1 /** 2 * Copyright 2011 Freescale Semiconductor 3 * Author: Mingkai Hu <Mingkai.hu@freescale.com> 4 * 5 * This program is free software; you can redistribute it and/or modify it 6 * under the terms of the GNU General Public License as published by the Free 7 * Software Foundation; either version 2 of the License, or (at your option) 8 * any later version. 9 * 10 * This file provides support for the ngPIXIS, a board-specific FPGA used on 11 * some Freescale reference boards. 12 */ 13 14 /* 15 * CPLD register set. Feel free to add board-specific #ifdefs where necessary. 16 */ 17 typedef struct cpld_data { 18 u8 cpld_ver; /* 0x0 - CPLD Major Revision Register */ 19 u8 cpld_ver_sub; /* 0x1 - CPLD Minor Revision Register */ 20 u8 pcba_ver; /* 0x2 - PCBA Revision Register */ 21 u8 system_rst; /* 0x3 - system reset register */ 22 u8 res0; /* 0x4 - not used */ 23 u8 sw_ctl_on; /* 0x5 - Switch Control Enable Register */ 24 u8 por_cfg; /* 0x6 - POR Control Register */ 25 u8 switch_strobe; /* 0x7 - Multiplexed pin Select Register */ 26 u8 jtag_sel; /* 0x8 - JTAG or AURORA Selection */ 27 u8 sdbank1_clk; /* 0x9 - SerDes Bank1 Reference clock */ 28 u8 sdbank2_clk; /* 0xa - SerDes Bank2 Reference clock */ 29 u8 fbank_sel; /* 0xb - Flash bank selection */ 30 u8 serdes_mux; /* 0xc - Multiplexed pin Select Register */ 31 u8 sw[1]; /* 0xd - SW2 Status */ 32 u8 system_rst_default; /* 0xe - system reset to default register */ 33 u8 sysclk_sw1; /* 0xf - sysclk configuration register */ 34 } __attribute__ ((packed)) cpld_data_t; 35 36 #define SERDES_MUX_LANE_6_MASK 0x2 37 #define SERDES_MUX_LANE_6_SHIFT 1 38 #define SERDES_MUX_LANE_A_MASK 0x1 39 #define SERDES_MUX_LANE_A_SHIFT 0 40 #define SERDES_MUX_LANE_C_MASK 0x4 41 #define SERDES_MUX_LANE_C_SHIFT 2 42 #define SERDES_MUX_LANE_D_MASK 0x8 43 #define SERDES_MUX_LANE_D_SHIFT 3 44 #define CPLD_SWITCH_BANK_ENABLE 0x40 45 #define CPLD_SYSCLK_83 0x1 /* system clock 83.3MHz */ 46 #define CPLD_SYSCLK_100 0x2 /* system clock 100MHz */ 47 48 /* Pointer to the CPLD register set */ 49 #define cpld ((cpld_data_t *)CPLD_BASE) 50 51 /* The CPLD SW register that corresponds to board switch X, where x >= 1 */ 52 #define CPLD_SW(x) (cpld->sw[(x) - 2]) 53 54 u8 cpld_read(unsigned int reg); 55 void cpld_write(unsigned int reg, u8 value); 56 57 #define CPLD_READ(reg) cpld_read(offsetof(cpld_data_t, reg)) 58 #define CPLD_WRITE(reg, value) cpld_write(offsetof(cpld_data_t, reg), value) 59