1menu "Panasonic UniPhier platform" 2 depends on ARCH_UNIPHIER 3 4config SYS_CONFIG_NAME 5 default "uniphier" 6 7config UNIPHIER_SMP 8 bool 9 10choice 11 prompt "UniPhier SoC select" 12 optional 13 14config MACH_PH1_PRO4 15 bool "PH1-Pro4" 16 select UNIPHIER_SMP 17 18config MACH_PH1_LD4 19 bool "PH1-LD4" 20 21config MACH_PH1_SLD8 22 bool "PH1-sLD8" 23 24endchoice 25 26choice 27 prompt "UniPhier Support Card select" 28 optional 29 30config PFC_MICRO_SUPPORT_CARD 31 bool "Support card with PFC CPLD" 32 help 33 This option provides support for the expansion board with PFC 34 original address mapping. 35 36 Say Y to use the on-board UART, Ether, LED devices. 37 38config DCC_MICRO_SUPPORT_CARD 39 bool "Support card with DCC CPLD" 40 help 41 This option provides support for the expansion board with DCC- 42 arranged address mapping that is compatible with legacy UniPhier 43 reference boards. 44 45 Say Y to use the on-board UART, Ether, LED devices. 46 47endchoice 48 49config CMD_PINMON 50 bool "Enable boot mode pins monitor command" 51 default y 52 help 53 The command "pinmon" shows the state of the boot mode pins. 54 The boot mode pins are latched when the system reset is deasserted 55 and determine which device the system should load a boot image from. 56 57config CMD_DDRPHY_DUMP 58 bool "Enable dump command of DDR PHY parameters" 59 help 60 The command "ddrphy" shows the resulting parameters of DDR PHY 61 training; it is useful for the evaluation of DDR PHY training. 62 63choice 64 prompt "DDR3 Frequency select" 65 66config DDR_FREQ_1600 67 bool "DDR3 1600" 68 depends on MACH_PH1_PRO4 || MACH_PH1_LD4 69 70config DDR_FREQ_1333 71 bool "DDR3 1333" 72 depends on MACH_PH1_LD4 || MACH_PH1_SLD8 73 74endchoice 75 76config DDR_FREQ 77 int 78 default 1333 if DDR_FREQ_1333 79 default 1600 if DDR_FREQ_1600 80 81endmenu 82