1 /* 2 * Copyright (C) 2008-2013 Eric Jarrige <eric.jarrige@armadeus.org> 3 * 4 * based on the files by 5 * Sascha Hauer, Pengutronix 6 * 7 * SPDX-License-Identifier: GPL-2.0+ 8 */ 9 10 #include <common.h> 11 #include <environment.h> 12 #include <jffs2/jffs2.h> 13 #include <nand.h> 14 #include <netdev.h> 15 #include <asm/io.h> 16 #include <asm/arch/imx-regs.h> 17 #include <asm/arch/gpio.h> 18 #include <asm/gpio.h> 19 #include <asm/errno.h> 20 #include "apf27.h" 21 #include "crc.h" 22 #include "fpga.h" 23 24 DECLARE_GLOBAL_DATA_PTR; 25 26 /* 27 * Fuse bank 1 row 8 is "reserved for future use" and therefore available for 28 * customer use. The APF27 board uses this fuse to store the board revision: 29 * 0: initial board revision 30 * 1: first revision - Presence of the second RAM chip on the board is blown in 31 * fuse bank 1 row 9 bit 0 - No hardware change 32 * N: to be defined 33 */ 34 static u32 get_board_rev(void) 35 { 36 struct iim_regs *iim = (struct iim_regs *)IMX_IIM_BASE; 37 38 return readl(&iim->bank[1].fuse_regs[8]); 39 } 40 41 /* 42 * Fuse bank 1 row 9 is "reserved for future use" and therefore available for 43 * customer use. The APF27 board revision 1 uses the bit 0 to permanently store 44 * the presence of the second RAM chip 45 * 0: AFP27 with 1 RAM of 64 MiB 46 * 1: AFP27 with 2 RAM chips of 64 MiB each (128MB) 47 */ 48 static int get_num_ram_bank(void) 49 { 50 struct iim_regs *iim = (struct iim_regs *)IMX_IIM_BASE; 51 int nr_dram_banks = 1; 52 53 if ((get_board_rev() > 0) && (CONFIG_NR_DRAM_BANKS > 1)) 54 nr_dram_banks += readl(&iim->bank[1].fuse_regs[9]) & 0x01; 55 else 56 nr_dram_banks = CONFIG_NR_DRAM_POPULATED; 57 58 return nr_dram_banks; 59 } 60 61 static void apf27_port_init(int port, u32 gpio_dr, u32 ocr1, u32 ocr2, 62 u32 iconfa1, u32 iconfa2, u32 iconfb1, u32 iconfb2, 63 u32 icr1, u32 icr2, u32 imr, u32 gpio_dir, u32 gpr, 64 u32 puen, u32 gius) 65 { 66 struct gpio_port_regs *regs = (struct gpio_port_regs *)IMX_GPIO_BASE; 67 68 writel(gpio_dr, ®s->port[port].gpio_dr); 69 writel(ocr1, ®s->port[port].ocr1); 70 writel(ocr2, ®s->port[port].ocr2); 71 writel(iconfa1, ®s->port[port].iconfa1); 72 writel(iconfa2, ®s->port[port].iconfa2); 73 writel(iconfb1, ®s->port[port].iconfb1); 74 writel(iconfb2, ®s->port[port].iconfb2); 75 writel(icr1, ®s->port[port].icr1); 76 writel(icr2, ®s->port[port].icr2); 77 writel(imr, ®s->port[port].imr); 78 writel(gpio_dir, ®s->port[port].gpio_dir); 79 writel(gpr, ®s->port[port].gpr); 80 writel(puen, ®s->port[port].puen); 81 writel(gius, ®s->port[port].gius); 82 } 83 84 #define APF27_PORT_INIT(n) apf27_port_init(PORT##n, ACFG_DR_##n##_VAL, \ 85 ACFG_OCR1_##n##_VAL, ACFG_OCR2_##n##_VAL, ACFG_ICFA1_##n##_VAL, \ 86 ACFG_ICFA2_##n##_VAL, ACFG_ICFB1_##n##_VAL, ACFG_ICFB2_##n##_VAL, \ 87 ACFG_ICR1_##n##_VAL, ACFG_ICR2_##n##_VAL, ACFG_IMR_##n##_VAL, \ 88 ACFG_DDIR_##n##_VAL, ACFG_GPR_##n##_VAL, ACFG_PUEN_##n##_VAL, \ 89 ACFG_GIUS_##n##_VAL) 90 91 static void apf27_iomux_init(void) 92 { 93 APF27_PORT_INIT(A); 94 APF27_PORT_INIT(B); 95 APF27_PORT_INIT(C); 96 APF27_PORT_INIT(D); 97 APF27_PORT_INIT(E); 98 APF27_PORT_INIT(F); 99 } 100 101 static int apf27_devices_init(void) 102 { 103 int i; 104 unsigned int mode[] = { 105 PC5_PF_I2C2_DATA, 106 PC6_PF_I2C2_CLK, 107 PD17_PF_I2C_DATA, 108 PD18_PF_I2C_CLK, 109 }; 110 111 for (i = 0; i < ARRAY_SIZE(mode); i++) 112 imx_gpio_mode(mode[i]); 113 114 #ifdef CONFIG_MXC_UART 115 mx27_uart1_init_pins(); 116 #endif 117 118 #ifdef CONFIG_FEC_MXC 119 mx27_fec_init_pins(); 120 #endif 121 122 #ifdef CONFIG_MXC_MMC 123 mx27_sd2_init_pins(); 124 imx_gpio_mode((GPIO_PORTF | GPIO_OUT | GPIO_PUEN | GPIO_GPIO | 16)); 125 gpio_request(PC_PWRON, "pc_pwron"); 126 gpio_set_value(PC_PWRON, 1); 127 #endif 128 return 0; 129 } 130 131 static void apf27_setup_csx(void) 132 { 133 struct weim_regs *weim = (struct weim_regs *)IMX_WEIM_BASE; 134 135 writel(ACFG_CS0U_VAL, &weim->cs0u); 136 writel(ACFG_CS0L_VAL, &weim->cs0l); 137 writel(ACFG_CS0A_VAL, &weim->cs0a); 138 139 writel(ACFG_CS1U_VAL, &weim->cs1u); 140 writel(ACFG_CS1L_VAL, &weim->cs1l); 141 writel(ACFG_CS1A_VAL, &weim->cs1a); 142 143 writel(ACFG_CS2U_VAL, &weim->cs2u); 144 writel(ACFG_CS2L_VAL, &weim->cs2l); 145 writel(ACFG_CS2A_VAL, &weim->cs2a); 146 147 writel(ACFG_CS3U_VAL, &weim->cs3u); 148 writel(ACFG_CS3L_VAL, &weim->cs3l); 149 writel(ACFG_CS3A_VAL, &weim->cs3a); 150 151 writel(ACFG_CS4U_VAL, &weim->cs4u); 152 writel(ACFG_CS4L_VAL, &weim->cs4l); 153 writel(ACFG_CS4A_VAL, &weim->cs4a); 154 155 writel(ACFG_CS5U_VAL, &weim->cs5u); 156 writel(ACFG_CS5L_VAL, &weim->cs5l); 157 writel(ACFG_CS5A_VAL, &weim->cs5a); 158 159 writel(ACFG_EIM_VAL, &weim->eim); 160 } 161 162 static void apf27_setup_port(void) 163 { 164 struct system_control_regs *system = 165 (struct system_control_regs *)IMX_SYSTEM_CTL_BASE; 166 167 writel(ACFG_FMCR_VAL, &system->fmcr); 168 } 169 170 int board_init(void) 171 { 172 gd->bd->bi_boot_params = PHYS_SDRAM_1 + 0x100; 173 174 apf27_setup_csx(); 175 apf27_setup_port(); 176 apf27_iomux_init(); 177 apf27_devices_init(); 178 #if defined(CONFIG_FPGA) 179 APF27_init_fpga(); 180 #endif 181 182 183 return 0; 184 } 185 186 int dram_init(void) 187 { 188 gd->ram_size = get_ram_size((void *)PHYS_SDRAM_1, PHYS_SDRAM_1_SIZE); 189 if (get_num_ram_bank() > 1) 190 gd->ram_size += get_ram_size((void *)PHYS_SDRAM_2, 191 PHYS_SDRAM_2_SIZE); 192 193 return 0; 194 } 195 196 void dram_init_banksize(void) 197 { 198 gd->bd->bi_dram[0].start = PHYS_SDRAM_1; 199 gd->bd->bi_dram[0].size = get_ram_size((void *)PHYS_SDRAM_1, 200 PHYS_SDRAM_1_SIZE); 201 gd->bd->bi_dram[1].start = PHYS_SDRAM_2; 202 if (get_num_ram_bank() > 1) 203 gd->bd->bi_dram[1].size = get_ram_size((void *)PHYS_SDRAM_2, 204 PHYS_SDRAM_2_SIZE); 205 else 206 gd->bd->bi_dram[1].size = 0; 207 } 208 209 ulong board_get_usable_ram_top(ulong total_size) 210 { 211 ulong ramtop; 212 213 if (get_num_ram_bank() > 1) 214 ramtop = PHYS_SDRAM_2 + get_ram_size((void *)PHYS_SDRAM_2, 215 PHYS_SDRAM_2_SIZE); 216 else 217 ramtop = PHYS_SDRAM_1 + get_ram_size((void *)PHYS_SDRAM_1, 218 PHYS_SDRAM_1_SIZE); 219 220 return ramtop; 221 } 222 223 int checkboard(void) 224 { 225 printf("Board: Armadeus APF27 revision %d\n", get_board_rev()); 226 return 0; 227 } 228 229 #ifdef CONFIG_SPL_BUILD 230 inline void hang(void) 231 { 232 for (;;) 233 ; 234 } 235 236 void board_init_f(ulong bootflag) 237 { 238 /* 239 * copy ourselves from where we are running to where we were 240 * linked at. Use ulong pointers as all addresses involved 241 * are 4-byte-aligned. 242 */ 243 ulong *start_ptr, *end_ptr, *link_ptr, *run_ptr, *dst; 244 asm volatile ("ldr %0, =_start" : "=r"(start_ptr)); 245 asm volatile ("ldr %0, =_end" : "=r"(end_ptr)); 246 asm volatile ("ldr %0, =board_init_f" : "=r"(link_ptr)); 247 asm volatile ("adr %0, board_init_f" : "=r"(run_ptr)); 248 for (dst = start_ptr; dst < end_ptr; dst++) 249 *dst = *(dst+(run_ptr-link_ptr)); 250 251 /* 252 * branch to nand_boot's link-time address. 253 */ 254 asm volatile("ldr pc, =nand_boot"); 255 } 256 #endif /* CONFIG_SPL_BUILD */ 257