1Keymile kmeter1 Board
2-----------------------------------------
31.	Alternative Boot EEPROM
4
5    Upon the kmeter1 startup the I2C_1 controller is used to fetch the boot
6    configuration from a serial EEPROM. During the development and debugging
7    phase it might be helpful to apply an alternative boot configuration in
8    a simple way. Therefore it is an alternative boot eeprom on the PIGGY,
9    which can be activated by setting the "ST" jumper on the PIGGY board.
10
112.	Memory Map
12
13    BaseAddr    PortSz  Size  Device
14    ----------- ------  -----  ------
15    0x0000_0000 64 bit  256MB  DDR
16    0x8000_0000  8 bit  256KB  GPIO/PIGGY on CS1
17    0xa000_0000  8 bit  256MB  PAXE on CS3
18    0xe000_0000           2MB  Int Mem Reg Space
19    0xf000_0000 16 bit  256MB  FLASH on CS0
20
21
22    DDR-SDRAM:
23    The current realization is made with four 16-bits memory devices.
24    Mounting options have been foreseen for device architectures from
25    4Mx16 to 512Mx16. The kmeter1 is equipped with four 32Mx16 devices
26    thus resulting in a total capacity of 256MBytes.
27
283. Compilation
29
30	Assuming you're using BASH shell:
31
32		export CROSS_COMPILE=your-cross-compile-prefix
33		cd u-boot
34		make distclean
35		make kmeter1_config
36		make
37
384. Downloading and Flashing Images
39
404.0 Download over serial line using Kermit:
41
42	loadb
43	[Drop to kermit:
44	    ^\c
45	    send <u-boot-bin-image>
46	    c
47	]
48
49
50    Or via tftp:
51
52	tftp 10000 u-boot.bin
53    => run load
54    Using UEC0 device
55    TFTP from server 192.168.1.1; our IP address is 192.168.205.4
56    Filename '/tftpboot/kmeter1/u-boot.bin'.
57    Load address: 0x200000
58    Loading: ##############
59    done
60    Bytes transferred = 204204 (31dac hex)
61    =>
62
634.1 Reflash U-Boot Image using U-Boot
64
65    => run update
66    ..... done
67    Un-Protected 5 sectors
68
69    ..... done
70    Erased 5 sectors
71    Copy to Flash... done
72    ..... done
73    Protected 5 sectors
74    Total of 204204 bytes were the same
75    Saving Environment to Flash...
76    . done
77    Un-Protected 1 sectors
78    . done
79    Un-Protected 1 sectors
80    Erasing Flash...
81    . done
82    Erased 1 sectors
83    Writing to Flash... done
84    . done
85    Protected 1 sectors
86    . done
87    Protected 1 sectors
88    =>
89
905. Notes
91	1) The console baudrate for kmeter1 is 115200bps.
92