1menu "Panasonic UniPhier platform" 2 depends on ARCH_UNIPHIER 3 4config SYS_SOC 5 default "uniphier" 6 7config SYS_CONFIG_NAME 8 default "uniphier" 9 10config UNIPHIER_SMP 11 bool 12 13choice 14 prompt "UniPhier SoC select" 15 16config MACH_PH1_PRO4 17 bool "PH1-Pro4" 18 select UNIPHIER_SMP 19 20config MACH_PH1_LD4 21 bool "PH1-LD4" 22 23config MACH_PH1_SLD8 24 bool "PH1-sLD8" 25 26endchoice 27 28choice 29 prompt "UniPhier Support Card select" 30 optional 31 32config PFC_MICRO_SUPPORT_CARD 33 bool "Support card with PFC CPLD" 34 help 35 This option provides support for the expansion board with PFC 36 original address mapping. 37 38 Say Y to use the on-board UART, Ether, LED devices. 39 40config DCC_MICRO_SUPPORT_CARD 41 bool "Support card with DCC CPLD" 42 help 43 This option provides support for the expansion board with DCC- 44 arranged address mapping that is compatible with legacy UniPhier 45 reference boards. 46 47 Say Y to use the on-board UART, Ether, LED devices. 48 49endchoice 50 51config SYS_MALLOC_F 52 default y 53 54config SYS_MALLOC_F_LEN 55 default 0x400 56 57config CMD_PINMON 58 bool "Enable boot mode pins monitor command" 59 default y 60 help 61 The command "pinmon" shows the state of the boot mode pins. 62 The boot mode pins are latched when the system reset is deasserted 63 and determine which device the system should load a boot image from. 64 65config CMD_DDRPHY_DUMP 66 bool "Enable dump command of DDR PHY parameters" 67 help 68 The command "ddrphy" shows the resulting parameters of DDR PHY 69 training; it is useful for the evaluation of DDR PHY training. 70 71choice 72 prompt "DDR3 Frequency select" 73 74config DDR_FREQ_1600 75 bool "DDR3 1600" 76 depends on MACH_PH1_PRO4 || MACH_PH1_LD4 77 78config DDR_FREQ_1333 79 bool "DDR3 1333" 80 depends on MACH_PH1_LD4 || MACH_PH1_SLD8 81 82endchoice 83 84config DDR_FREQ 85 int 86 default 1333 if DDR_FREQ_1333 87 default 1600 if DDR_FREQ_1600 88 89endmenu 90