1/*
2 * SAMSUNG/GOOGLE Peach-Pit board device tree source
3 *
4 * Copyright (c) 2013 Samsung Electronics Co., Ltd.
5 *		http://www.samsung.com
6 *
7 * SPDX-License-Identifier:	GPL-2.0+
8 */
9
10/dts-v1/;
11#include "exynos54xx.dtsi"
12
13/ {
14	model = "Samsung/Google Peach Pi board based on Exynos5800";
15
16	compatible = "google,pit-rev#", "google,pit",
17		"google,peach", "samsung,exynos5800", "samsung,exynos5";
18
19	config {
20		google,bad-wake-gpios = <&gpx0 6 GPIO_ACTIVE_HIGH>;
21		hwid = "PIT TEST A-A 7848";
22		lazy-init = <1>;
23	};
24
25	aliases {
26		serial0 = "/serial@12C30000";
27		console = "/serial@12C30000";
28		pmic = "/i2c@12ca0000";
29	};
30
31	dmc {
32		mem-manuf = "samsung";
33		mem-type = "ddr3";
34		clock-frequency = <800000000>;
35		arm-frequency = <900000000>;
36	};
37
38	tmu@10060000 {
39		samsung,min-temp	= <25>;
40		samsung,max-temp	= <125>;
41		samsung,start-warning	= <95>;
42		samsung,start-tripping	= <105>;
43		samsung,hw-tripping	= <110>;
44		samsung,efuse-min-value	= <40>;
45		samsung,efuse-value	= <55>;
46		samsung,efuse-max-value	= <100>;
47		samsung,slope		= <274761730>;
48		samsung,dc-value	= <25>;
49	};
50
51	/* MAX77802 is on i2c bus 4 */
52	i2c@12ca0000 {
53		clock-frequency = <400000>;
54		power-regulator@9 {
55			compatible = "maxim,max77802-pmic";
56			reg = <0x9>;
57		};
58	};
59
60	i2c@12cd0000 { /* i2c7 */
61		clock-frequency = <100000>;
62	       soundcodec@20 {
63	              reg = <0x20>;
64	              compatible = "maxim,max98090-codec";
65	       };
66	};
67
68        sound@3830000 {
69                samsung,codec-type = "max98090";
70        };
71
72	i2c@12e10000 { /* i2c9 */
73		clock-frequency = <400000>;
74                tpm@20 {
75                        compatible = "infineon,slb9645-tpm";
76                        reg = <0x20>;
77		};
78	};
79
80	spi@12d30000 { /* spi1 */
81		spi-max-frequency = <50000000>;
82		firmware_storage_spi: flash@0 {
83			reg = <0>;
84
85			/*
86			 * A region for the kernel to store a panic event
87			 * which the firmware will add to the log.
88			*/
89			elog-panic-event-offset = <0x01e00000 0x100000>;
90
91			elog-shrink-size = <0x400>;
92			elog-full-threshold = <0xc00>;
93		};
94	};
95
96	spi@12d40000 { /* spi2 */
97		spi-max-frequency = <4000000>;
98		spi-deactivate-delay = <200>;
99		cros_ec: cros-ec@0 {
100			compatible = "google,cros-ec-spi";
101			reg = <0>;
102			spi-half-duplex;
103			spi-max-timeout-ms = <1100>;
104			ec-interrupt = <&gpx1 5 GPIO_ACTIVE_LOW>;
105
106			/*
107			 * This describes the flash memory within the EC. Note
108			 * that the STM32L flash erases to 0, not 0xff.
109			 */
110			#address-cells = <1>;
111			#size-cells = <1>;
112			flash@8000000 {
113				reg = <0x08000000 0x20000>;
114				erase-value = <0>;
115			};
116		};
117	};
118
119	xhci@12000000 {
120		samsung,vbus-gpio = <&gph0 0 GPIO_ACTIVE_HIGH>;
121	};
122
123	xhci@12400000 {
124		samsung,vbus-gpio = <&gph0 1 GPIO_ACTIVE_HIGH>;
125	};
126
127	fimd@14400000 {
128		samsung,vl-freq = <60>;
129		samsung,vl-col = <1920>;
130		samsung,vl-row = <1080>;
131		samsung,vl-width = <1920>;
132		samsung,vl-height = <1080>;
133
134		samsung,vl-clkp;
135		samsung,vl-dp;
136		samsung,vl-bpix = <4>;
137
138		samsung,vl-hspw = <80>;
139		samsung,vl-hbpd = <172>;
140		samsung,vl-hfpd = <60>;
141		samsung,vl-vspw = <10>;
142		samsung,vl-vbpd = <25>;
143		samsung,vl-vfpd = <10>;
144		samsung,vl-cmd-allow-len = <0xf>;
145
146		samsung,power-on-delay = <30000>;
147		samsung,winid = <3>;
148		samsung,interface-mode = <1>;
149		samsung,dp-enabled = <1>;
150		samsung,dual-lcd-enabled = <0>;
151
152		samsung,bl-en-gpio = <&gpx2 2 GPIO_ACTIVE_HIGH>;
153	};
154};
155
156#include "cros-ec-keyboard.dtsi"
157