdev=eth0\0"				\
70 	"loadaddr=40010000\0"			\
71 	"u-boot=u-boot.bin\0"			\
72 	"load=tftp ${loadaddr) ${u-boot}\0"	\
73 	"upd=run load; run prog\0"		\
74 	"prog=prot off 0 3ffff;"		\
75 	"era 0 3ffff;"				\
76 	"cp.b ${loadaddr} 0 ${filesize};"	\
77 	"save\0"				\
78 	""
79 
80 #define CONFIG_PRAM		512	/* 512 KB */
81 #define CONFIG_SYS_LONGHELP	/* undef to save memory */
82 
83 #define CONFIG_SYS_LOAD_ADDR	0x40010000
84 
85 #define CONFIG_SYS_CLK		166666666	/* CPU Core Clock */
86 #define CONFIG_SYS_PLL_ODR	0x36
87 #define CONFIG_SYS_PLL_FDR	0x7D
88 
89 #define CONFIG_SYS_MBAR		0xFC000000
90 
91 /*
92  * Low Level Configuration Settings
93  * (address mappings, register initial values, etc.)
94  * You should know what you are doing if you make changes here.
95  */
96 /* Definitions for initial stack pointer and data area (in DPRAM) */
97 #define CONFIG_SYS_INIT_RAM_ADDR	0x80000000
98 #define CONFIG_SYS_INIT_RAM_SIZE		0x4000	/* Size of used area in internal SRAM */
99 #define CONFIG_SYS_INIT_RAM_CTRL	0x221
100 #define CONFIG_SYS_GBL_DATA_OFFSET	((CONFIG_SYS_INIT_RAM_SIZE - GENERATED_GBL_DATA_SIZE) - 0x10)
101 #define CONFIG_SYS_INIT_SP_OFFSET	CONFIG_SYS_GBL_DATA_OFFSET
102 
103 /*
104  * Start addresses for the final memory configuration
105  * (Set up by the startup code)
106  * Please note that CONFIG_SYS_SDRAM_BASE _must_ start at 0
107  */
108 #define CONFIG_SYS_SDRAM_BASE		0x40000000
109 #define CONFIG_SYS_SDRAM_SIZE		32	/* SDRAM size in MB */
110 #define CONFIG_SYS_SDRAM_CFG1		0x43711630
111 #define CONFIG_SYS_SDRAM_CFG2		0x56670000
112 #define CONFIG_SYS_SDRAM_CTRL		0xE1002000
113 #define CONFIG_SYS_SDRAM_EMOD		0x80010000
114 #define CONFIG_SYS_SDRAM_MODE		0x00CD0000
115 
116 #define CONFIG_SYS_MEMTEST_START	CONFIG_SYS_SDRAM_BASE + 0x400
117 #define CONFIG_SYS_MEMTEST_END		((CONFIG_SYS_SDRAM_SIZE - 3) << 20)
118 
119 #define CONFIG_SYS_MONITOR_BASE		(CONFIG_SYS_FLASH_BASE + 0x400)
120 #define CONFIG_SYS_MONITOR_LEN		(256 << 10)	/* Reserve 256 kB for Monitor */
121 
122 #define CONFIG_SYS_BOOTPARAMS_LEN	64*1024
123 #define CONFIG_SYS_MALLOC_LEN		(128 << 10)	/* Reserve 128 kB for malloc() */
124 
125 /*
126  * For booting Linux, the board info and command line data
127  * have to be in the first 8 MB of memory, since this is
128  * the maximum mapped by the Linux kernel during initialization ??
129  */
130 #define CONFIG_SYS_BOOTMAPSZ		(CONFIG_SYS_SDRAM_BASE + (CONFIG_SYS_SDRAM_SIZE << 20))
131 #define CONFIG_SYS_BOOTM_LEN		(CONFIG_SYS_SDRAM_SIZE << 20)
132 
133 /* FLASH organization */
134 #define CONFIG_SYS_FLASH_CFI
135 #ifdef CONFIG_SYS_FLASH_CFI
136 #	define CONFIG_FLASH_CFI_DRIVER		1
137 #	define CONFIG_SYS_FLASH_SIZE		0x800000	/* Max size that the board might have */
138 #	define CONFIG_SYS_FLASH_CFI_WIDTH	FLASH_CFI_16BIT
139 #	define CONFIG_SYS_MAX_FLASH_BANKS	1	/* max number of memory banks */
140 #	define CONFIG_SYS_MAX_FLASH_SECT	254	/* max number of sectors on one chip */
141 #	define CONFIG_SYS_FLASH_PROTECTION	/* "Real" (hardware) sectors protection */
142 #endif
143 
144 #define CONFIG_SYS_FLASH_BASE		CONFIG_SYS_CS0_BASE
145 
146 /*
147  * Configuration for environment
148  * Environment is embedded in u-boot in the second sector of the flash
149  */
150 #define CONFIG_ENV_OFFSET		0x2000
151 #define CONFIG_ENV_SIZE			0x1000
152 #define CONFIG_ENV_SECT_SIZE		0x2000
153 
154 #define LDS_BOARD_TEXT \
155 	. = DEFINED(env_offset) ? env_offset : .; \
156 	env/embedded.o(.text*);
157 
158 /* Cache Configuration */
159 #define CONFIG_SYS_CACHELINE_SIZE	16
160 
161 #define ICACHE_STATUS			(CONFIG_SYS_INIT_RAM_ADDR + \
162 					 CONFIG_SYS_INIT_RAM_SIZE - 8)
163 #define DCACHE_STATUS			(CONFIG_SYS_INIT_RAM_ADDR + \
164 					 CONFIG_SYS_INIT_RAM_SIZE - 4)
165 #define CONFIG_SYS_ICACHE_INV		(CF_CACR_CINV | CF_CACR_INVI)
166 #define CONFIG_SYS_CACHE_ACR0		(CONFIG_SYS_SDRAM_BASE | \
167 					 CF_ADDRMASK(CONFIG_SYS_SDRAM_SIZE) | \
168 					 CF_ACR_EN | CF_ACR_SM_ALL)
169 #define CONFIG_SYS_CACHE_ICACR		(CF_CACR_CENB | CF_CACR_CINV | \
170 					 CF_CACR_DISD | CF_CACR_INVI | \
171 					 CF_CACR_CEIB | CF_CACR_DCM | \
172 					 CF_CACR_EUSP)
173 
174 /* Chipselect bank definitions */
175 /*
176  * CS0 - NOR Flash
177  * CS1 - Available
178  * CS2 - Available
179  * CS3 - Available
180  * CS4 - Available
181  * CS5 - Available
182  */
183 #define CONFIG_SYS_CS0_BASE		0
184 #define CONFIG_SYS_CS0_MASK		0x007F0001
185 #define CONFIG_SYS_CS0_CTRL		0x00001FA0
186 
187 #endif				/* _M5208EVBE_H */
188