1 // SPDX-License-Identifier: GPL-2.0+
2 /*
3  * Copyright (C) 2016 Stefan Roese <sr@denx.de>
4  */
5 
6 #include <common.h>
7 #include <i2c.h>
8 #include <winbond_w83627.h>
9 #include <asm/gpio.h>
10 #include <asm/ibmpc.h>
11 #include <asm/pnp_def.h>
12 
13 int board_early_init_f(void)
14 {
15 #ifndef CONFIG_INTERNAL_UART
16 	/*
17 	 * The FSP enables the BayTrail internal legacy UART (again).
18 	 * Disable it again, so that the Winbond one can be used.
19 	 */
20 	setup_internal_uart(0);
21 
22 	/* Enable the legacy UART in the Winbond W83627 Super IO chip */
23 	winbond_enable_serial(PNP_DEV(WINBOND_IO_PORT, W83627DHG_SP1),
24 			      UART0_BASE, UART0_IRQ);
25 #endif
26 
27 	return 0;
28 }
29 
30 int board_late_init(void)
31 {
32 	struct udevice *dev;
33 	u8 buf[8];
34 	int ret;
35 
36 	/* Configure SMSC USB2513 USB Hub: 7bit address 0x2c */
37 	ret = i2c_get_chip_for_busnum(0, 0x2c, 1, &dev);
38 	if (ret) {
39 		printf("Cannot find USB2513: %d\n", ret);
40 		return 0;
41 	}
42 
43 	/*
44 	 * The first access to the USB Hub fails sometimes, so lets read
45 	 * a dummy byte to be sure here
46 	 */
47 	dm_i2c_read(dev, 0x00, buf, 1);
48 
49 	/*
50 	 * The SMSC hub is not visible on the I2C bus after the first
51 	 * configuration at power-up. The following code deliberately
52 	 * does not report upon failure of these I2C write calls.
53 	 */
54 	buf[0] = 0x93;
55 	dm_i2c_write(dev, 0x06, buf, 1);
56 
57 	buf[0] = 0xaa;
58 	dm_i2c_write(dev, 0xf8, buf, 1);
59 
60 	buf[0] = 0x0f;
61 	dm_i2c_write(dev, 0xfa, buf, 1);
62 
63 	buf[0] = 0x01;
64 	dm_i2c_write(dev, 0xff, buf, 1);
65 
66 	return 0;
67 }
68