1 /* 2 * Copyright (C) 2012 Lucas Stach 3 * 4 * SPDX-License-Identifier: GPL-2.0+ 5 */ 6 7 #include <common.h> 8 #include <asm/arch/clock.h> 9 #include <asm/arch/funcmux.h> 10 #include <asm/arch/pinmux.h> 11 #include <asm/arch-tegra/ap.h> 12 #include <asm/arch-tegra/board.h> 13 #include <asm/arch-tegra/tegra.h> 14 #include <asm/gpio.h> 15 #include <asm/io.h> 16 #include <i2c.h> 17 #include <nand.h> 18 #include "../common/tdx-common.h" 19 20 DECLARE_GLOBAL_DATA_PTR; 21 22 #define PMU_I2C_ADDRESS 0x34 23 #define MAX_I2C_RETRY 3 24 #define PMU_SUPPLYENE 0x14 25 #define PMU_SUPPLYENE_SYSINEN (1<<5) 26 #define PMU_SUPPLYENE_EXITSLREQ (1<<1) 27 28 int arch_misc_init(void) 29 { 30 /* Disable PMIC sleep mode on low supply voltage */ 31 struct udevice *dev; 32 u8 addr, data[1]; 33 int err; 34 35 err = i2c_get_chip_for_busnum(0, PMU_I2C_ADDRESS, 1, &dev); 36 if (err) { 37 debug("%s: Cannot find PMIC I2C chip\n", __func__); 38 return err; 39 } 40 41 addr = PMU_SUPPLYENE; 42 43 err = dm_i2c_read(dev, addr, data, 1); 44 if (err) { 45 debug("failed to get PMU_SUPPLYENE\n"); 46 return err; 47 } 48 49 data[0] &= ~PMU_SUPPLYENE_SYSINEN; 50 data[0] |= PMU_SUPPLYENE_EXITSLREQ; 51 52 err = dm_i2c_write(dev, addr, data, 1); 53 if (err) { 54 debug("failed to set PMU_SUPPLYENE\n"); 55 return err; 56 } 57 58 /* make sure SODIMM pin 87 nRESET_OUT is released properly */ 59 pinmux_set_func(PMUX_PINGRP_ATA, PMUX_FUNC_GMI); 60 61 if (readl(NV_PA_BASE_SRAM + NVBOOTINFOTABLE_BOOTTYPE) == 62 NVBOOTTYPE_RECOVERY) 63 printf("USB recovery mode\n"); 64 65 return 0; 66 } 67 68 int checkboard(void) 69 { 70 printf("Model: Toradex Colibri T20 %dMB V%s\n", 71 (gd->ram_size == 0x10000000) ? 256 : 512, 72 (nand_info[0]->erasesize >> 10 == 512) ? 73 ((gd->ram_size == 0x10000000) ? "1.1B" : "1.1C") : "1.2A"); 74 75 return 0; 76 } 77 78 #if defined(CONFIG_OF_LIBFDT) && defined(CONFIG_OF_BOARD_SETUP) 79 int ft_board_setup(void *blob, bd_t *bd) 80 { 81 return ft_common_board_setup(blob, bd); 82 } 83 #endif 84 85 #ifdef CONFIG_MMC_SDHCI_TEGRA 86 /* 87 * Routine: pin_mux_mmc 88 * Description: setup the pin muxes/tristate values for the SDMMC(s) 89 */ 90 void pin_mux_mmc(void) 91 { 92 funcmux_select(PERIPH_ID_SDMMC4, FUNCMUX_SDMMC4_ATB_GMA_4_BIT); 93 pinmux_tristate_disable(PMUX_PINGRP_GMB); 94 } 95 #endif 96 97 #ifdef CONFIG_TEGRA_NAND 98 void pin_mux_nand(void) 99 { 100 funcmux_select(PERIPH_ID_NDFLASH, FUNCMUX_NDFLASH_KBC_8_BIT); 101 102 /* 103 * configure pingroup ATC to something unrelated to 104 * avoid ATC overriding KBC 105 */ 106 pinmux_set_func(PMUX_PINGRP_ATC, PMUX_FUNC_GMI); 107 } 108 #endif 109 110 #ifdef CONFIG_USB_EHCI_TEGRA 111 void pin_mux_usb(void) 112 { 113 /* module internal USB bus to connect ethernet chipset */ 114 funcmux_select(PERIPH_ID_USB2, FUNCMUX_USB2_ULPI); 115 116 /* ULPI reference clock output */ 117 pinmux_set_func(PMUX_PINGRP_CDEV2, PMUX_FUNC_PLLP_OUT4); 118 pinmux_tristate_disable(PMUX_PINGRP_CDEV2); 119 120 /* PHY reset GPIO */ 121 pinmux_tristate_disable(PMUX_PINGRP_UAC); 122 123 /* VBus GPIO */ 124 pinmux_tristate_disable(PMUX_PINGRP_DTE); 125 126 /* Reset ASIX using LAN_RESET */ 127 gpio_request(TEGRA_GPIO(V, 4), "LAN_RESET"); 128 gpio_direction_output(TEGRA_GPIO(V, 4), 0); 129 pinmux_tristate_disable(PMUX_PINGRP_GPV); 130 udelay(5); 131 gpio_set_value(TEGRA_GPIO(V, 4), 1); 132 133 /* USBH_PEN: USB 1 aka Tegra USB port 3 VBus */ 134 pinmux_tristate_disable(PMUX_PINGRP_SPIG); 135 } 136 #endif 137 138 #ifdef CONFIG_VIDEO_TEGRA20 139 /* 140 * Routine: pin_mux_display 141 * Description: setup the pin muxes/tristate values for the LCD interface) 142 */ 143 void pin_mux_display(void) 144 { 145 /* 146 * Manually untristate BL_ON (PT4 - SODIMM 71) as specified through 147 * device-tree 148 */ 149 pinmux_tristate_disable(PMUX_PINGRP_DTA); 150 151 pinmux_set_func(PMUX_PINGRP_SDC, PMUX_FUNC_PWM); 152 pinmux_tristate_disable(PMUX_PINGRP_SDC); 153 } 154 #endif 155