1 // SPDX-License-Identifier: GPL-2.0
2 /*
3  * Copyright (C) Marvell International Ltd. and its affiliates
4  */
5 
6 #include "ddr3_init.h"
7 #include "mv_ddr_common.h"
8 
9 /*
10  * Translates topology map definitions to real memory size in bits
11   * (per values in ddr3_training_ip_def.h)
12  */
13 u32 mem_size[] = {
14 	ADDR_SIZE_512MB,
15 	ADDR_SIZE_1GB,
16 	ADDR_SIZE_2GB,
17 	ADDR_SIZE_4GB,
18 	ADDR_SIZE_8GB
19 };
20 
21 static char *ddr_type = "DDR3";
22 
23 /*
24  * generic_init_controller controls D-unit configuration:
25  * '1' - dynamic D-unit configuration,
26  */
27 u8 generic_init_controller = 1;
28 
29 static int mv_ddr_training_params_set(u8 dev_num);
30 
31 /*
32  * Name:     ddr3_init - Main DDR3 Init function
33  * Desc:     This routine initialize the DDR3 MC and runs HW training.
34  * Args:     None.
35  * Notes:
36  * Returns:  None.
37  */
38 int ddr3_init(void)
39 {
40 	struct mv_ddr_topology_map *tm = mv_ddr_topology_map_get();
41 	u32 octets_per_if_num;
42 	int status;
43 	int is_manual_cal_done;
44 
45 	/* Print mv_ddr version */
46 	mv_ddr_ver_print();
47 
48 	mv_ddr_pre_training_fixup();
49 
50 	/* SoC/Board special initializations */
51 	mv_ddr_pre_training_soc_config(ddr_type);
52 
53 	/* Set log level for training library */
54 	mv_ddr_user_log_level_set(DEBUG_BLOCK_ALL);
55 
56 	mv_ddr_early_init();
57 
58 	if (mv_ddr_topology_map_update() == NULL) {
59 		printf("mv_ddr: failed to update topology\n");
60 		return MV_FAIL;
61 	}
62 
63 	if (mv_ddr_early_init2() != MV_OK)
64 		return MV_FAIL;
65 
66 	/* Set training algorithm's parameters */
67 	status = mv_ddr_training_params_set(0);
68 	if (MV_OK != status)
69 		return status;
70 
71 
72 	mv_ddr_mc_config();
73 
74 	is_manual_cal_done = mv_ddr_manual_cal_do();
75 
76 	mv_ddr_mc_init();
77 
78 	if (!is_manual_cal_done) {
79 	}
80 
81 
82 	status = ddr3_silicon_post_init();
83 	if (MV_OK != status) {
84 		printf("DDR3 Post Init - FAILED 0x%x\n", status);
85 		return status;
86 	}
87 
88 	/* PHY initialization (Training) */
89 	status = hws_ddr3_tip_run_alg(0, ALGO_TYPE_DYNAMIC);
90 	if (MV_OK != status) {
91 		printf("%s Training Sequence - FAILED\n", ddr_type);
92 		return status;
93 	}
94 
95 #if defined(CONFIG_PHY_STATIC_PRINT)
96 	mv_ddr_phy_static_print();
97 #endif
98 
99 	/* Post MC/PHY initializations */
100 	mv_ddr_post_training_soc_config(ddr_type);
101 
102 	mv_ddr_post_training_fixup();
103 
104 	octets_per_if_num = ddr3_tip_dev_attr_get(0, MV_ATTR_OCTET_PER_INTERFACE);
105 	if (ddr3_if_ecc_enabled()) {
106 		if (MV_DDR_IS_64BIT_DRAM_MODE(tm->bus_act_mask) ||
107 		    MV_DDR_IS_32BIT_IN_64BIT_DRAM_MODE(tm->bus_act_mask, octets_per_if_num))
108 			mv_ddr_mem_scrubbing();
109 		else
110 			ddr3_new_tip_ecc_scrub();
111 	}
112 
113 	printf("mv_ddr: completed successfully\n");
114 
115 	return MV_OK;
116 }
117 
118 uint64_t mv_ddr_get_memory_size_per_cs_in_bits(void)
119 {
120 	uint64_t memory_size_per_cs;
121 
122 	u32 bus_cnt, num_of_active_bus = 0;
123 	u32 num_of_sub_phys_per_ddr_unit = 0;
124 
125 	struct mv_ddr_topology_map *tm = mv_ddr_topology_map_get();
126 
127 	u32 octets_per_if_num = ddr3_tip_dev_attr_get(DEV_NUM_0, MV_ATTR_OCTET_PER_INTERFACE);
128 
129 	/* count the number of active bus */
130 	for (bus_cnt = 0; bus_cnt < octets_per_if_num - 1/* ignore ecc octet */; bus_cnt++) {
131 		VALIDATE_BUS_ACTIVE(tm->bus_act_mask, bus_cnt);
132 		num_of_active_bus++;
133 	}
134 
135 	/* calculate number of sub-phys per ddr unit */
136 	if (tm->interface_params[0].bus_width/* supports only single interface */ == MV_DDR_DEV_WIDTH_16BIT)
137 		num_of_sub_phys_per_ddr_unit = TWO_SUB_PHYS;
138 	if (tm->interface_params[0].bus_width/* supports only single interface */ == MV_DDR_DEV_WIDTH_8BIT)
139 		num_of_sub_phys_per_ddr_unit = SINGLE_SUB_PHY;
140 
141 	/* calculate dram size per cs */
142 	memory_size_per_cs = (uint64_t)mem_size[tm->interface_params[0].memory_size] * (uint64_t)num_of_active_bus
143 		/ (uint64_t)num_of_sub_phys_per_ddr_unit * (uint64_t)MV_DDR_NUM_BITS_IN_BYTE;
144 
145 	return memory_size_per_cs;
146 }
147 
148 uint64_t mv_ddr_get_total_memory_size_in_bits(void)
149 {
150 	uint64_t total_memory_size = 0;
151 	uint64_t memory_size_per_cs = 0;
152 
153 	/* get the number of cs */
154 	u32 max_cs = ddr3_tip_max_cs_get(DEV_NUM_0);
155 
156 	memory_size_per_cs = mv_ddr_get_memory_size_per_cs_in_bits();
157 	total_memory_size = (uint64_t)max_cs * memory_size_per_cs;
158 
159 	return total_memory_size;
160 }
161 
162 int ddr3_if_ecc_enabled(void)
163 {
164 	struct mv_ddr_topology_map *tm = mv_ddr_topology_map_get();
165 
166 	if (DDR3_IS_ECC_PUP4_MODE(tm->bus_act_mask) ||
167 	    DDR3_IS_ECC_PUP3_MODE(tm->bus_act_mask) ||
168 	    DDR3_IS_ECC_PUP8_MODE(tm->bus_act_mask))
169 		return 1;
170 	else
171 		return 0;
172 }
173 
174 /*
175  * Name:	mv_ddr_training_params_set
176  * Desc:
177  * Args:
178  * Notes:	sets internal training params
179  * Returns:
180  */
181 static int mv_ddr_training_params_set(u8 dev_num)
182 {
183 	struct tune_train_params params;
184 	int status;
185 	struct mv_ddr_topology_map *tm = mv_ddr_topology_map_get();
186 	u32 if_id;
187 	u32 cs_num;
188 
189 	CHECK_STATUS(ddr3_tip_get_first_active_if
190 		     (dev_num, tm->if_act_mask,
191 		      &if_id));
192 
193 	CHECK_STATUS(calc_cs_num(dev_num, if_id, &cs_num));
194 
195 	/* NOTE: do not remove any field initilization */
196 	params.ck_delay = TUNE_TRAINING_PARAMS_CK_DELAY;
197 	params.phy_reg3_val = TUNE_TRAINING_PARAMS_PHYREG3VAL;
198 	params.g_zpri_data = TUNE_TRAINING_PARAMS_PRI_DATA;
199 	params.g_znri_data = TUNE_TRAINING_PARAMS_NRI_DATA;
200 	params.g_zpri_ctrl = TUNE_TRAINING_PARAMS_PRI_CTRL;
201 	params.g_znri_ctrl = TUNE_TRAINING_PARAMS_NRI_CTRL;
202 	params.g_znodt_data = TUNE_TRAINING_PARAMS_N_ODT_DATA;
203 	params.g_zpodt_ctrl = TUNE_TRAINING_PARAMS_P_ODT_CTRL;
204 	params.g_znodt_ctrl = TUNE_TRAINING_PARAMS_N_ODT_CTRL;
205 
206 	params.g_zpodt_data = TUNE_TRAINING_PARAMS_P_ODT_DATA;
207 	params.g_dic = TUNE_TRAINING_PARAMS_DIC;
208 	params.g_rtt_nom = TUNE_TRAINING_PARAMS_RTT_NOM;
209 	if (cs_num == 1) {
210 		params.g_rtt_wr = TUNE_TRAINING_PARAMS_RTT_WR_1CS;
211 		params.g_odt_config = TUNE_TRAINING_PARAMS_ODT_CONFIG_1CS;
212 	} else {
213 		params.g_rtt_wr = TUNE_TRAINING_PARAMS_RTT_WR_2CS;
214 		params.g_odt_config = TUNE_TRAINING_PARAMS_ODT_CONFIG_2CS;
215 	}
216 
217 	status = ddr3_tip_tune_training_params(dev_num, &params);
218 	if (MV_OK != status) {
219 		printf("%s Training Sequence - FAILED\n", ddr_type);
220 		return status;
221 	}
222 
223 	return MV_OK;
224 }
225