1 /* 2 * (C) Copyright 2011 3 * Texas Instruments, <www.ti.com> 4 * 5 * Author : 6 * Tom Rini <trini@ti.com> 7 * 8 * Initial Code from: 9 * Richard Woodruff <r-woodruff2@ti.com> 10 * Jian Zhang <jzhang@ti.com> 11 * 12 * SPDX-License-Identifier: GPL-2.0+ 13 */ 14 15 #include <common.h> 16 #include <jffs2/load_kernel.h> 17 #include <linux/mtd/rawnand.h> 18 #include <linux/mtd/omap_gpmc.h> 19 #include <asm/io.h> 20 #include <asm/arch/sys_proto.h> 21 #include <asm/arch/mem.h> 22 23 /* 24 * Many boards will want to know the results of the NAND_CMD_READID command 25 * in order to decide what to do about DDR initialization. This function 26 * allows us to do that very early and to pass those results back to the 27 * board so it can make whatever decisions need to be made. 28 */ 29 int identify_nand_chip(int *mfr, int *id) 30 { 31 int loops = 1000; 32 33 /* Make sure that we have setup GPMC for NAND correctly. */ 34 set_gpmc_cs0(MTD_DEV_TYPE_NAND); 35 36 sdelay(2000); 37 38 /* Issue a RESET and then READID */ 39 writeb(NAND_CMD_RESET, &gpmc_cfg->cs[0].nand_cmd); 40 writeb(NAND_CMD_STATUS, &gpmc_cfg->cs[0].nand_cmd); 41 while ((readl(&gpmc_cfg->cs[0].nand_dat) & NAND_STATUS_READY) 42 != NAND_STATUS_READY) { 43 sdelay(100); 44 if (--loops == 0) 45 return 1; 46 } 47 writeb(NAND_CMD_READID, &gpmc_cfg->cs[0].nand_cmd); 48 49 /* Set the address to read to 0x0 */ 50 writeb(0x0, &gpmc_cfg->cs[0].nand_adr); 51 52 /* Read off the manufacturer and device id. */ 53 *mfr = readb(&gpmc_cfg->cs[0].nand_dat); 54 *id = readb(&gpmc_cfg->cs[0].nand_dat); 55 56 return 0; 57 } 58