Name |
Date |
Size |
#Lines |
LOC |
||
---|---|---|---|---|---|---|
.. | - | - | ||||
Kconfig | H A D | 14-Oct-2015 | 193 | 13 | 8 | |
MAINTAINERS | H A D | 21-Feb-2016 | 205 | 8 | 7 | |
Makefile | H A D | 06-May-2018 | 116 | 5 | 1 | |
README | H A D | 08-Feb-2016 | 832 | 33 | 20 | |
mx6ul_14x14_evk.c | H A D | 13-Mar-2019 | 19.8 KiB | 743 | 568 |
README
1How to use U-Boot on Freescale MX6UL 14x14 EVK 2----------------------------------------------- 3 4- Build U-Boot for MX6UL 14x14 EVK: 5 6$ make mrproper 7$ make mx6ul_14x14_evk_defconfig 8$ make 9 10This will generate the SPL image called SPL and the u-boot.img. 11 12- Flash the SPL image into the micro SD card: 13 14sudo dd if=SPL of=/dev/mmcblk0 bs=1k seek=1; sync 15 16- Flash the u-boot.img image into the micro SD card: 17 18sudo dd if=u-boot.img of=/dev/mmcblk0 bs=1k seek=69; sync 19 20- Jumper settings: 21 22SW601: 0 0 1 0 23Sw602: 1 0 24 25where 0 means bottom position and 1 means top position (from the 26switch label numbers reference). 27 28- Connect the USB cable between the EVK and the PC for the console. 29(The USB console connector is the one close the push buttons) 30 31- Insert the micro SD card in the board, power it up and U-Boot messages should 32come up. 33