xref: /openbmc/u-boot/board/nvidia/cardhu/cardhu.c (revision 23ff8633)
1 /*
2  *  (C) Copyright 2010-2013
3  *  NVIDIA Corporation <www.nvidia.com>
4  *
5  * SPDX-License-Identifier:	GPL-2.0+
6  */
7 
8 #include <common.h>
9 #include <dm.h>
10 #include <asm/arch/pinmux.h>
11 #include <asm/arch/gp_padctrl.h>
12 #include <asm/arch/gpio.h>
13 #include <asm/gpio.h>
14 #include "pinmux-config-cardhu.h"
15 #include <i2c.h>
16 
17 #define PMU_I2C_ADDRESS		0x2D
18 #define MAX_I2C_RETRY		3
19 
20 /*
21  * Routine: pinmux_init
22  * Description: Do individual peripheral pinmux configs
23  */
24 void pinmux_init(void)
25 {
26 	pinmux_config_pingrp_table(tegra3_pinmux_common,
27 		ARRAY_SIZE(tegra3_pinmux_common));
28 
29 	pinmux_config_pingrp_table(unused_pins_lowpower,
30 		ARRAY_SIZE(unused_pins_lowpower));
31 
32 	/* Initialize any non-default pad configs (APB_MISC_GP regs) */
33 	pinmux_config_drvgrp_table(cardhu_padctrl, ARRAY_SIZE(cardhu_padctrl));
34 }
35 
36 #if defined(CONFIG_TEGRA_MMC)
37 /*
38  * Do I2C/PMU writes to bring up SD card bus power
39  *
40  */
41 void board_sdmmc_voltage_init(void)
42 {
43 	struct udevice *dev;
44 	uchar reg, data_buffer[1];
45 	int ret;
46 	int i;
47 
48 	ret = i2c_get_chip_for_busnum(0, PMU_I2C_ADDRESS, 1, &dev);
49 	if (ret) {
50 		debug("%s: Cannot find PMIC I2C chip\n", __func__);
51 		return;
52 	}
53 
54 	/* TPS659110: LDO5_REG = 3.3v, ACTIVE to SDMMC1 */
55 	data_buffer[0] = 0x65;
56 	reg = 0x32;
57 
58 	for (i = 0; i < MAX_I2C_RETRY; ++i) {
59 		if (dm_i2c_write(dev, reg, data_buffer, 1))
60 			udelay(100);
61 	}
62 
63 	/* TPS659110: GPIO7_REG = PDEN, output a 1 to EN_3V3_SYS */
64 	data_buffer[0] = 0x09;
65 	reg = 0x67;
66 
67 	for (i = 0; i < MAX_I2C_RETRY; ++i) {
68 		if (dm_i2c_write(dev, reg, data_buffer, 1))
69 			udelay(100);
70 	}
71 }
72 
73 /*
74  * Routine: pin_mux_mmc
75  * Description: setup the MMC muxes, power rails, etc.
76  */
77 void pin_mux_mmc(void)
78 {
79 	/*
80 	 * NOTE: We don't do mmc-specific pin muxes here.
81 	 * They were done globally in pinmux_init().
82 	 */
83 
84 	/* Bring up the SDIO1 power rail */
85 	board_sdmmc_voltage_init();
86 }
87 #endif	/* MMC */
88 
89 #ifdef CONFIG_PCI_TEGRA
90 int tegra_pcie_board_init(void)
91 {
92 	struct udevice *dev;
93 	u8 addr, data[1];
94 	int err;
95 
96 	err = i2c_get_chip_for_busnum(0, PMU_I2C_ADDRESS, 1, &dev);
97 	if (err) {
98 		debug("failed to find PMU bus\n");
99 		return err;
100 	}
101 
102 	/* TPS659110: LDO1_REG = 1.05V, ACTIVE */
103 	data[0] = 0x15;
104 	addr = 0x30;
105 
106 	err = dm_i2c_write(dev, addr, data, 1);
107 	if (err) {
108 		debug("failed to set VDD supply\n");
109 		return err;
110 	}
111 
112 	/* GPIO: PEX = 3.3V */
113 	err = gpio_request(GPIO_PL7, "PEX");
114 	if (err < 0)
115 		return err;
116 
117 	gpio_direction_output(GPIO_PL7, 1);
118 
119 	/* TPS659110: LDO2_REG = 1.05V, ACTIVE */
120 	data[0] = 0x15;
121 	addr = 0x31;
122 
123 	err = dm_i2c_write(dev, addr, data, 1);
124 	if (err) {
125 		debug("failed to set AVDD supply\n");
126 		return err;
127 	}
128 
129 	return 0;
130 }
131 #endif /* PCI */
132