1U-Boot for Wandboard 2-------------------- 3 4This file contains information for the port of U-Boot to the Wandboard. 5 6Wandboard is a development board that has two variants: one version based 7on mx6 dual lite and another one based on mx6 solo. 8 9For more details about Wandboard, please refer to: 10http://www.wandboard.org/ 11 12Building U-boot for Wandboard 13----------------------------- 14 15To build U-Boot for the Wandboard Dual Lite version: 16 17$ make wandboard_dl_config 18$ make 19 20To build U-Boot for the Wandboard Solo version: 21 22$ make wandboard_solo_config 23$ make 24 25To build U-Boot for the Wandboard Quad version: 26 27$ make wandboard_quad_config 28$ make 29 30Flashing U-boot into the SD card 31-------------------------------- 32 33- After the 'make' command completes, the generated 'u-boot.imx' binary must be 34flashed into the SD card; 35 36$ sudo dd if=u-boot.imx of=/dev/mmcblk0 bs=512 seek=2; sync 37 38(Note - the SD card node may vary, so adjust this as needed). 39 40- Insert the SD card into the slot located in the bottom of the board (same side 41as the mx6 processor) 42 43- Connect the serial cable to the host PC 44 45- Power up the board and U-boot messages will appear in the serial console. 46