1Intel Interrupt Router Device Binding 2===================================== 3 4The device tree node which describes the operation of the Intel Interrupt Router 5device is as follows: 6 7Required properties : 8- reg : Specifies the interrupt router's PCI configuration space address as 9 defined by the Open Firmware spec. 10- compatible = "intel,irq-router" 11- intel,pirq-config : Specifies the IRQ routing register programming mechanism. 12 Valid values are: 13 "pci": IRQ routing is controlled by PCI configuration registers 14 "ibase": IRQ routing is in the memory-mapped IBASE register block 15- intel,ibase-offset : IBASE register offset in the interrupt router's PCI 16 configuration space, required only if intel,pirq-config = "ibase". 17- intel,pirq-link : Specifies the PIRQ link information with two cells. The 18 first cell is the register offset that controls the first PIRQ link routing. 19 The second cell is the total number of PIRQ links the router supports. 20- intel,pirq-mask : Specifies the IRQ mask reprenting the 16 IRQs in 8259 PIC. 21 Bit N is 1 means IRQ N is available to be routed. 22- intel,pirq-routing : Specifies all PCI devices' IRQ routing information, 23 encoded as 3 cells a group for a device. The first cell is the device's PCI 24 bus number, device number and function number encoding with PCI_BDF() macro. 25 The second cell is the PCI interrupt pin used by this device. The last cell 26 is which PIRQ line the PCI interrupt pin is routed to. 27 28 29Example 30------- 31 32#include <dt-bindings/interrupt-router/intel-irq.h> 33 34 irq-router@1f,0 { 35 reg = <0x0000f800 0 0 0 0>; 36 compatible = "intel,irq-router"; 37 intel,pirq-config = "pci"; 38 intel,pirq-link = <0x60 8>; 39 intel,pirq-mask = <0xdef8>; 40 intel,pirq-routing = < 41 PCI_BDF(0, 2, 0) INTA PIRQA 42 PCI_BDF(0, 3, 0) INTA PIRQB 43 PCI_BDF(0, 8, 0) INTA PIRQC 44 PCI_BDF(0, 8, 1) INTB PIRQD 45 PCI_BDF(1, 6, 0) INTA PIRQE 46 PCI_BDF(1, 6, 1) INTB PIRQF 47 PCI_BDF(1, 6, 2) INTC PIRQG 48 PCI_BDF(1, 6, 3) INTD PIRQH 49 >; 50 }; 51