1U-Boot config options used in fec_mxc.c 2 3CONFIG_FEC_MXC 4 Selects fec_mxc.c to be compiled into u-boot. Can read out the 5 ethaddr from the SoC eFuses (see below). 6 7CONFIG_MII 8 Must be defined if CONFIG_FEC_MXC is defined. 9 10CONFIG_FEC_XCV_TYPE 11 Defaults to MII100 for 100 Base-tx. 12 RGMII selects 1000 Base-tx reduced pin count interface. 13 RMII selects 100 Base-tx reduced pin count interface. 14 15CONFIG_FEC_MXC_SWAP_PACKET 16 Forced on iff MX28. 17 Swaps the bytes order of all words(4 byte units) in the packet. 18 This should not be specified by a board file. It is cpu specific. 19 20CONFIG_PHYLIB 21 fec_mxc supports PHYLIB and should be used for new boards. 22 23CONFIG_FEC_MXC_NO_ANEG 24 Relevant only if PHYLIB not used. Skips auto-negotiation restart. 25 26CONFIG_FEC_MXC_PHYADDR 27 Optional, selects the exact phy address that should be connected 28 and function fecmxc_initialize will try to initialize it. 29 30 31Reading the ethaddr from the SoC eFuses: 32if CONFIG_FEC_MXC is defined and the U-Boot environment does not contain the 33ethaddr variable, then its value gets read from the corresponding eFuses in 34the SoC. See the README files of the specific SoC for details. 35