1 /* 2 * (C) Copyright 2004-2014 3 * Texas Instruments, <www.ti.com> 4 * 5 * Some changes copyright (C) 2007 Sergey Kubushyn <ksi@koi8.net> 6 * 7 * SPDX-License-Identifier: GPL-2.0+ 8 */ 9 #ifndef _DAVINCI_I2C_H_ 10 #define _DAVINCI_I2C_H_ 11 12 #define I2C_WRITE 0 13 #define I2C_READ 1 14 15 struct i2c_regs { 16 u32 i2c_oa; 17 u32 i2c_ie; 18 u32 i2c_stat; 19 u32 i2c_scll; 20 u32 i2c_sclh; 21 u32 i2c_cnt; 22 u32 i2c_drr; 23 u32 i2c_sa; 24 u32 i2c_dxr; 25 u32 i2c_con; 26 u32 i2c_iv; 27 u32 res_2c; 28 u32 i2c_psc; 29 }; 30 31 /* I2C masks */ 32 33 /* I2C Interrupt Enable Register (I2C_IE): */ 34 #define I2C_IE_SCD_IE (1 << 5) /* Stop condition detect interrupt enable */ 35 #define I2C_IE_XRDY_IE (1 << 4) /* Transmit data ready interrupt enable */ 36 #define I2C_IE_RRDY_IE (1 << 3) /* Receive data ready interrupt enable */ 37 #define I2C_IE_ARDY_IE (1 << 2) /* Register access ready interrupt enable */ 38 #define I2C_IE_NACK_IE (1 << 1) /* No acknowledgment interrupt enable */ 39 #define I2C_IE_AL_IE (1 << 0) /* Arbitration lost interrupt enable */ 40 41 /* I2C Status Register (I2C_STAT): */ 42 43 #define I2C_STAT_BB (1 << 12) /* Bus busy */ 44 #define I2C_STAT_ROVR (1 << 11) /* Receive overrun */ 45 #define I2C_STAT_XUDF (1 << 10) /* Transmit underflow */ 46 #define I2C_STAT_AAS (1 << 9) /* Address as slave */ 47 #define I2C_STAT_SCD (1 << 5) /* Stop condition detect */ 48 #define I2C_STAT_XRDY (1 << 4) /* Transmit data ready */ 49 #define I2C_STAT_RRDY (1 << 3) /* Receive data ready */ 50 #define I2C_STAT_ARDY (1 << 2) /* Register access ready */ 51 #define I2C_STAT_NACK (1 << 1) /* No acknowledgment interrupt enable */ 52 #define I2C_STAT_AL (1 << 0) /* Arbitration lost interrupt enable */ 53 54 /* I2C Interrupt Code Register (I2C_INTCODE): */ 55 56 #define I2C_INTCODE_MASK 7 57 #define I2C_INTCODE_NONE 0 58 #define I2C_INTCODE_AL 1 /* Arbitration lost */ 59 #define I2C_INTCODE_NAK 2 /* No acknowledgement/general call */ 60 #define I2C_INTCODE_ARDY 3 /* Register access ready */ 61 #define I2C_INTCODE_RRDY 4 /* Rcv data ready */ 62 #define I2C_INTCODE_XRDY 5 /* Xmit data ready */ 63 #define I2C_INTCODE_SCD 6 /* Stop condition detect */ 64 65 /* I2C Configuration Register (I2C_CON): */ 66 67 #define I2C_CON_EN (1 << 5) /* I2C module enable */ 68 #define I2C_CON_STB (1 << 4) /* Start byte mode (master mode only) */ 69 #define I2C_CON_MST (1 << 10) /* Master/slave mode */ 70 #define I2C_CON_TRX (1 << 9) /* Tx/Rx mode (master mode only) */ 71 #define I2C_CON_XA (1 << 8) /* Expand address */ 72 #define I2C_CON_STP (1 << 11) /* Stop condition (master mode only) */ 73 #define I2C_CON_STT (1 << 13) /* Start condition (master mode only) */ 74 #define I2C_CON_FREE (1 << 14) /* Free run on emulation */ 75 76 #define I2C_TIMEOUT 0xffff0000 /* Timeout mask for poll_i2c_irq() */ 77 78 #endif 79