1 /*
2  * (C) Copyright 2009
3  * Marvell Semiconductor <www.marvell.com>
4  * Written-by: Prafulla Wadaskar <prafulla@marvell.com>
5  *
6  * Derived from drivers/spi/mpc8xxx_spi.c
7  *
8  * SPDX-License-Identifier:	GPL-2.0+
9  */
10 
11 #ifndef __KW_SPI_H__
12 #define __KW_SPI_H__
13 
14 /* SPI Registers on kirkwood SOC */
15 struct kwspi_registers {
16 	u32 ctrl;	/* 0x10600 */
17 	u32 cfg;	/* 0x10604 */
18 	u32 dout;	/* 0x10608 */
19 	u32 din;	/* 0x1060c */
20 	u32 irq_cause;	/* 0x10610 */
21 	u32 irq_mask;	/* 0x10614 */
22 };
23 
24 /* They are used to define CONFIG_SYS_KW_SPI_MPP
25  * each of the below #defines selects which mpp is
26  * configured for each SPI signal in spi_claim_bus
27  * bit 0: selects pin for MOSI (MPP1 if 0, MPP6 if 1)
28  * bit 1: selects pin for SCK (MPP2 if 0, MPP10 if 1)
29  * bit 2: selects pin for MISO (MPP3 if 0, MPP11 if 1)
30  */
31 #define MOSI_MPP6	(1 << 0)
32 #define SCK_MPP10	(1 << 1)
33 #define MISO_MPP11	(1 << 2)
34 
35 #define KWSPI_CLKPRESCL_MASK	0x1f
36 #define KWSPI_CLKPRESCL_MIN	0x12
37 #define KWSPI_CSN_ACT		1 /* Activates serial memory interface */
38 #define KWSPI_SMEMRDY		(1 << 1) /* SerMem Data xfer ready */
39 #define KWSPI_IRQUNMASK		1 /* unmask SPI interrupt */
40 #define KWSPI_IRQMASK		0 /* mask SPI interrupt */
41 #define KWSPI_SMEMRDIRQ		1 /* SerMem data xfer ready irq */
42 #define KWSPI_XFERLEN_1BYTE	0
43 #define KWSPI_XFERLEN_2BYTE	(1 << 5)
44 #define KWSPI_XFERLEN_MASK	(1 << 5)
45 #define KWSPI_ADRLEN_1BYTE	0
46 #define KWSPI_ADRLEN_2BYTE	(1 << 8)
47 #define KWSPI_ADRLEN_3BYTE	(2 << 8)
48 #define KWSPI_ADRLEN_4BYTE	(3 << 8)
49 #define KWSPI_ADRLEN_MASK	(3 << 8)
50 #define KWSPI_TIMEOUT		10000
51 
52 #endif /* __KW_SPI_H__ */
53