1 2 /* 3 * (C) Copyright 2002 4 * Daniel Engström, Omicron Ceti AB, daniel@omicron.se 5 * 6 * SPDX-License-Identifier: GPL-2.0+ 7 */ 8 9 #ifndef _PCI_I386_H_ 10 #define _PCI_I386_H_ 11 12 #define DEFINE_PCI_DEVICE_TABLE(_table) \ 13 const struct pci_device_id _table[] 14 15 struct pci_controller; 16 17 void pci_setup_type1(struct pci_controller *hose); 18 19 /** 20 * board_pci_setup_hose() - Set up the PCI hose 21 * 22 * This is called by the common x86 PCI code to set up the PCI controller 23 * hose. It may be called when no memory/BSS is available so should just 24 * store things in 'hose' and not in BSS variables. 25 */ 26 void board_pci_setup_hose(struct pci_controller *hose); 27 28 /** 29 * pci_early_init_hose() - Set up PCI host before relocation 30 * 31 * This allocates memory for, sets up and returns the PCI hose. It can be 32 * called before relocation. The hose will be stored in gd->arch.hose for 33 * later use, but will become invalid one DRAM is available. 34 */ 35 int pci_early_init_hose(struct pci_controller **hosep); 36 37 int board_pci_pre_scan(struct pci_controller *hose); 38 int board_pci_post_scan(struct pci_controller *hose); 39 40 /* 41 * Simple PCI access routines - these work from either the early PCI hose 42 * or the 'real' one, created after U-Boot has memory available 43 */ 44 unsigned int pci_read_config8(pci_dev_t dev, unsigned where); 45 unsigned int pci_read_config16(pci_dev_t dev, unsigned where); 46 unsigned int pci_read_config32(pci_dev_t dev, unsigned where); 47 48 void pci_write_config8(pci_dev_t dev, unsigned where, unsigned value); 49 void pci_write_config16(pci_dev_t dev, unsigned where, unsigned value); 50 void pci_write_config32(pci_dev_t dev, unsigned where, unsigned value); 51 52 #endif 53