1 // SPDX-License-Identifier: GPL-2.0+ 2 /* 3 * Copyright (C) 2012 Altera Corporation <www.altera.com> 4 */ 5 6 #include <common.h> 7 #include <asm/io.h> 8 #include <asm/pl310.h> 9 #include <asm/u-boot.h> 10 #include <asm/utils.h> 11 #include <image.h> 12 #include <asm/arch/reset_manager.h> 13 #include <spl.h> 14 #include <asm/arch/system_manager.h> 15 #include <asm/arch/freeze_controller.h> 16 #include <asm/arch/clock_manager.h> 17 #include <asm/arch/scan_manager.h> 18 #include <asm/arch/sdram.h> 19 #include <asm/arch/scu.h> 20 #include <asm/arch/misc.h> 21 #include <asm/arch/nic301.h> 22 #include <asm/sections.h> 23 #include <fdtdec.h> 24 #include <watchdog.h> 25 #include <asm/arch/pinmux.h> 26 27 DECLARE_GLOBAL_DATA_PTR; 28 29 static const struct socfpga_system_manager *sysmgr_regs = 30 (struct socfpga_system_manager *)SOCFPGA_SYSMGR_ADDRESS; 31 32 u32 spl_boot_device(void) 33 { 34 const u32 bsel = readl(&sysmgr_regs->bootinfo); 35 36 switch (SYSMGR_GET_BOOTINFO_BSEL(bsel)) { 37 case 0x1: /* FPGA (HPS2FPGA Bridge) */ 38 return BOOT_DEVICE_RAM; 39 case 0x2: /* NAND Flash (1.8V) */ 40 case 0x3: /* NAND Flash (3.0V) */ 41 socfpga_per_reset(SOCFPGA_RESET(NAND), 0); 42 return BOOT_DEVICE_NAND; 43 case 0x4: /* SD/MMC External Transceiver (1.8V) */ 44 case 0x5: /* SD/MMC Internal Transceiver (3.0V) */ 45 socfpga_per_reset(SOCFPGA_RESET(SDMMC), 0); 46 socfpga_per_reset(SOCFPGA_RESET(DMA), 0); 47 return BOOT_DEVICE_MMC1; 48 case 0x6: /* QSPI Flash (1.8V) */ 49 case 0x7: /* QSPI Flash (3.0V) */ 50 socfpga_per_reset(SOCFPGA_RESET(QSPI), 0); 51 return BOOT_DEVICE_SPI; 52 default: 53 printf("Invalid boot device (bsel=%08x)!\n", bsel); 54 hang(); 55 } 56 } 57 58 #ifdef CONFIG_SPL_MMC_SUPPORT 59 u32 spl_boot_mode(const u32 boot_device) 60 { 61 #if defined(CONFIG_SPL_FAT_SUPPORT) || defined(CONFIG_SPL_EXT_SUPPORT) 62 return MMCSD_MODE_FS; 63 #else 64 return MMCSD_MODE_RAW; 65 #endif 66 } 67 #endif 68 69 void spl_board_init(void) 70 { 71 /* configuring the clock based on handoff */ 72 cm_basic_init(gd->fdt_blob); 73 WATCHDOG_RESET(); 74 75 config_dedicated_pins(gd->fdt_blob); 76 WATCHDOG_RESET(); 77 78 /* enable console uart printing */ 79 preloader_console_init(); 80 81 WATCHDOG_RESET(); 82 83 /* Add device descriptor to FPGA device table */ 84 socfpga_fpga_add(); 85 } 86 87 void board_init_f(ulong dummy) 88 { 89 /* 90 * Configure Clock Manager to use intosc clock instead external osc to 91 * ensure success watchdog operation. We do it as early as possible. 92 */ 93 cm_use_intosc(); 94 95 socfpga_watchdog_disable(); 96 97 arch_early_init_r(); 98 99 #ifdef CONFIG_HW_WATCHDOG 100 /* release osc1 watchdog timer 0 from reset */ 101 socfpga_reset_deassert_osc1wd0(); 102 103 /* reconfigure and enable the watchdog */ 104 hw_watchdog_init(); 105 WATCHDOG_RESET(); 106 #endif /* CONFIG_HW_WATCHDOG */ 107 } 108