1Exynos Display Controller
2=========================
3Required properties:
4SOC specific:
5	compatible: should be "samsung,exynos-fimd"
6	reg: Base address of FIMD IP.
7
8Board(panel specific):
9	samsung,vl-col: X resolution of the panel
10	samsung,vl-row: Y resolution of the panel
11	samsung,vl-freq: Refresh rate
12	samsung,vl-bpix: Bits per pixel
13	samsung,vl-hspw: Hsync value
14	samsung,vl-hfpd: Right margin
15	samsung,vl-hbpd: Left margin
16	samsung,vl-vspw: Vsync value
17	samsung,vl-vfpd: Lower margin
18	samsung,vl-vbpd: Upper margin
19
20Optional properties:
21Board(panel specific):
22	samsung,vl-width: width of display area in mm
23	samsung,vl-height: Height of display area in mm
24
25	samsung,vl-clkp: Clock polarity
26		CONFIG_SYS_LOW if defined, else CONFIG_SYS_HIGH
27	samsung,vl-oep: Output Enable polarity
28		CONFIG_SYS_LOW if defined, else CONFIG_SYS_HIGH
29	samsung,vl-hsp: Horizontal Sync polarity
30		CONFIG_SYS_LOW if defined, else CONFIG_SYS_HIGH
31	samsung,vl-vsp: Vertical Sync polarity
32		CONFIG_SYS_LOW if defined, else CONFIG_SYS_HIGH
33	samsung,vl-dp: Data polarity
34		CONFIG_SYS_LOW if defined, else CONFIG_SYS_HIGH
35
36	samsung,vl-cmd-allow-len: Wait end of frame
37	samsung,winid: Window number on which data is to be displayed
38	samsung,init-delay: Delay before LCD initialization starts
39	samsung,power-on-delay: Delay after LCD is powered on
40	samsung,reset-delay: Delay after LCD is reset
41	samsung,interface-mode: 1(FIMD_RGB_INTERFACE), 2(FIMD_CPU_INTERFACE)
42	samsung,mipi-enabled: 1 if you want to use MIPI, else 0
43	samsung,dp-enabled: 1is you want to use DP, else 0
44	samsung,cs-setup: cs_setup value in FIMD_CPU_INTERFACE mode.
45	samsung,wr-setup: wr_setup value in FIMD_CPU_INTERFACE mode.
46	samsung,wr-act: wr_act value in FIMD_CPU_INTERFACE mode.
47	samsung,wr-hold: wr_hold value in FIMD_CPU_INTERFACE mode.
48	samsung,logo-on: 1 if you want to use custom logo.
49			 0 if you want LCD console.
50	samsung,logo-width: pixel width of logo image. Valid if logo_on = 1
51	samsung,logo-height: pixel height of logo image. Valid if logo_on = 1
52	samsung,logo-addr: Address of logo image. Valid if logo_on = 1
53	samsung,rgb-mode: 0(MODE_RGB_P), 1(MODE_BGR_P),
54			  2(MODE_RGB_S), 3(MODE_BGR_S)
55	samsung,pclk-name: parent clock identifier: 1(MPLL), 2(EPLL), 3(VPLL)
56	samsung,sclk-div: parent_clock/source_clock ratio
57	samsung,dual-lcd-enabled: 1 if you support two LCD, else 0
58
59Example:
60SOC specific part:
61	fimd@14400000 {
62		compatible = "samsung,exynos-fimd";
63		reg = <0x14400000 0x10000>;
64		#address-cells = <1>;
65		#size-cells = <1>;
66	};
67
68Board specific part:
69	fimd@14400000 {
70		samsung,vl-freq = <60>;
71		samsung,vl-col = <2560>;
72		samsung,vl-row = <1600>;
73		samsung,vl-width = <2560>;
74		samsung,vl-height = <1600>;
75
76		samsung,vl-clkp;
77		samsung,vl-dp;
78		samsung,vl-bpix = <4>;
79
80		samsung,vl-hspw = <32>;
81		samsung,vl-hbpd = <80>;
82		samsung,vl-hfpd = <48>;
83		samsung,vl-vspw = <6>;
84		samsung,vl-vbpd = <37>;
85		samsung,vl-vfpd = <3>;
86		samsung,vl-cmd-allow-len = <0xf>;
87
88		samsung,winid = <3>;
89		samsung,interface-mode = <1>;
90		samsung,dp-enabled = <1>;
91		samsung,dual-lcd-enabled = <0>;
92	};
93