1 2config BITBANGMII 3 bool "Bit-banged ethernet MII management channel support" 4 5config MV88E6352_SWITCH 6 bool "Marvell 88E6352 switch support" 7 8menuconfig PHYLIB 9 bool "Ethernet PHY (physical media interface) support" 10 help 11 Enable Ethernet PHY (physical media interface) support. 12 13if PHYLIB 14 15config MV88E61XX_SWITCH 16 bool "Marvel MV88E61xx Ethernet switch PHY support." 17 18config PHYLIB_10G 19 bool "Generic 10G PHY support" 20 21config PHY_AQUANTIA 22 bool "Aquantia Ethernet PHYs support" 23 24config PHY_ATHEROS 25 bool "Atheros Ethernet PHYs support" 26 27config PHY_BROADCOM 28 bool "Broadcom Ethernet PHYs support" 29 30config PHY_CORTINA 31 bool "Cortina Ethernet PHYs support" 32 33config PHY_DAVICOM 34 bool "Davicom Ethernet PHYs support" 35 36config PHY_ET1011C 37 bool "LSI TruePHY ET1011C support" 38 39config PHY_LXT 40 bool "LXT971 Ethernet PHY support" 41 42config PHY_MARVELL 43 bool "Marvell Ethernet PHYs support" 44 45config PHY_MICREL 46 bool "Micrel Ethernet PHYs support" 47 48config PHY_MSCC 49 bool "Microsemi Corp Ethernet PHYs support" 50 51config PHY_NATSEMI 52 bool "National Semiconductor Ethernet PHYs support" 53 54config PHY_REALTEK 55 bool "Realtek Ethernet PHYs support" 56 57config RTL8211X_PHY_FORCE_MASTER 58 bool "Ethernet PHY RTL8211x: force 1000BASE-T master mode" 59 depends on PHY_REALTEK 60 help 61 Force master mode for 1000BASE-T on RTl8211x PHYs (except for RTL8211F). 62 This can work around link stability and data corruption issues on gigabit 63 links which can occur in slave mode on certain PHYs, e.g. on the 64 RTL8211C(L). 65 66 Please note that two directly connected devices (i.e. via crossover cable) 67 will not be able to establish a link between each other if they both force 68 master mode. Multiple devices forcing master mode when connected by a 69 network switch do not pose a problem as the switch configures its affected 70 ports into slave mode. 71 72 This option only affects gigabit links. If you must establish a direct 73 connection between two devices which both force master mode, try forcing 74 the link speed to 100MBit/s. 75 76 If unsure, say N. 77 78config PHY_SMSC 79 bool "Microchip(SMSC) Ethernet PHYs support" 80 81config PHY_TERANETICS 82 bool "Teranetics Ethernet PHYs support" 83 84config PHY_TI 85 bool "Texas Instruments Ethernet PHYs support" 86 87config PHY_VITESSE 88 bool "Vitesse Ethernet PHYs support" 89 90config PHY_XILINX 91 bool "Xilinx Ethernet PHYs support" 92 93endif #PHYLIB 94