1 /*
2  * (C) Copyright 2009
3  * Marvell Semiconductor <www.marvell.com>
4  * Written-by: Prafulla Wadaskar <prafulla@marvell.com>
5  *
6  * Derived from drivers/spi/mpc8xxx_spi.c
7  *
8  * SPDX-License-Identifier:	GPL-2.0+
9  */
10 
11 #ifndef __KW_SPI_H__
12 #define __KW_SPI_H__
13 
14 /* SPI Registers on kirkwood SOC */
15 struct kwspi_registers {
16 	u32 ctrl;	/* 0x10600 */
17 	u32 cfg;	/* 0x10604 */
18 	u32 dout;	/* 0x10608 */
19 	u32 din;	/* 0x1060c */
20 	u32 irq_cause;	/* 0x10610 */
21 	u32 irq_mask;	/* 0x10614 */
22 	u32 timing1;	/* 0x10618 */
23 	u32 timing2;	/* 0x1061c */
24 	u32 dw_cfg;	/* 0x10620 - Direct Write Configuration */
25 };
26 
27 /* They are used to define CONFIG_SYS_KW_SPI_MPP
28  * each of the below #defines selects which mpp is
29  * configured for each SPI signal in spi_claim_bus
30  * bit 0: selects pin for MOSI (MPP1 if 0, MPP6 if 1)
31  * bit 1: selects pin for SCK (MPP2 if 0, MPP10 if 1)
32  * bit 2: selects pin for MISO (MPP3 if 0, MPP11 if 1)
33  */
34 #define MOSI_MPP6	(1 << 0)
35 #define SCK_MPP10	(1 << 1)
36 #define MISO_MPP11	(1 << 2)
37 
38 /* Control Register */
39 #define KWSPI_CSN_ACT		(1 << 0) /* Activates serial memory interface */
40 #define KWSPI_SMEMRDY		(1 << 1) /* SerMem Data xfer ready */
41 #define KWSPI_CS_SHIFT		2	/* chip select shift */
42 #define KWSPI_CS_MASK		0x7	/* chip select mask */
43 
44 /* Configuration Register */
45 #define KWSPI_CLKPRESCL_MASK	0x1f
46 #define KWSPI_CLKPRESCL_MIN	0x12
47 #define KWSPI_XFERLEN_1BYTE	0
48 #define KWSPI_XFERLEN_2BYTE	(1 << 5)
49 #define KWSPI_XFERLEN_MASK	(1 << 5)
50 #define KWSPI_ADRLEN_1BYTE	0
51 #define KWSPI_ADRLEN_2BYTE	(1 << 8)
52 #define KWSPI_ADRLEN_3BYTE	(2 << 8)
53 #define KWSPI_ADRLEN_4BYTE	(3 << 8)
54 #define KWSPI_ADRLEN_MASK	(3 << 8)
55 #define KWSPI_CPOL		(1 << 11)
56 #define KWSPI_CPHA		(1 << 12)
57 #define KWSPI_TXLSBF		(1 << 13)
58 #define KWSPI_RXLSBF		(1 << 14)
59 
60 #define KWSPI_IRQUNMASK		1 /* unmask SPI interrupt */
61 #define KWSPI_IRQMASK		0 /* mask SPI interrupt */
62 #define KWSPI_SMEMRDIRQ		1 /* SerMem data xfer ready irq */
63 
64 #define KWSPI_TIMEOUT		10000
65 
66 #endif /* __KW_SPI_H__ */
67