1 // SPDX-License-Identifier: GPL-2.0+
2 /*
3  * board/renesas/salvator-x/salvator-x.c
4  *     This file is Salvator-X/Salvator-XS board support.
5  *
6  * Copyright (C) 2015-2017 Renesas Electronics Corporation
7  * Copyright (C) 2015 Nobuhiro Iwamatsu <iwamatsu@nigauri.org>
8  */
9 
10 #include <common.h>
11 #include <malloc.h>
12 #include <netdev.h>
13 #include <dm.h>
14 #include <dm/platform_data/serial_sh.h>
15 #include <asm/processor.h>
16 #include <asm/mach-types.h>
17 #include <asm/io.h>
18 #include <linux/errno.h>
19 #include <asm/arch/sys_proto.h>
20 #include <asm/gpio.h>
21 #include <asm/arch/gpio.h>
22 #include <asm/arch/rmobile.h>
23 #include <asm/arch/rcar-mstp.h>
24 #include <asm/arch/sh_sdhi.h>
25 #include <i2c.h>
26 #include <mmc.h>
27 
28 DECLARE_GLOBAL_DATA_PTR;
29 
30 void s_init(void)
31 {
32 }
33 
34 #define SCIF2_MSTP310		BIT(10)	/* SCIF2 */
35 #define DVFS_MSTP926		BIT(26)
36 #define HSUSB_MSTP704		BIT(4)	/* HSUSB */
37 
38 int board_early_init_f(void)
39 {
40 #if defined(CONFIG_SYS_I2C) && defined(CONFIG_SYS_I2C_SH)
41 	/* DVFS for reset */
42 	mstp_clrbits_le32(SMSTPCR9, SMSTPCR9, DVFS_MSTP926);
43 #endif
44 	return 0;
45 }
46 
47 /* HSUSB block registers */
48 #define HSUSB_REG_LPSTS			0xE6590102
49 #define HSUSB_REG_LPSTS_SUSPM_NORMAL	BIT(14)
50 #define HSUSB_REG_UGCTRL2		0xE6590184
51 #define HSUSB_REG_UGCTRL2_USB0SEL	0x30
52 #define HSUSB_REG_UGCTRL2_USB0SEL_EHCI	0x10
53 
54 int board_init(void)
55 {
56 	/* adress of boot parameters */
57 	gd->bd->bi_boot_params = CONFIG_SYS_TEXT_BASE + 0x50000;
58 
59 	/* USB1 pull-up */
60 	setbits_le32(PFC_PUEN6, PUEN_USB1_OVC | PUEN_USB1_PWEN);
61 
62 	/* Configure the HSUSB block */
63 	mstp_clrbits_le32(SMSTPCR7, SMSTPCR7, HSUSB_MSTP704);
64 	/* Choice USB0SEL */
65 	clrsetbits_le32(HSUSB_REG_UGCTRL2, HSUSB_REG_UGCTRL2_USB0SEL,
66 			HSUSB_REG_UGCTRL2_USB0SEL_EHCI);
67 	/* low power status */
68 	setbits_le16(HSUSB_REG_LPSTS, HSUSB_REG_LPSTS_SUSPM_NORMAL);
69 
70 	return 0;
71 }
72 
73 int dram_init(void)
74 {
75 	if (fdtdec_setup_mem_size_base() != 0)
76 		return -EINVAL;
77 
78 	return 0;
79 }
80 
81 int dram_init_banksize(void)
82 {
83 	fdtdec_setup_memory_banksize();
84 
85 	return 0;
86 }
87 
88 #define RST_BASE	0xE6160000
89 #define RST_CA57RESCNT	(RST_BASE + 0x40)
90 #define RST_CA53RESCNT	(RST_BASE + 0x44)
91 #define RST_RSTOUTCR	(RST_BASE + 0x58)
92 #define RST_CODE	0xA5A5000F
93 
94 void reset_cpu(ulong addr)
95 {
96 #if defined(CONFIG_SYS_I2C) && defined(CONFIG_SYS_I2C_SH)
97 	i2c_reg_write(CONFIG_SYS_I2C_POWERIC_ADDR, 0x20, 0x80);
98 #else
99 	/* only CA57 ? */
100 	writel(RST_CODE, RST_CA57RESCNT);
101 #endif
102 }
103