xref: /openbmc/u-boot/board/nvidia/cardhu/cardhu.c (revision fd0bc623)
1 // SPDX-License-Identifier: GPL-2.0+
2 /*
3  *  (C) Copyright 2010-2013
4  *  NVIDIA Corporation <www.nvidia.com>
5  */
6 
7 #include <common.h>
8 #include <dm.h>
9 #include <asm/arch/pinmux.h>
10 #include <asm/arch/gp_padctrl.h>
11 #include <asm/arch/gpio.h>
12 #include <asm/gpio.h>
13 #include "pinmux-config-cardhu.h"
14 #include <i2c.h>
15 
16 #define PMU_I2C_ADDRESS		0x2D
17 #define MAX_I2C_RETRY		3
18 
19 /*
20  * Routine: pinmux_init
21  * Description: Do individual peripheral pinmux configs
22  */
23 void pinmux_init(void)
24 {
25 	pinmux_config_pingrp_table(tegra3_pinmux_common,
26 		ARRAY_SIZE(tegra3_pinmux_common));
27 
28 	pinmux_config_pingrp_table(unused_pins_lowpower,
29 		ARRAY_SIZE(unused_pins_lowpower));
30 
31 	/* Initialize any non-default pad configs (APB_MISC_GP regs) */
32 	pinmux_config_drvgrp_table(cardhu_padctrl, ARRAY_SIZE(cardhu_padctrl));
33 }
34 
35 #if defined(CONFIG_MMC_SDHCI_TEGRA)
36 /*
37  * Do I2C/PMU writes to bring up SD card bus power
38  *
39  */
40 void board_sdmmc_voltage_init(void)
41 {
42 	struct udevice *dev;
43 	uchar reg, data_buffer[1];
44 	int ret;
45 	int i;
46 
47 	ret = i2c_get_chip_for_busnum(0, PMU_I2C_ADDRESS, 1, &dev);
48 	if (ret) {
49 		debug("%s: Cannot find PMIC I2C chip\n", __func__);
50 		return;
51 	}
52 
53 	/* TPS659110: LDO5_REG = 3.3v, ACTIVE to SDMMC1 */
54 	data_buffer[0] = 0x65;
55 	reg = 0x32;
56 
57 	for (i = 0; i < MAX_I2C_RETRY; ++i) {
58 		if (dm_i2c_write(dev, reg, data_buffer, 1))
59 			udelay(100);
60 	}
61 
62 	/* TPS659110: GPIO7_REG = PDEN, output a 1 to EN_3V3_SYS */
63 	data_buffer[0] = 0x09;
64 	reg = 0x67;
65 
66 	for (i = 0; i < MAX_I2C_RETRY; ++i) {
67 		if (dm_i2c_write(dev, reg, data_buffer, 1))
68 			udelay(100);
69 	}
70 }
71 
72 /*
73  * Routine: pin_mux_mmc
74  * Description: setup the MMC muxes, power rails, etc.
75  */
76 void pin_mux_mmc(void)
77 {
78 	/*
79 	 * NOTE: We don't do mmc-specific pin muxes here.
80 	 * They were done globally in pinmux_init().
81 	 */
82 
83 	/* Bring up the SDIO1 power rail */
84 	board_sdmmc_voltage_init();
85 }
86 #endif	/* MMC */
87 
88 #ifdef CONFIG_PCI_TEGRA
89 int tegra_pcie_board_init(void)
90 {
91 	struct udevice *dev;
92 	u8 addr, data[1];
93 	int err;
94 
95 	err = i2c_get_chip_for_busnum(0, PMU_I2C_ADDRESS, 1, &dev);
96 	if (err) {
97 		debug("failed to find PMU bus\n");
98 		return err;
99 	}
100 
101 	/* TPS659110: LDO1_REG = 1.05V, ACTIVE */
102 	data[0] = 0x15;
103 	addr = 0x30;
104 
105 	err = dm_i2c_write(dev, addr, data, 1);
106 	if (err) {
107 		debug("failed to set VDD supply\n");
108 		return err;
109 	}
110 
111 	/* GPIO: PEX = 3.3V */
112 	err = gpio_request(TEGRA_GPIO(L, 7), "PEX");
113 	if (err < 0)
114 		return err;
115 
116 	gpio_direction_output(TEGRA_GPIO(L, 7), 1);
117 
118 	/* TPS659110: LDO2_REG = 1.05V, ACTIVE */
119 	data[0] = 0x15;
120 	addr = 0x31;
121 
122 	err = dm_i2c_write(dev, addr, data, 1);
123 	if (err) {
124 		debug("failed to set AVDD supply\n");
125 		return err;
126 	}
127 
128 	return 0;
129 }
130 #endif /* PCI */
131