1 // SPDX-License-Identifier: GPL-2.0+
2 /*
3  * (C) Copyright 2007-2008
4  * Stelian Pop <stelian@popies.net>
5  * Lead Tech Design <www.leadtechdesign.com>
6  */
7 
8 #include <common.h>
9 #include <debug_uart.h>
10 #include <asm/io.h>
11 #include <asm/arch/at91sam9260_matrix.h>
12 #include <asm/arch/at91sam9_smc.h>
13 #include <asm/arch/at91_common.h>
14 #include <asm/arch/clk.h>
15 #include <asm/arch/gpio.h>
16 
17 DECLARE_GLOBAL_DATA_PTR;
18 
19 /* ------------------------------------------------------------------------- */
20 /*
21  * Miscelaneous platform dependent initialisations
22  */
23 
24 #ifdef CONFIG_CMD_NAND
at91sam9260ek_nand_hw_init(void)25 static void at91sam9260ek_nand_hw_init(void)
26 {
27 	struct at91_smc *smc = (struct at91_smc *)ATMEL_BASE_SMC;
28 	struct at91_matrix *matrix = (struct at91_matrix *)ATMEL_BASE_MATRIX;
29 	unsigned long csa;
30 
31 	/* Assign CS3 to NAND/SmartMedia Interface */
32 	csa = readl(&matrix->ebicsa);
33 	csa |= AT91_MATRIX_CS3A_SMC_SMARTMEDIA;
34 	writel(csa, &matrix->ebicsa);
35 
36 	/* Configure SMC CS3 for NAND/SmartMedia */
37 	writel(AT91_SMC_SETUP_NWE(1) | AT91_SMC_SETUP_NCS_WR(0) |
38 		AT91_SMC_SETUP_NRD(1) | AT91_SMC_SETUP_NCS_RD(0),
39 		&smc->cs[3].setup);
40 	writel(AT91_SMC_PULSE_NWE(3) | AT91_SMC_PULSE_NCS_WR(3) |
41 		AT91_SMC_PULSE_NRD(3) | AT91_SMC_PULSE_NCS_RD(3),
42 		&smc->cs[3].pulse);
43 	writel(AT91_SMC_CYCLE_NWE(5) | AT91_SMC_CYCLE_NRD(5),
44 		&smc->cs[3].cycle);
45 	writel(AT91_SMC_MODE_RM_NRD | AT91_SMC_MODE_WM_NWE |
46 		AT91_SMC_MODE_EXNW_DISABLE |
47 #ifdef CONFIG_SYS_NAND_DBW_16
48 		AT91_SMC_MODE_DBW_16 |
49 #else /* CONFIG_SYS_NAND_DBW_8 */
50 		AT91_SMC_MODE_DBW_8 |
51 #endif
52 		AT91_SMC_MODE_TDF_CYCLE(2),
53 		&smc->cs[3].mode);
54 
55 	/* Configure RDY/BSY */
56 	at91_set_gpio_input(CONFIG_SYS_NAND_READY_PIN, 1);
57 
58 	/* Enable NandFlash */
59 	at91_set_gpio_output(CONFIG_SYS_NAND_ENABLE_PIN, 1);
60 
61 }
62 #endif
63 
64 #ifdef CONFIG_DEBUG_UART_BOARD_INIT
board_debug_uart_init(void)65 void board_debug_uart_init(void)
66 {
67 	at91_seriald_hw_init();
68 }
69 #endif
70 
71 #ifdef CONFIG_BOARD_EARLY_INIT_F
board_early_init_f(void)72 int board_early_init_f(void)
73 {
74 #ifdef CONFIG_DEBUG_UART
75 	debug_uart_init();
76 #endif
77 	return 0;
78 }
79 #endif
80 
board_init(void)81 int board_init(void)
82 {
83 	/* adress of boot parameters */
84 	gd->bd->bi_boot_params = CONFIG_SYS_SDRAM_BASE + 0x100;
85 
86 #ifdef CONFIG_CMD_NAND
87 	at91sam9260ek_nand_hw_init();
88 #endif
89 	return 0;
90 }
91 
dram_init(void)92 int dram_init(void)
93 {
94 	gd->ram_size = get_ram_size(
95 		(void *)CONFIG_SYS_SDRAM_BASE,
96 		CONFIG_SYS_SDRAM_SIZE);
97 	return 0;
98 }
99 
100 #ifdef CONFIG_RESET_PHY_R
reset_phy(void)101 void reset_phy(void)
102 {
103 }
104 #endif
105