1How to use U-Boot on Freescale MX6UL 14x14 EVK
2-----------------------------------------------
3
4- Build U-Boot for MX6UL 14x14 EVK:
5
6$ make mrproper
7$ make mx6ul_14x14_evk_defconfig
8$ make
9
10This will generate the SPL image called SPL and the u-boot.img.
11
12- Flash the SPL image into the micro SD card:
13
14sudo dd if=SPL of=/dev/mmcblk0 bs=1k seek=1; sync
15
16- Flash the u-boot.img image into the micro SD card:
17
18sudo dd if=u-boot.img of=/dev/mmcblk0 bs=1k seek=69; sync
19
20- Jumper settings:
21
22SW601: 0 0 1 0
23Sw602: 1 0
24
25where 0 means bottom position and 1 means top position (from the
26switch label numbers reference).
27
28- Connect the USB cable between the EVK and the PC for the console.
29(The USB console connector is the one close the push buttons)
30
31- Insert the micro SD card in the board, power it up and U-Boot messages should
32come up.
33