1 /*
2  * Copyright (C) 2014 Atmel Corporation
3  *		      Bo Shen <voice.shen@atmel.com>
4  *
5  * SPDX-License-Identifier:	GPL-2.0+
6  */
7 
8 #include <common.h>
9 #include <mmc.h>
10 #include <asm/io.h>
11 #include <asm/arch/sama5d3_smc.h>
12 #include <asm/arch/at91_common.h>
13 #include <asm/arch/at91_pmc.h>
14 #include <asm/arch/at91_rstc.h>
15 #include <asm/arch/gpio.h>
16 #include <asm/arch/clk.h>
17 #include <atmel_mci.h>
18 #include <net.h>
19 #include <netdev.h>
20 #include <spl.h>
21 #include <asm/arch/atmel_mpddrc.h>
22 #include <asm/arch/at91_wdt.h>
23 
24 DECLARE_GLOBAL_DATA_PTR;
25 
26 #ifdef CONFIG_NAND_ATMEL
27 void sama5d3_xplained_nand_hw_init(void)
28 {
29 	struct at91_smc *smc = (struct at91_smc *)ATMEL_BASE_SMC;
30 
31 	at91_periph_clk_enable(ATMEL_ID_SMC);
32 
33 	/* Configure SMC CS3 for NAND/SmartMedia */
34 	writel(AT91_SMC_SETUP_NWE(2) | AT91_SMC_SETUP_NCS_WR(1) |
35 	       AT91_SMC_SETUP_NRD(2) | AT91_SMC_SETUP_NCS_RD(1),
36 	       &smc->cs[3].setup);
37 	writel(AT91_SMC_PULSE_NWE(3) | AT91_SMC_PULSE_NCS_WR(5) |
38 	       AT91_SMC_PULSE_NRD(3) | AT91_SMC_PULSE_NCS_RD(5),
39 	       &smc->cs[3].pulse);
40 	writel(AT91_SMC_CYCLE_NWE(8) | AT91_SMC_CYCLE_NRD(8),
41 	       &smc->cs[3].cycle);
42 	writel(AT91_SMC_TIMINGS_TCLR(3) | AT91_SMC_TIMINGS_TADL(10) |
43 	       AT91_SMC_TIMINGS_TAR(3)  | AT91_SMC_TIMINGS_TRR(4)   |
44 	       AT91_SMC_TIMINGS_TWB(5)  | AT91_SMC_TIMINGS_RBNSEL(3)|
45 	       AT91_SMC_TIMINGS_NFSEL(1), &smc->cs[3].timings);
46 	writel(AT91_SMC_MODE_RM_NRD | AT91_SMC_MODE_WM_NWE |
47 	       AT91_SMC_MODE_EXNW_DISABLE |
48 #ifdef CONFIG_SYS_NAND_DBW_16
49 	       AT91_SMC_MODE_DBW_16 |
50 #else /* CONFIG_SYS_NAND_DBW_8 */
51 	       AT91_SMC_MODE_DBW_8 |
52 #endif
53 	       AT91_SMC_MODE_TDF_CYCLE(3),
54 	       &smc->cs[3].mode);
55 }
56 #endif
57 
58 #ifdef CONFIG_CMD_USB
59 static void sama5d3_xplained_usb_hw_init(void)
60 {
61 	at91_set_pio_output(AT91_PIO_PORTE, 3, 0);
62 	at91_set_pio_output(AT91_PIO_PORTE, 4, 0);
63 }
64 #endif
65 
66 #ifdef CONFIG_GENERIC_ATMEL_MCI
67 static void sama5d3_xplained_mci0_hw_init(void)
68 {
69 	at91_mci_hw_init();
70 
71 	at91_set_pio_output(AT91_PIO_PORTE, 2, 0);	/* MCI0 Power */
72 }
73 #endif
74 
75 int board_early_init_f(void)
76 {
77 	at91_periph_clk_enable(ATMEL_ID_PIOA);
78 	at91_periph_clk_enable(ATMEL_ID_PIOB);
79 	at91_periph_clk_enable(ATMEL_ID_PIOC);
80 	at91_periph_clk_enable(ATMEL_ID_PIOD);
81 	at91_periph_clk_enable(ATMEL_ID_PIOE);
82 
83 	at91_seriald_hw_init();
84 
85 	return 0;
86 }
87 
88 int board_init(void)
89 {
90 	/* adress of boot parameters */
91 	gd->bd->bi_boot_params = CONFIG_SYS_SDRAM_BASE + 0x100;
92 
93 #ifdef CONFIG_NAND_ATMEL
94 	sama5d3_xplained_nand_hw_init();
95 #endif
96 #ifdef CONFIG_CMD_USB
97 	sama5d3_xplained_usb_hw_init();
98 #endif
99 #ifdef CONFIG_GENERIC_ATMEL_MCI
100 	sama5d3_xplained_mci0_hw_init();
101 #endif
102 #ifdef CONFIG_MACB
103 	at91_gmac_hw_init();
104 	at91_macb_hw_init();
105 #endif
106 	return 0;
107 }
108 
109 int dram_init(void)
110 {
111 	gd->ram_size = get_ram_size((void *)CONFIG_SYS_SDRAM_BASE,
112 				    CONFIG_SYS_SDRAM_SIZE);
113 
114 	return 0;
115 }
116 
117 int board_eth_init(bd_t *bis)
118 {
119 #ifdef CONFIG_MACB
120 	macb_eth_initialize(0, (void *)ATMEL_BASE_GMAC, 0x00);
121 	macb_eth_initialize(0, (void *)ATMEL_BASE_EMAC, 0x00);
122 #endif
123 	return 0;
124 }
125 
126 #ifdef CONFIG_GENERIC_ATMEL_MCI
127 int board_mmc_init(bd_t *bis)
128 {
129 	atmel_mci_init((void *)ATMEL_BASE_MCI0);
130 
131 	return 0;
132 }
133 #endif
134 
135 /* SPL */
136 #ifdef CONFIG_SPL_BUILD
137 void spl_board_init(void)
138 {
139 #ifdef CONFIG_SYS_USE_MMC
140 	sama5d3_xplained_mci0_hw_init();
141 #elif CONFIG_SYS_USE_NANDFLASH
142 	sama5d3_xplained_nand_hw_init();
143 #endif
144 }
145 
146 static void ddr2_conf(struct atmel_mpddrc_config *ddr2)
147 {
148 	ddr2->md = (ATMEL_MPDDRC_MD_DBW_32_BITS | ATMEL_MPDDRC_MD_DDR2_SDRAM);
149 
150 	ddr2->cr = (ATMEL_MPDDRC_CR_NC_COL_10 |
151 		    ATMEL_MPDDRC_CR_NR_ROW_14 |
152 		    ATMEL_MPDDRC_CR_CAS_DDR_CAS3 |
153 		    ATMEL_MPDDRC_CR_ENRDM_ON |
154 		    ATMEL_MPDDRC_CR_NB_8BANKS |
155 		    ATMEL_MPDDRC_CR_NDQS_DISABLED |
156 		    ATMEL_MPDDRC_CR_DECOD_INTERLEAVED |
157 		    ATMEL_MPDDRC_CR_UNAL_SUPPORTED);
158 	/*
159 	 * As the DDR2-SDRAm device requires a refresh time is 7.8125us
160 	 * when DDR run at 133MHz, so it needs (7.8125us * 133MHz / 10^9) clocks
161 	 */
162 	ddr2->rtr = 0x411;
163 
164 	ddr2->tpr0 = (6 << ATMEL_MPDDRC_TPR0_TRAS_OFFSET |
165 		      2 << ATMEL_MPDDRC_TPR0_TRCD_OFFSET |
166 		      2 << ATMEL_MPDDRC_TPR0_TWR_OFFSET |
167 		      8 << ATMEL_MPDDRC_TPR0_TRC_OFFSET |
168 		      2 << ATMEL_MPDDRC_TPR0_TRP_OFFSET |
169 		      2 << ATMEL_MPDDRC_TPR0_TRRD_OFFSET |
170 		      2 << ATMEL_MPDDRC_TPR0_TWTR_OFFSET |
171 		      2 << ATMEL_MPDDRC_TPR0_TMRD_OFFSET);
172 
173 	ddr2->tpr1 = (2 << ATMEL_MPDDRC_TPR1_TXP_OFFSET |
174 		      200 << ATMEL_MPDDRC_TPR1_TXSRD_OFFSET |
175 		      28 << ATMEL_MPDDRC_TPR1_TXSNR_OFFSET |
176 		      26 << ATMEL_MPDDRC_TPR1_TRFC_OFFSET);
177 
178 	ddr2->tpr2 = (7 << ATMEL_MPDDRC_TPR2_TFAW_OFFSET |
179 		      2 << ATMEL_MPDDRC_TPR2_TRTP_OFFSET |
180 		      2 << ATMEL_MPDDRC_TPR2_TRPA_OFFSET |
181 		      7 << ATMEL_MPDDRC_TPR2_TXARDS_OFFSET |
182 		      8 << ATMEL_MPDDRC_TPR2_TXARD_OFFSET);
183 }
184 
185 void mem_init(void)
186 {
187 	struct at91_pmc *pmc = (struct at91_pmc *)ATMEL_BASE_PMC;
188 	struct atmel_mpddrc_config ddr2;
189 
190 	ddr2_conf(&ddr2);
191 
192 	/* enable MPDDR clock */
193 	at91_periph_clk_enable(ATMEL_ID_MPDDRC);
194 	writel(AT91_PMC_DDR, &pmc->scer);
195 
196 	/* DDRAM2 Controller initialize */
197 	ddr2_init(ATMEL_BASE_MPDDRC, ATMEL_BASE_DDRCS, &ddr2);
198 }
199 
200 void at91_pmc_init(void)
201 {
202 	struct at91_pmc *pmc = (struct at91_pmc *)ATMEL_BASE_PMC;
203 	u32 tmp;
204 
205 	tmp = AT91_PMC_PLLAR_29 |
206 	      AT91_PMC_PLLXR_PLLCOUNT(0x3f) |
207 	      AT91_PMC_PLLXR_MUL(43) |
208 	      AT91_PMC_PLLXR_DIV(1);
209 	at91_plla_init(tmp);
210 
211 	writel(0x3 << 8, &pmc->pllicpr);
212 
213 	tmp = AT91_PMC_MCKR_MDIV_4 |
214 	      AT91_PMC_MCKR_CSS_PLLA;
215 	at91_mck_init(tmp);
216 }
217 #endif
218