Name |
Date |
Size |
#Lines |
LOC |
||
---|---|---|---|---|---|---|
.. | - | - | ||||
Kconfig | H A D | 27-Nov-2017 | 153 | 13 | 8 | |
MAINTAINERS | H A D | 18-May-2018 | 666 | 20 | 19 | |
Makefile | H A D | 06-May-2018 | 100 | 5 | 1 | |
README | H A D | 27-Nov-2017 | 874 | 34 | 20 | |
imx6ul.c | H A D | 06-May-2018 | 3.3 KiB | 97 | 67 |
README
1Hsow to use U-Boot on Engicam GEAM6UL and Is.IoT MX6UL Starter Kit: 2------------------------------------------------------------------- 3 4$ make mrproper 5 6- Configure U-Boot for Engicam GEAM6UL: 7$ make imx6ul_geam_mmc_defconfig 8 9- Configure U-Boot for Engicam Is.IoT MX6UL: 10$ make imx6ul_isiot_mmc_defconfig 11 12- Build U-Boot 13$ make 14 15This will generate the SPL image called SPL and the u-boot-dtb.img. 16 17- Flash the SPL image into the micro SD card: 18 19sudo dd if=SPL of=/dev/mmcblk0 bs=1k seek=1; sync 20 21- Flash the u-boot-dtb.img image into the micro SD card: 22 23sudo dd if=u-boot-dtb.img of=/dev/mmcblk0 bs=1k seek=69; sync 24 25- Jumper settings: 26 27MMC Boot: JM3 Closed 28 29- Connect the Serial cable between the Starter Kit and the PC for the console. 30(J28 is the Linux Serial console connector) 31 32- Insert the micro SD card in the board, power it up and U-Boot messages should 33come up. 34