xref: /openbmc/u-boot/arch/arm/mach-k3/am6_init.c (revision cbd2fba1)
1 // SPDX-License-Identifier: GPL-2.0+
2 /*
3  * K3: Architecture initialization
4  *
5  * Copyright (C) 2017-2018 Texas Instruments Incorporated - http://www.ti.com/
6  *	Lokesh Vutla <lokeshvutla@ti.com>
7  */
8 
9 #include <common.h>
10 #include <asm/io.h>
11 #include <spl.h>
12 #include <asm/arch/hardware.h>
13 #include "common.h"
14 #include <dm.h>
15 
16 #ifdef CONFIG_SPL_BUILD
17 static void mmr_unlock(u32 base, u32 partition)
18 {
19 	/* Translate the base address */
20 	phys_addr_t part_base = base + partition * CTRL_MMR0_PARTITION_SIZE;
21 
22 	/* Unlock the requested partition if locked using two-step sequence */
23 	writel(CTRLMMR_LOCK_KICK0_UNLOCK_VAL, part_base + CTRLMMR_LOCK_KICK0);
24 	writel(CTRLMMR_LOCK_KICK1_UNLOCK_VAL, part_base + CTRLMMR_LOCK_KICK1);
25 }
26 
27 static void ctrl_mmr_unlock(void)
28 {
29 	/* Unlock all WKUP_CTRL_MMR0 module registers */
30 	mmr_unlock(WKUP_CTRL_MMR0_BASE, 0);
31 	mmr_unlock(WKUP_CTRL_MMR0_BASE, 1);
32 	mmr_unlock(WKUP_CTRL_MMR0_BASE, 2);
33 	mmr_unlock(WKUP_CTRL_MMR0_BASE, 3);
34 	mmr_unlock(WKUP_CTRL_MMR0_BASE, 6);
35 	mmr_unlock(WKUP_CTRL_MMR0_BASE, 7);
36 
37 	/* Unlock all MCU_CTRL_MMR0 module registers */
38 	mmr_unlock(MCU_CTRL_MMR0_BASE, 0);
39 	mmr_unlock(MCU_CTRL_MMR0_BASE, 1);
40 	mmr_unlock(MCU_CTRL_MMR0_BASE, 2);
41 	mmr_unlock(MCU_CTRL_MMR0_BASE, 6);
42 
43 	/* Unlock all CTRL_MMR0 module registers */
44 	mmr_unlock(CTRL_MMR0_BASE, 0);
45 	mmr_unlock(CTRL_MMR0_BASE, 1);
46 	mmr_unlock(CTRL_MMR0_BASE, 2);
47 	mmr_unlock(CTRL_MMR0_BASE, 3);
48 	mmr_unlock(CTRL_MMR0_BASE, 6);
49 	mmr_unlock(CTRL_MMR0_BASE, 7);
50 }
51 
52 static void store_boot_index_from_rom(void)
53 {
54 	u32 *boot_index = (u32 *)K3_BOOT_PARAM_TABLE_INDEX_VAL;
55 
56 	*boot_index = *(u32 *)(CONFIG_SYS_K3_BOOT_PARAM_TABLE_INDEX);
57 }
58 
59 void board_init_f(ulong dummy)
60 {
61 #if defined(CONFIG_K3_AM654_DDRSS)
62 	struct udevice *dev;
63 	int ret;
64 #endif
65 	/*
66 	 * Cannot delay this further as there is a chance that
67 	 * K3_BOOT_PARAM_TABLE_INDEX can be over written by SPL MALLOC section.
68 	 */
69 	store_boot_index_from_rom();
70 
71 	/* Make all control module registers accessible */
72 	ctrl_mmr_unlock();
73 
74 #ifdef CONFIG_CPU_V7R
75 	setup_k3_mpu_regions();
76 #endif
77 
78 	/* Init DM early in-order to invoke system controller */
79 	spl_early_init();
80 
81 	/* Prepare console output */
82 	preloader_console_init();
83 
84 #ifdef CONFIG_K3_AM654_DDRSS
85 	ret = uclass_get_device(UCLASS_RAM, 0, &dev);
86 	if (ret) {
87 		printf("DRAM init failed: %d\n", ret);
88 		return;
89 	}
90 #endif
91 }
92 
93 u32 spl_boot_mode(const u32 boot_device)
94 {
95 #if defined(CONFIG_SUPPORT_EMMC_BOOT)
96 	u32 devstat = readl(CTRLMMR_MAIN_DEVSTAT);
97 	u32 bootindex = readl(K3_BOOT_PARAM_TABLE_INDEX_VAL);
98 
99 	u32 bootmode = (devstat & CTRLMMR_MAIN_DEVSTAT_BOOTMODE_MASK) >>
100 			CTRLMMR_MAIN_DEVSTAT_BOOTMODE_SHIFT;
101 
102 	/* eMMC boot0 mode is only supported for primary boot */
103 	if (bootindex == K3_PRIMARY_BOOTMODE &&
104 	    bootmode == BOOT_DEVICE_MMC1)
105 		return MMCSD_MODE_EMMCBOOT;
106 #endif
107 
108 	/* Everything else use filesystem if available */
109 #if defined(CONFIG_SPL_FAT_SUPPORT) || defined(CONFIG_SPL_EXT_SUPPORT)
110 	return MMCSD_MODE_FS;
111 #else
112 	return MMCSD_MODE_RAW;
113 #endif
114 }
115 
116 static u32 __get_backup_bootmedia(u32 devstat)
117 {
118 	u32 bkup_boot = (devstat & CTRLMMR_MAIN_DEVSTAT_BKUP_BOOTMODE_MASK) >>
119 			CTRLMMR_MAIN_DEVSTAT_BKUP_BOOTMODE_SHIFT;
120 
121 	switch (bkup_boot) {
122 	case BACKUP_BOOT_DEVICE_USB:
123 		return BOOT_DEVICE_USB;
124 	case BACKUP_BOOT_DEVICE_UART:
125 		return BOOT_DEVICE_UART;
126 	case BACKUP_BOOT_DEVICE_ETHERNET:
127 		return BOOT_DEVICE_ETHERNET;
128 	case BACKUP_BOOT_DEVICE_MMC2:
129 	{
130 		u32 port = (devstat & CTRLMMR_MAIN_DEVSTAT_BKUP_MMC_PORT_MASK) >>
131 			    CTRLMMR_MAIN_DEVSTAT_BKUP_MMC_PORT_SHIFT;
132 		if (port == 0x0)
133 			return BOOT_DEVICE_MMC1;
134 		return BOOT_DEVICE_MMC2;
135 	}
136 	case BACKUP_BOOT_DEVICE_SPI:
137 		return BOOT_DEVICE_SPI;
138 	case BACKUP_BOOT_DEVICE_HYPERFLASH:
139 		return BOOT_DEVICE_HYPERFLASH;
140 	case BACKUP_BOOT_DEVICE_I2C:
141 		return BOOT_DEVICE_I2C;
142 	};
143 
144 	return BOOT_DEVICE_RAM;
145 }
146 
147 static u32 __get_primary_bootmedia(u32 devstat)
148 {
149 	u32 bootmode = (devstat & CTRLMMR_MAIN_DEVSTAT_BOOTMODE_MASK) >>
150 			CTRLMMR_MAIN_DEVSTAT_BOOTMODE_SHIFT;
151 
152 	if (bootmode == BOOT_DEVICE_OSPI || bootmode ==	BOOT_DEVICE_QSPI)
153 		bootmode = BOOT_DEVICE_SPI;
154 
155 	if (bootmode == BOOT_DEVICE_MMC2) {
156 		u32 port = (devstat & CTRLMMR_MAIN_DEVSTAT_MMC_PORT_MASK) >>
157 			    CTRLMMR_MAIN_DEVSTAT_MMC_PORT_SHIFT;
158 		if (port == 0x0)
159 			bootmode = BOOT_DEVICE_MMC1;
160 	} else if (bootmode == BOOT_DEVICE_MMC1) {
161 		u32 port = (devstat & CTRLMMR_MAIN_DEVSTAT_EMMC_PORT_MASK) >>
162 			    CTRLMMR_MAIN_DEVSTAT_EMMC_PORT_SHIFT;
163 		if (port == 0x1)
164 			bootmode = BOOT_DEVICE_MMC2;
165 	}
166 
167 	return bootmode;
168 }
169 
170 u32 spl_boot_device(void)
171 {
172 	u32 devstat = readl(CTRLMMR_MAIN_DEVSTAT);
173 	u32 bootindex = readl(K3_BOOT_PARAM_TABLE_INDEX_VAL);
174 
175 	if (bootindex == K3_PRIMARY_BOOTMODE)
176 		return __get_primary_bootmedia(devstat);
177 	else
178 		return __get_backup_bootmedia(devstat);
179 }
180 #endif
181 
182 #ifndef CONFIG_SYSRESET
183 void reset_cpu(ulong ignored)
184 {
185 }
186 #endif
187