1 /* SPDX-License-Identifier: GPL-2.0+ */ 2 /* 3 * (C) Copyright 2005 4 * ARM Ltd. 5 * Peter Pearse, <Peter.Pearse@arm.com> 6 * Configuration for ARM Core Modules. 7 * No standalonw port yet available 8 * - this file is included by both integratorap.h & integratorcp.h 9 */ 10 11 #ifndef __ARMCOREMODULE_H 12 #define __ARMCOREMODULE_H 13 14 #define CM_BASE 0x10000000 15 16 /* CM registers common to all CMs */ 17 /* Note that observed values after reboot into the ARM Boot Monitor 18 have been used as defaults, rather than the POR values */ 19 #define OS_CTRL 0x0000000C 20 #define CMMASK_REMAP 0x00000005 /* set remap & led */ 21 #define CMMASK_RESET 0x00000008 22 #define OS_LOCK 0x00000014 23 #define CMVAL_LOCK1 0x0000A000 /* locking value */ 24 #define CMVAL_LOCK2 0x0000005F /* locking value */ 25 #define CMVAL_UNLOCK 0x00000000 /* any value != CM_LOCKVAL */ 26 #define OS_SDRAM 0x00000020 27 #define OS_INIT 0x00000024 28 #define CMMASK_MAP_SIMPLE 0xFFFDFFFF /* simple mapping */ 29 #define CMMASK_TCRAM_DISABLE 0xFFFEFFFF /* TCRAM disabled */ 30 #define CMMASK_LOWVEC 0x00000000 /* vectors @ 0x00000000 */ 31 #define CMMASK_LE 0xFFFFFFF7 /* little endian */ 32 #define CMMASK_CMxx6_COMMON 0x00000013 /* Common value for CMxx6 */ 33 /* - observed reset value of */ 34 /* CM926EJ-S */ 35 /* CM1136-EJ-S */ 36 37 #if defined (CONFIG_CM10200E) || defined (CONFIG_CM10220E) 38 #define CMMASK_INIT_102 0x00000300 /* see CM102xx ref manual */ 39 /* - PLL test clock bypassed */ 40 /* - bus clock ratio 2 */ 41 /* - little endian */ 42 /* - vectors at zero */ 43 #endif /* CM1022xx */ 44 45 /* Determine CM characteristics */ 46 47 #undef CONFIG_CM_MULTIPLE_SSRAM 48 #undef CONFIG_CM_SPD_DETECT 49 #undef CONFIG_CM_REMAP 50 #undef CONFIG_CM_INIT 51 #undef CONFIG_CM_TCRAM 52 53 #if defined (CONFIG_CM946E_S) || defined (CONFIG_CM966E_S) 54 #define CONFIG_CM_MULTIPLE_SSRAM /* CM has multiple SSRAM mapping */ 55 #endif 56 57 /* Excalibur core module has reduced functionality */ 58 #ifndef CONFIG_CM922T_XA10 59 #define CONFIG_CM_SPD_DETECT /* CM supports SPD query */ 60 #define OS_SPD 0x00000100 /* Address of SPD data */ 61 #define CONFIG_CM_REMAP /* CM supports remapping */ 62 #define CONFIG_CM_INIT /* CM has initialization reg */ 63 #endif /* NOT EXCALIBUR */ 64 65 #if defined(CONFIG_CM926EJ_S) || defined (CONFIG_CM946E_S) || \ 66 defined(CONFIG_CM966E_S) || defined (CONFIG_CM1026EJ_S) || \ 67 defined(CONFIG_CM1136JF_S) 68 #define CONFIG_CM_TCRAM /* CM has TCRAM */ 69 #endif 70 71 #ifdef CONFIG_CM_SPD_DETECT 72 #define OS_SPD 0x00000100 /* The SDRAM SPD data is copied here */ 73 #endif 74 75 #endif /* __ARMCOREMODULE_H */ 76