xref: /openbmc/u-boot/drivers/w1/mxc_w1.c (revision 224f7452)
1 // SPDX-License-Identifier: GPL-2.0+
2 /*
3  * Driver for one wire controller in some i.MX Socs
4  *
5  * There are currently two silicon variants:
6  * V1: i.MX21, i.MX27, i.MX31, i.MX51
7  * V2: i.MX25, i.MX35, i.MX50, i.MX53
8  * Newer i.MX SoCs such as the i.MX6 do not have one wire controllers.
9  *
10  * The V1 controller only supports single bit operations.
11  * The V2 controller is backwards compatible on the register level but adds
12  * byte size operations and a "search ROM accelerator mode"
13  *
14  * This driver does not currently support the search ROM accelerator
15  *
16  * Copyright (c) 2018 Flowbird
17  * Martin Fuzzey <martin.fuzzey@flowbird.group>
18  */
19 
20 #include <asm/arch/clock.h>
21 #include <common.h>
22 #include <dm.h>
23 #include <linux/io.h>
24 #include <w1.h>
25 
26 struct mxc_w1_regs {
27 	u16 control;
28 #define MXC_W1_CONTROL_RPP	BIT(7)
29 #define MXC_W1_CONTROL_PST	BIT(6)
30 #define MXC_W1_CONTROL_WR(x)	BIT(5 - (x))
31 #define MXC_W1_CONTROL_RDST	BIT(3)
32 
33 	u16 time_divider;
34 	u16 reset;
35 
36 	/* Registers below on V2 silicon only */
37 	u16 command;
38 	u16 tx_rx;
39 	u16 interrupt;
40 #define MXC_W1_INTERRUPT_TBE	BIT(2)
41 #define MXC_W1_INTERRUPT_TSRE	BIT(3)
42 #define MXC_W1_INTERRUPT_RBF	BIT(4)
43 #define MXC_W1_INTERRUPT_RSRF	BIT(5)
44 
45 	u16 interrupt_en;
46 };
47 
48 struct mxc_w1_pdata {
49 	struct mxc_w1_regs *regs;
50 };
51 
52 /*
53  * this is the low level routine to read/write a bit on the One Wire
54  * interface on the hardware. It does write 0 if parameter bit is set
55  * to 0, otherwise a write 1/read.
56  */
57 static u8 mxc_w1_touch_bit(struct mxc_w1_pdata *pdata, u8 bit)
58 {
59 	u16 *ctrl_addr = &pdata->regs->control;
60 	u16 mask = MXC_W1_CONTROL_WR(bit);
61 	unsigned int timeout_cnt = 400; /* Takes max. 120us according to
62 					 * datasheet.
63 					 */
64 
65 	writew(mask, ctrl_addr);
66 
67 	while (timeout_cnt--) {
68 		if (!(readw(ctrl_addr) & mask))
69 			break;
70 
71 		udelay(1);
72 	}
73 
74 	return (readw(ctrl_addr) & MXC_W1_CONTROL_RDST) ? 1 : 0;
75 }
76 
77 static u8 mxc_w1_read_byte(struct udevice *dev)
78 {
79 	struct mxc_w1_pdata *pdata = dev_get_platdata(dev);
80 	struct mxc_w1_regs *regs = pdata->regs;
81 	u16 status;
82 
83 	if (dev_get_driver_data(dev) < 2) {
84 		int i;
85 		u8 ret = 0;
86 
87 		for (i = 0; i < 8; i++)
88 			ret |= (mxc_w1_touch_bit(pdata, 1) << i);
89 
90 		return ret;
91 	}
92 
93 	readw(&regs->tx_rx);
94 	writew(0xFF, &regs->tx_rx);
95 
96 	do {
97 		udelay(1); /* Without this bytes are sometimes duplicated... */
98 		status = readw(&regs->interrupt);
99 	} while (!(status & MXC_W1_INTERRUPT_RBF));
100 
101 	return (u8)readw(&regs->tx_rx);
102 }
103 
104 static void mxc_w1_write_byte(struct udevice *dev, u8 byte)
105 {
106 	struct mxc_w1_pdata *pdata = dev_get_platdata(dev);
107 	struct mxc_w1_regs *regs = pdata->regs;
108 	u16 status;
109 
110 	if (dev_get_driver_data(dev) < 2) {
111 		int i;
112 
113 		for (i = 0; i < 8; i++)
114 			mxc_w1_touch_bit(pdata, (byte >> i) & 0x1);
115 
116 		return;
117 	}
118 
119 	readw(&regs->tx_rx);
120 	writew(byte, &regs->tx_rx);
121 
122 	do {
123 		udelay(1);
124 		status = readw(&regs->interrupt);
125 	} while (!(status & MXC_W1_INTERRUPT_TSRE));
126 }
127 
128 static bool mxc_w1_reset(struct udevice *dev)
129 {
130 	struct mxc_w1_pdata *pdata = dev_get_platdata(dev);
131 	u16 reg_val;
132 
133 	writew(MXC_W1_CONTROL_RPP, &pdata->regs->control);
134 
135 	do {
136 		reg_val = readw(&pdata->regs->control);
137 	}  while (reg_val & MXC_W1_CONTROL_RPP);
138 
139 	return !(reg_val & MXC_W1_CONTROL_PST);
140 }
141 
142 static u8 mxc_w1_triplet(struct udevice *dev, bool bdir)
143 {
144 	struct mxc_w1_pdata *pdata = dev_get_platdata(dev);
145 	u8 id_bit   = mxc_w1_touch_bit(pdata, 1);
146 	u8 comp_bit = mxc_w1_touch_bit(pdata, 1);
147 	u8 retval;
148 
149 	if (id_bit && comp_bit)
150 		return 0x03;  /* error */
151 
152 	if (!id_bit && !comp_bit) {
153 		/* Both bits are valid, take the direction given */
154 		retval = bdir ? 0x04 : 0;
155 	} else {
156 		/* Only one bit is valid, take that direction */
157 		bdir = id_bit;
158 		retval = id_bit ? 0x05 : 0x02;
159 	}
160 
161 	mxc_w1_touch_bit(pdata, bdir);
162 
163 	return retval;
164 }
165 
166 static int mxc_w1_ofdata_to_platdata(struct udevice *dev)
167 {
168 	struct mxc_w1_pdata *pdata = dev_get_platdata(dev);
169 	fdt_addr_t addr;
170 
171 	addr = devfdt_get_addr(dev);
172 	if (addr == FDT_ADDR_T_NONE)
173 		return -EINVAL;
174 
175 	pdata->regs = (struct mxc_w1_regs *)addr;
176 
177 	return 0;
178 };
179 
180 static int mxc_w1_probe(struct udevice *dev)
181 {
182 	struct mxc_w1_pdata *pdata = dev_get_platdata(dev);
183 	unsigned int clkrate = mxc_get_clock(MXC_IPG_PERCLK);
184 	unsigned int clkdiv;
185 
186 	if (clkrate < 10000000) {
187 		dev_err(dev, "input clock frequency (%u Hz) too low\n",
188 			clkrate);
189 		return -EINVAL;
190 	}
191 
192 	clkdiv = clkrate / 1000000;
193 	clkrate /= clkdiv;
194 	if (clkrate < 980000 || clkrate > 1020000) {
195 		dev_err(dev, "Incorrect time base frequency %u Hz\n", clkrate);
196 		return -EINVAL;
197 	}
198 
199 	writew(clkdiv - 1, &pdata->regs->time_divider);
200 
201 	return 0;
202 }
203 
204 static const struct w1_ops mxc_w1_ops = {
205 	.read_byte	= mxc_w1_read_byte,
206 	.reset		= mxc_w1_reset,
207 	.triplet	= mxc_w1_triplet,
208 	.write_byte	= mxc_w1_write_byte,
209 };
210 
211 static const struct udevice_id mxc_w1_id[] = {
212 	{ .compatible = "fsl,imx21-owire", .data = 1 },
213 	{ .compatible = "fsl,imx27-owire", .data = 1 },
214 	{ .compatible = "fsl,imx31-owire", .data = 1 },
215 	{ .compatible = "fsl,imx51-owire", .data = 1 },
216 
217 	{ .compatible = "fsl,imx25-owire", .data = 2 },
218 	{ .compatible = "fsl,imx35-owire", .data = 2 },
219 	{ .compatible = "fsl,imx50-owire", .data = 2 },
220 	{ .compatible = "fsl,imx53-owire", .data = 2 },
221 	{ },
222 };
223 
224 U_BOOT_DRIVER(mxc_w1_drv) = {
225 	.id				= UCLASS_W1,
226 	.name				= "mxc_w1_drv",
227 	.of_match			= mxc_w1_id,
228 	.ofdata_to_platdata		= mxc_w1_ofdata_to_platdata,
229 	.ops				= &mxc_w1_ops,
230 	.platdata_auto_alloc_size	= sizeof(struct mxc_w1_pdata),
231 	.probe				= mxc_w1_probe,
232 };
233