xref: /openbmc/u-boot/drivers/usb/gadget/at91_udc.h (revision 699c4e59)
1 /*
2  * Copyright (C) 2004 by Thomas Rathbone, HP Labs
3  * Copyright (C) 2005 by Ivan Kokshaysky
4  * Copyright (C) 2006 by SAN People
5  *
6  * SPDX-License-Identifier:	GPL-2.0+
7  */
8 
9 #ifndef AT91_UDC_H
10 #define AT91_UDC_H
11 
12 /*
13  * USB Device Port (UDP) registers.
14  * Based on AT91RM9200 datasheet revision E.
15  */
16 
17 #define AT91_UDP_FRM_NUM	0x00		/* Frame Number Register */
18 #define     AT91_UDP_NUM	(0x7ff <<  0)	/* Frame Number */
19 #define     AT91_UDP_FRM_ERR	(1     << 16)	/* Frame Error */
20 #define     AT91_UDP_FRM_OK	(1     << 17)	/* Frame OK */
21 
22 #define AT91_UDP_GLB_STAT	0x04		/* Global State Register */
23 #define     AT91_UDP_FADDEN	(1 <<  0)	/* Function Address Enable */
24 #define     AT91_UDP_CONFG	(1 <<  1)	/* Configured */
25 #define     AT91_UDP_ESR	(1 <<  2)	/* Enable Send Resume */
26 #define     AT91_UDP_RSMINPR	(1 <<  3)	/* Resume has been sent */
27 #define     AT91_UDP_RMWUPE	(1 <<  4)	/* Remote Wake Up Enable */
28 
29 #define AT91_UDP_FADDR		0x08		/* Function Address Register */
30 #define     AT91_UDP_FADD	(0x7f << 0)	/* Function Address Value */
31 #define     AT91_UDP_FEN	(1    << 8)	/* Function Enable */
32 
33 #define AT91_UDP_IER		0x10		/* Interrupt Enable Register */
34 #define AT91_UDP_IDR		0x14		/* Interrupt Disable Register */
35 #define AT91_UDP_IMR		0x18		/* Interrupt Mask Register */
36 
37 #define AT91_UDP_ISR		0x1c		/* Interrupt Status Register */
38 #define     AT91_UDP_EP(n)	(1 << (n))	/* Endpoint Interrupt Status */
39 #define     AT91_UDP_RXSUSP	(1 <<  8) 	/* USB Suspend Interrupt Status */
40 #define     AT91_UDP_RXRSM	(1 <<  9)	/* USB Resume Interrupt Status */
41 #define     AT91_UDP_EXTRSM	(1 << 10)	/* External Resume Interrupt Status [AT91RM9200 only] */
42 #define     AT91_UDP_SOFINT	(1 << 11)	/* Start of Frame Interrupt Status */
43 #define     AT91_UDP_ENDBUSRES	(1 << 12)	/* End of Bus Reset Interrupt Status */
44 #define     AT91_UDP_WAKEUP	(1 << 13)	/* USB Wakeup Interrupt Status [AT91RM9200 only] */
45 
46 #define AT91_UDP_ICR		0x20		/* Interrupt Clear Register */
47 #define AT91_UDP_RST_EP		0x28		/* Reset Endpoint Register */
48 
49 #define AT91_UDP_CSR(n)		(0x30+((n)*4))	/* Endpoint Control/Status Registers 0-7 */
50 #define     AT91_UDP_TXCOMP	(1 <<  0)	/* Generates IN packet with data previously written in DPR */
51 #define     AT91_UDP_RX_DATA_BK0 (1 <<  1)	/* Receive Data Bank 0 */
52 #define     AT91_UDP_RXSETUP	(1 <<  2)	/* Send STALL to the host */
53 #define     AT91_UDP_STALLSENT	(1 <<  3)	/* Stall Sent / Isochronous error (Isochronous endpoints) */
54 #define     AT91_UDP_TXPKTRDY	(1 <<  4)	/* Transmit Packet Ready */
55 #define     AT91_UDP_FORCESTALL	(1 <<  5)	/* Force Stall */
56 #define     AT91_UDP_RX_DATA_BK1 (1 <<  6)	/* Receive Data Bank 1 */
57 #define     AT91_UDP_DIR	(1 <<  7)	/* Transfer Direction */
58 #define     AT91_UDP_EPTYPE	(7 <<  8)	/* Endpoint Type */
59 #define		AT91_UDP_EPTYPE_CTRL		(0 <<  8)
60 #define		AT91_UDP_EPTYPE_ISO_OUT		(1 <<  8)
61 #define		AT91_UDP_EPTYPE_BULK_OUT	(2 <<  8)
62 #define		AT91_UDP_EPTYPE_INT_OUT		(3 <<  8)
63 #define		AT91_UDP_EPTYPE_ISO_IN		(5 <<  8)
64 #define		AT91_UDP_EPTYPE_BULK_IN		(6 <<  8)
65 #define		AT91_UDP_EPTYPE_INT_IN		(7 <<  8)
66 #define     AT91_UDP_DTGLE	(1 << 11)	/* Data Toggle */
67 #define     AT91_UDP_EPEDS	(1 << 15)	/* Endpoint Enable/Disable */
68 #define     AT91_UDP_RXBYTECNT	(0x7ff << 16)	/* Number of bytes in FIFO */
69 
70 #define AT91_UDP_FDR(n)		(0x50+((n)*4))	/* Endpoint FIFO Data Registers 0-7 */
71 
72 #define AT91_UDP_TXVC		0x74		/* Transceiver Control Register */
73 #define     AT91_UDP_TXVC_TXVDIS (1 << 8)	/* Transceiver Disable */
74 #define     AT91_UDP_TXVC_PUON   (1 << 9)	/* PullUp On [AT91SAM9260 only] */
75 
76 /*-------------------------------------------------------------------------*/
77 
78 /*
79  * controller driver data structures
80  */
81 
82 #define	NUM_ENDPOINTS	6
83 
84 /*
85  * hardware won't disable bus reset, or resume while the controller
86  * is suspended ... watching suspend helps keep the logic symmetric.
87  */
88 #define	MINIMUS_INTERRUPTUS \
89 	(AT91_UDP_ENDBUSRES | AT91_UDP_RXRSM | AT91_UDP_RXSUSP)
90 
91 struct at91_ep {
92 	struct usb_ep			ep;
93 	struct list_head		queue;
94 	struct at91_udc			*udc;
95 	void __iomem			*creg;
96 
97 	unsigned			maxpacket:16;
98 	u8				int_mask;
99 	unsigned			is_pingpong:1;
100 
101 	unsigned			stopped:1;
102 	unsigned			is_in:1;
103 	unsigned			is_iso:1;
104 	unsigned			fifo_bank:1;
105 };
106 
107 struct at91_udc_caps {
108 	int (*init)(struct at91_udc *udc);
109 	void (*pullup)(struct at91_udc *udc, int is_on);
110 };
111 
112 /*
113  * driver is non-SMP, and just blocks IRQs whenever it needs
114  * access protection for chip registers or driver state
115  */
116 struct at91_udc {
117 	struct usb_gadget		gadget;
118 	struct at91_ep			ep[NUM_ENDPOINTS];
119 	struct usb_gadget_driver	*driver;
120 	const struct at91_udc_caps	*caps;
121 	unsigned			vbus:1;
122 	unsigned			enabled:1;
123 	unsigned			clocked:1;
124 	unsigned			suspended:1;
125 	unsigned			req_pending:1;
126 	unsigned			wait_for_addr_ack:1;
127 	unsigned			wait_for_config_ack:1;
128 	unsigned			selfpowered:1;
129 	unsigned			active_suspend:1;
130 	u8				addr;
131 	struct at91_udc_data		board;
132 	void __iomem			*udp_baseaddr;
133 	int				udp_irq;
134 	spinlock_t			lock;
135 	struct at91_matrix		*matrix;
136 };
137 
138 static inline struct at91_udc *to_udc(struct usb_gadget *g)
139 {
140 	return container_of(g, struct at91_udc, gadget);
141 }
142 
143 struct at91_request {
144 	struct usb_request		req;
145 	struct list_head		queue;
146 };
147 
148 /*-------------------------------------------------------------------------*/
149 
150 #ifdef VERBOSE_DEBUG
151 #    define VDBG		DBG
152 #else
153 #    define VDBG(stuff...)	do{}while(0)
154 #endif
155 
156 #ifdef PACKET_TRACE
157 #    define PACKET		VDBG
158 #else
159 #    define PACKET(stuff...)	do{}while(0)
160 #endif
161 
162 #define ERR(stuff...)		debug("udc: " stuff)
163 #define WARNING(stuff...)	debug("udc: " stuff)
164 #define INFO(stuff...)		debug("udc: " stuff)
165 #define DBG(stuff...)		debug("udc: " stuff)
166 
167 #endif
168 
169