1if ARCH_UNIPHIER 2 3config SYS_CONFIG_NAME 4 default "uniphier" 5 6config UNIPHIER_SMP 7 bool 8 9choice 10 prompt "UniPhier SoC select" 11 default MACH_PH1_PRO4 12 13config MACH_PH1_PRO4 14 bool "PH1-Pro4" 15 select UNIPHIER_SMP 16 17config MACH_PH1_LD4 18 bool "PH1-LD4" 19 20config MACH_PH1_SLD8 21 bool "PH1-sLD8" 22 23endchoice 24 25choice 26 prompt "UniPhier Support Card select" 27 optional 28 29config PFC_MICRO_SUPPORT_CARD 30 bool "Support card with PFC CPLD" 31 help 32 This option provides support for the expansion board with PFC 33 original address mapping. 34 35 Say Y to use the on-board UART, Ether, LED devices. 36 37config DCC_MICRO_SUPPORT_CARD 38 bool "Support card with DCC CPLD" 39 help 40 This option provides support for the expansion board with DCC- 41 arranged address mapping that is compatible with legacy UniPhier 42 reference boards. 43 44 Say Y to use the on-board UART, Ether, LED devices. 45 46endchoice 47 48config CMD_PINMON 49 bool "Enable boot mode pins monitor command" 50 default y 51 help 52 The command "pinmon" shows the state of the boot mode pins. 53 The boot mode pins are latched when the system reset is deasserted 54 and determine which device the system should load a boot image from. 55 56config CMD_DDRPHY_DUMP 57 bool "Enable dump command of DDR PHY parameters" 58 help 59 The command "ddrphy" shows the resulting parameters of DDR PHY 60 training; it is useful for the evaluation of DDR PHY training. 61 62choice 63 prompt "DDR3 Frequency select" 64 65config DDR_FREQ_1600 66 bool "DDR3 1600" 67 depends on MACH_PH1_PRO4 || MACH_PH1_LD4 68 69config DDR_FREQ_1333 70 bool "DDR3 1333" 71 depends on MACH_PH1_LD4 || MACH_PH1_SLD8 72 73endchoice 74 75config DDR_FREQ 76 int 77 default 1333 if DDR_FREQ_1333 78 default 1600 if DDR_FREQ_1600 79 80endif 81