1Update from original Marvell U-Boot to mainline U-Boot: 2------------------------------------------------------- 3 4Generate the U-Boot image with these commands: 5 6$ make clearfog_defconfig 7$ make 8 9The resulting image including the SPL binary with the 10full DDR setup is "u-boot-spl.kwb". 11 12Now all you need to do is copy this image on a SD card. 13For example with this command: 14 15$ sudo dd if=u-boot-spl.kwb of=/dev/sdX bs=512 seek=1 16 17Please use the correct device node for your setup instead 18of "/dev/sdX" here! 19 20Boot selection: 21--------------- 22 23Before powering up the board, boot selection should be done via the SW1 dip 24switch (0: OFF, 1: ON): 25 26 - SPI: 00010 27 - SD/eMMC: 00111 28 - M.2 SSD: 11100 29 - UART: 01001 [1] 30 31[1]: According to SolidRun's manual, 11110 should be used for UART booting on 32 the ClearFog 'Pro' variant. 33 However, this doesn't work (anymore) at least on Rev. 2.1 (but '01001' as 34 mentionend for the 'Base' variant does). 35 36Boot from UART: 37--------------- 38 39Connect the on-board micro-USB (CF Pro: CON11, CF Base: CON5) 40to your host. 41 42Set the SW1 DIP switches to UART boot (see above). 43 44Run the following command to initiate U-Boot download: 45 46 ./tools/kwboot -b u-boot-spl.kwb /dev/ttyUSBX 47 48Use the correct UART device node for /dev/ttyUSBX. 49 50When download finishes start your favorite terminal emulator 51on /dev/ttyUSBX. 52