1 /* 2 * Based on corenet_ds.c 3 * 4 * SPDX-License-Identifier: GPL-2.0+ 5 */ 6 7 #include <common.h> 8 #include <command.h> 9 #include <netdev.h> 10 #include <linux/compiler.h> 11 #include <asm/mmu.h> 12 #include <asm/processor.h> 13 #include <asm/cache.h> 14 #include <asm/immap_85xx.h> 15 #include <asm/fsl_law.h> 16 #include <asm/fsl_serdes.h> 17 #include <asm/fsl_portals.h> 18 #include <asm/fsl_liodn.h> 19 #include <fm_eth.h> 20 #include <pci.h> 21 22 #include "cyrus.h" 23 #include "../common/eeprom.h" 24 25 DECLARE_GLOBAL_DATA_PTR; 26 27 #define GPIO_OPENDRAIN 0x30000000 28 #define GPIO_DIR 0x3c000004 29 #define GPIO_INITIAL 0x30000000 30 #define GPIO_VGA_SWITCH 0x00001000 31 32 int checkboard(void) 33 { 34 printf("Board: CYRUS\n"); 35 36 return 0; 37 } 38 39 int board_early_init_f(void) 40 { 41 ccsr_gur_t *gur = (void *)(CONFIG_SYS_MPC85xx_GUTS_ADDR); 42 ccsr_gpio_t *pgpio = (void *)(CONFIG_SYS_MPC85xx_GPIO_ADDR); 43 44 /* 45 * Only use DDR1_MCK0/3 and DDR2_MCK0/3 46 * disable DDR1_MCK1/2/4/5 and DDR2_MCK1/2/4/5 to reduce 47 * the noise introduced by these unterminated and unused clock pairs. 48 */ 49 setbits_be32(&gur->ddrclkdr, 0x001B001B); 50 51 /* Set GPIO reset lines to open-drain, tristate */ 52 setbits_be32(&pgpio->gpdat, GPIO_INITIAL); 53 setbits_be32(&pgpio->gpodr, GPIO_OPENDRAIN); 54 55 /* Set GPIO Direction */ 56 setbits_be32(&pgpio->gpdir, GPIO_DIR); 57 58 return 0; 59 } 60 61 int board_early_init_r(void) 62 { 63 fsl_lbc_t *lbc = LBC_BASE_ADDR; 64 65 out_be32(&lbc->lbcr, 0); 66 /* 1 clock LALE cycle */ 67 out_be32(&lbc->lcrr, 0x80000000 | CONFIG_SYS_LBC_LCRR); 68 69 set_liodns(); 70 71 #ifdef CONFIG_SYS_DPAA_QBMAN 72 setup_portals(); 73 #endif 74 print_lbc_regs(); 75 return 0; 76 } 77 78 int misc_init_r(void) 79 { 80 return 0; 81 } 82 83 int ft_board_setup(void *blob, bd_t *bd) 84 { 85 phys_addr_t base; 86 phys_size_t size; 87 88 ft_cpu_setup(blob, bd); 89 90 base = getenv_bootm_low(); 91 size = getenv_bootm_size(); 92 93 fdt_fixup_memory(blob, (u64)base, (u64)size); 94 95 #ifdef CONFIG_PCI 96 pci_of_setup(blob, bd); 97 #endif 98 99 fdt_fixup_liodn(blob); 100 fdt_fixup_dr_usb(blob, bd); 101 102 #ifdef CONFIG_SYS_DPAA_FMAN 103 fdt_fixup_fman_ethernet(blob); 104 #endif 105 106 return 0; 107 } 108 109 int mac_read_from_eeprom(void) 110 { 111 init_eeprom(CONFIG_SYS_EEPROM_BUS_NUM, 112 CONFIG_SYS_I2C_EEPROM_ADDR, 113 CONFIG_SYS_I2C_EEPROM_ADDR_LEN); 114 115 return mac_read_from_eeprom_common(); 116 } 117