xref: /openbmc/u-boot/board/wandboard/README (revision e2d282a1)
1*e2d282a1SFabio EstevamU-Boot for Wandboard
2*e2d282a1SFabio Estevam--------------------
3*e2d282a1SFabio Estevam
4*e2d282a1SFabio EstevamThis file contains information for the port of U-Boot to the Wandboard.
5*e2d282a1SFabio Estevam
6*e2d282a1SFabio EstevamWandboard is a development board that has two variants: one version based
7*e2d282a1SFabio Estevamon mx6 dual lite and another one based on mx6 solo.
8*e2d282a1SFabio Estevam
9*e2d282a1SFabio EstevamFor more details about Wandboard, please refer to:
10*e2d282a1SFabio Estevamhttp://www.wandboard.org/
11*e2d282a1SFabio Estevam
12*e2d282a1SFabio EstevamBuilding U-boot for Wandboard
13*e2d282a1SFabio Estevam-----------------------------
14*e2d282a1SFabio Estevam
15*e2d282a1SFabio EstevamTo build U-Boot for the Wandboard Dual Lite version:
16*e2d282a1SFabio Estevam
17*e2d282a1SFabio Estevam$ make wanboard_dl_config
18*e2d282a1SFabio Estevam$ make
19*e2d282a1SFabio Estevam
20*e2d282a1SFabio EstevamTo build U-Boot for the Wandboard Solo version:
21*e2d282a1SFabio Estevam
22*e2d282a1SFabio Estevam$ make wanboard_solo_config
23*e2d282a1SFabio Estevam$ make
24*e2d282a1SFabio Estevam
25*e2d282a1SFabio EstevamFlashing U-boot into the SD card
26*e2d282a1SFabio Estevam--------------------------------
27*e2d282a1SFabio Estevam
28*e2d282a1SFabio Estevam- After the 'make' command completes, the generated 'u-boot.imx' binary must be
29*e2d282a1SFabio Estevamflashed into the SD card;
30*e2d282a1SFabio Estevam
31*e2d282a1SFabio Estevam$ sudo dd if=u-boot.imx of=/dev/mmcblk0 bs=512 seek=2; sync
32*e2d282a1SFabio Estevam
33*e2d282a1SFabio Estevam(Note - the SD card node may vary, so adjust this as needed).
34*e2d282a1SFabio Estevam
35*e2d282a1SFabio Estevam- Insert the SD card into the slot located in the bottom of the board (same side
36*e2d282a1SFabio Estevamas the mx6 processor)
37*e2d282a1SFabio Estevam
38*e2d282a1SFabio Estevam- Connect the serial cable to the host PC
39*e2d282a1SFabio Estevam
40*e2d282a1SFabio Estevam- Power up the board and U-boot messages will appear in the serial console.
41