1menu "Panasonic UniPhier platform" 2 depends on ARCH_UNIPHIER 3 4config SYS_CONFIG_NAME 5 default "uniphier" 6 7config UNIPHIER_SMP 8 bool 9 10choice 11 prompt "UniPhier SoC select" 12 13config MACH_PH1_PRO4 14 bool "PH1-Pro4" 15 select UNIPHIER_SMP 16 17config MACH_PH1_LD4 18 bool "PH1-LD4" 19 20config MACH_PH1_SLD8 21 bool "PH1-sLD8" 22 23endchoice 24 25choice 26 prompt "UniPhier Support Card select" 27 optional 28 29config PFC_MICRO_SUPPORT_CARD 30 bool "Support card with PFC CPLD" 31 help 32 This option provides support for the expansion board with PFC 33 original address mapping. 34 35 Say Y to use the on-board UART, Ether, LED devices. 36 37config DCC_MICRO_SUPPORT_CARD 38 bool "Support card with DCC CPLD" 39 help 40 This option provides support for the expansion board with DCC- 41 arranged address mapping that is compatible with legacy UniPhier 42 reference boards. 43 44 Say Y to use the on-board UART, Ether, LED devices. 45 46endchoice 47 48config SYS_MALLOC_F 49 default y 50 51config CMD_PINMON 52 bool "Enable boot mode pins monitor command" 53 default y 54 help 55 The command "pinmon" shows the state of the boot mode pins. 56 The boot mode pins are latched when the system reset is deasserted 57 and determine which device the system should load a boot image from. 58 59config CMD_DDRPHY_DUMP 60 bool "Enable dump command of DDR PHY parameters" 61 help 62 The command "ddrphy" shows the resulting parameters of DDR PHY 63 training; it is useful for the evaluation of DDR PHY training. 64 65choice 66 prompt "DDR3 Frequency select" 67 68config DDR_FREQ_1600 69 bool "DDR3 1600" 70 depends on MACH_PH1_PRO4 || MACH_PH1_LD4 71 72config DDR_FREQ_1333 73 bool "DDR3 1333" 74 depends on MACH_PH1_LD4 || MACH_PH1_SLD8 75 76endchoice 77 78config DDR_FREQ 79 int 80 default 1333 if DDR_FREQ_1333 81 default 1600 if DDR_FREQ_1600 82 83endmenu 84