1 /* 2 * Copyright (C) 2016, Bin Meng <bmeng.cn@gmail.com> 3 * 4 * SPDX-License-Identifier: GPL-2.0+ 5 */ 6 7 #include <common.h> 8 #include <dm.h> 9 #include <errno.h> 10 #include <pci.h> 11 #include <smsc_sio1007.h> 12 #include <asm/ibmpc.h> 13 #include <asm/pci.h> 14 #include <asm/arch/pch.h> 15 16 #define SIO1007_RUNTIME_IOPORT 0x180 17 18 int board_early_init_f(void) 19 { 20 struct udevice *pch; 21 int ret; 22 23 ret = uclass_first_device(UCLASS_PCH, &pch); 24 if (ret) 25 return ret; 26 if (!pch) 27 return -ENODEV; 28 29 /* Initialize LPC interface to turn on superio chipset decode range */ 30 dm_pci_write_config16(pch, LPC_IO_DEC, COMA_DEC_RANGE | COMB_DEC_RANGE); 31 dm_pci_write_config16(pch, LPC_EN, KBC_LPC_EN | COMA_LPC_EN); 32 dm_pci_write_config32(pch, LPC_GEN1_DEC, GEN_DEC_RANGE_256B | 33 (SIO1007_IOPORT3 & 0xff00) | GEN_DEC_RANGE_EN); 34 dm_pci_write_config32(pch, LPC_GEN2_DEC, GEN_DEC_RANGE_16B | 35 SIO1007_RUNTIME_IOPORT | GEN_DEC_RANGE_EN); 36 37 /* Enable legacy serial port at 0x3f8 */ 38 sio1007_enable_serial(SIO1007_IOPORT3, 0, UART0_BASE, UART0_IRQ); 39 40 /* Enable SIO1007 runtime I/O port at 0x180 */ 41 sio1007_enable_runtime(SIO1007_IOPORT3, SIO1007_RUNTIME_IOPORT); 42 43 /* 44 * On Cougar Canyon 2 board, the RS232 transiver connected to serial 45 * port 0 (0x3f8) is controlled by a GPIO pin (GPIO10) on the SIO1007. 46 * Set the pin value to 1 to enable the RS232 transiver. 47 */ 48 sio1007_gpio_config(SIO1007_IOPORT3, 0, GPIO_DIR_OUTPUT, 49 GPIO_POL_NO_INVERT, GPIO_TYPE_PUSH_PULL); 50 sio1007_gpio_set_value(SIO1007_RUNTIME_IOPORT, 0, 1); 51 52 return 0; 53 } 54 55 void setup_pch_gpios(u16 gpiobase, const struct pch_gpio_map *gpio) 56 { 57 return; 58 } 59