1 /* 2 * (C) Copyright 2009 3 * Marvell Semiconductor <www.marvell.com> 4 * Written-by: Prafulla Wadaskar <prafulla@marvell.com> 5 * 6 * SPDX-License-Identifier: GPL-2.0+ 7 */ 8 9 #ifndef _MVEBU_CPU_H 10 #define _MVEBU_CPU_H 11 12 #include <asm/system.h> 13 14 #ifndef __ASSEMBLY__ 15 16 #define MVEBU_REG_PCIE_DEVID (MVEBU_REG_PCIE_BASE + 0x00) 17 #define MVEBU_REG_PCIE_REVID (MVEBU_REG_PCIE_BASE + 0x08) 18 19 enum memory_bank { 20 BANK0, 21 BANK1, 22 BANK2, 23 BANK3 24 }; 25 26 enum cpu_winen { 27 CPU_WIN_DISABLE, 28 CPU_WIN_ENABLE 29 }; 30 31 enum cpu_target { 32 CPU_TARGET_DRAM = 0x0, 33 CPU_TARGET_DEVICEBUS_BOOTROM_SPI = 0x1, 34 CPU_TARGET_ETH23 = 0x3, 35 CPU_TARGET_PCIE02 = 0x4, 36 CPU_TARGET_ETH01 = 0x7, 37 CPU_TARGET_PCIE13 = 0x8, 38 CPU_TARGET_SASRAM = 0x9, 39 CPU_TARGET_NAND = 0xd, 40 }; 41 42 enum cpu_attrib { 43 CPU_ATTR_SASRAM = 0x01, 44 CPU_ATTR_DRAM_CS0 = 0x0e, 45 CPU_ATTR_DRAM_CS1 = 0x0d, 46 CPU_ATTR_DRAM_CS2 = 0x0b, 47 CPU_ATTR_DRAM_CS3 = 0x07, 48 CPU_ATTR_NANDFLASH = 0x2f, 49 CPU_ATTR_SPIFLASH = 0x1e, 50 CPU_ATTR_BOOTROM = 0x1d, 51 CPU_ATTR_PCIE_IO = 0xe0, 52 CPU_ATTR_PCIE_MEM = 0xe8, 53 CPU_ATTR_DEV_CS0 = 0x3e, 54 CPU_ATTR_DEV_CS1 = 0x3d, 55 CPU_ATTR_DEV_CS2 = 0x3b, 56 CPU_ATTR_DEV_CS3 = 0x37, 57 }; 58 59 enum { 60 MVEBU_SOC_AXP, 61 MVEBU_SOC_A38X, 62 MVEBU_SOC_UNKNOWN, 63 }; 64 65 /* 66 * Default Device Address MAP BAR values 67 */ 68 #define DEFADR_PCI_MEM 0x90000000 69 #define DEFADR_PCI_IO 0xC0000000 70 #define DEFADR_SPIF 0xF4000000 71 #define DEFADR_BOOTROM 0xF8000000 72 73 struct mbus_win { 74 u32 base; 75 u32 size; 76 u8 target; 77 u8 attr; 78 }; 79 80 /* 81 * System registers 82 * Ref: Datasheet sec:A.28 83 */ 84 struct mvebu_system_registers { 85 u8 pad1[0x60]; 86 u32 rstoutn_mask; /* 0x60 */ 87 u32 sys_soft_rst; /* 0x64 */ 88 }; 89 90 /* 91 * GPIO Registers 92 * Ref: Datasheet sec:A.19 93 */ 94 struct kwgpio_registers { 95 u32 dout; 96 u32 oe; 97 u32 blink_en; 98 u32 din_pol; 99 u32 din; 100 u32 irq_cause; 101 u32 irq_mask; 102 u32 irq_level; 103 }; 104 105 /* Needed for dynamic (board-specific) mbus configuration */ 106 extern struct mvebu_mbus_state mbus_state; 107 108 /* 109 * functions 110 */ 111 unsigned int mvebu_sdram_bar(enum memory_bank bank); 112 unsigned int mvebu_sdram_bs(enum memory_bank bank); 113 void mvebu_sdram_size_adjust(enum memory_bank bank); 114 int mvebu_mbus_probe(struct mbus_win windows[], int count); 115 int mvebu_soc_family(void); 116 117 int mv_sdh_init(unsigned long regbase, u32 max_clk, u32 min_clk, u32 quirks); 118 119 /* 120 * Highspeed SERDES PHY config init, ported from bin_hdr 121 * to mainline U-Boot 122 */ 123 int serdes_phy_config(void); 124 125 /* 126 * DDR3 init / training code ported from Marvell bin_hdr. Now 127 * available in mainline U-Boot in: 128 * drivers/ddr/marvell 129 */ 130 int ddr3_init(void); 131 #endif /* __ASSEMBLY__ */ 132 #endif /* _MVEBU_CPU_H */ 133