1 /* 2 * (C) Copyright 2013 Keymile AG 3 * Valentin Longchamp <valentin.longchamp@keymile.com> 4 * 5 * Copyright 2009-2011 Freescale Semiconductor, Inc. 6 * 7 * SPDX-License-Identifier: GPL-2.0+ 8 */ 9 10 #include <common.h> 11 #include <i2c.h> 12 #include <hwconfig.h> 13 #include <asm/mmu.h> 14 #include <asm/fsl_ddr_sdram.h> 15 #include <asm/fsl_ddr_dimm_params.h> 16 17 void fsl_ddr_board_options(memctl_options_t *popts, 18 dimm_params_t *pdimm, 19 unsigned int ctrl_num) 20 { 21 if (ctrl_num) { 22 printf("Wrong parameter for controller number %d", ctrl_num); 23 return; 24 } 25 26 /* automatic calibration for nb of cycles between read and DQS pre */ 27 popts->cpo_override = 0xFF; 28 29 /* 1/2 clk delay between wr command and data strobe */ 30 popts->write_data_delay = 4; 31 /* clk lauched 1/2 applied cylcle after address command */ 32 popts->clk_adjust = 4; 33 /* 1T timing: command/address held for only 1 cycle */ 34 popts->twot_en = 0; 35 36 /* we have only one module, half str should be OK */ 37 popts->half_strength_driver_enable = 1; 38 39 /* wrlvl values overriden as recommended by ddr init func */ 40 popts->wrlvl_override = 1; 41 popts->wrlvl_sample = 0xf; 42 popts->wrlvl_start = 0x6; 43 44 /* Enable ZQ calibration */ 45 popts->zq_en = 1; 46 47 /* DHC_EN =1, ODT = 75 Ohm */ 48 popts->ddr_cdr1 = DDR_CDR1_DHC_EN | DDR_CDR_ODT_75ohm; 49 } 50 51 phys_size_t initdram(int board_type) 52 { 53 phys_size_t dram_size = 0; 54 55 puts("Initializing with SPD\n"); 56 57 dram_size = fsl_ddr_sdram(); 58 59 dram_size = setup_ddr_tlbs(dram_size / 0x100000); 60 dram_size *= 0x100000; 61 62 debug(" DDR: "); 63 return dram_size; 64 } 65