1/* 2 * armboot - Startup Code for OMAP3530/ARM Cortex CPU-core 3 * 4 * Copyright (c) 2004 Texas Instruments <r-woodruff2@ti.com> 5 * 6 * Copyright (c) 2001 Marius Gröger <mag@sysgo.de> 7 * Copyright (c) 2002 Alex Züpke <azu@sysgo.de> 8 * Copyright (c) 2002 Gary Jennejohn <garyj@denx.de> 9 * Copyright (c) 2003 Richard Woodruff <r-woodruff2@ti.com> 10 * Copyright (c) 2003 Kshitij <kshitij@ti.com> 11 * Copyright (c) 2006-2008 Syed Mohammed Khasim <x0khasim@ti.com> 12 * 13 * SPDX-License-Identifier: GPL-2.0+ 14 */ 15 16#include <asm-offsets.h> 17#include <config.h> 18#include <asm/system.h> 19#include <linux/linkage.h> 20 21/************************************************************************* 22 * 23 * Startup Code (reset vector) 24 * 25 * Do important init only if we don't start from memory! 26 * Setup memory and board specific bits prior to relocation. 27 * Relocate armboot to ram. Setup stack. 28 * 29 *************************************************************************/ 30 31 .globl reset 32 .globl save_boot_params_ret 33 34reset: 35 /* Allow the board to save important registers */ 36 b save_boot_params 37save_boot_params_ret: 38 /* 39 * disable interrupts (FIQ and IRQ), also set the cpu to SVC32 mode, 40 * except if in HYP mode already 41 */ 42 mrs r0, cpsr 43 and r1, r0, #0x1f @ mask mode bits 44 teq r1, #0x1a @ test for HYP mode 45 bicne r0, r0, #0x1f @ clear all mode bits 46 orrne r0, r0, #0x13 @ set SVC mode 47 orr r0, r0, #0xc0 @ disable FIQ and IRQ 48 msr cpsr,r0 49 50/* 51 * Setup vector: 52 * (OMAP4 spl TEXT_BASE is not 32 byte aligned. 53 * Continue to use ROM code vector only in OMAP4 spl) 54 */ 55#if !(defined(CONFIG_OMAP44XX) && defined(CONFIG_SPL_BUILD)) 56 /* Set V=0 in CP15 SCTLR register - for VBAR to point to vector */ 57 mrc p15, 0, r0, c1, c0, 0 @ Read CP15 SCTLR Register 58 bic r0, #CR_V @ V = 0 59 mcr p15, 0, r0, c1, c0, 0 @ Write CP15 SCTLR Register 60 61 /* Set vector address in CP15 VBAR register */ 62 ldr r0, =_start 63 mcr p15, 0, r0, c12, c0, 0 @Set VBAR 64#endif 65 66 /* the mask ROM code should have PLL and others stable */ 67#ifndef CONFIG_SKIP_LOWLEVEL_INIT 68 bl cpu_init_cp15 69 bl cpu_init_crit 70#endif 71 72 bl _main 73 74/*------------------------------------------------------------------------------*/ 75 76ENTRY(c_runtime_cpu_setup) 77/* 78 * If I-cache is enabled invalidate it 79 */ 80#ifndef CONFIG_SYS_ICACHE_OFF 81 mcr p15, 0, r0, c7, c5, 0 @ invalidate icache 82 mcr p15, 0, r0, c7, c10, 4 @ DSB 83 mcr p15, 0, r0, c7, c5, 4 @ ISB 84#endif 85 86 bx lr 87 88ENDPROC(c_runtime_cpu_setup) 89 90/************************************************************************* 91 * 92 * void save_boot_params(u32 r0, u32 r1, u32 r2, u32 r3) 93 * __attribute__((weak)); 94 * 95 * Stack pointer is not yet initialized at this moment 96 * Don't save anything to stack even if compiled with -O0 97 * 98 *************************************************************************/ 99ENTRY(save_boot_params) 100 b save_boot_params_ret @ back to my caller 101ENDPROC(save_boot_params) 102 .weak save_boot_params 103 104/************************************************************************* 105 * 106 * cpu_init_cp15 107 * 108 * Setup CP15 registers (cache, MMU, TLBs). The I-cache is turned on unless 109 * CONFIG_SYS_ICACHE_OFF is defined. 110 * 111 *************************************************************************/ 112ENTRY(cpu_init_cp15) 113 /* 114 * Invalidate L1 I/D 115 */ 116 mov r0, #0 @ set up for MCR 117 mcr p15, 0, r0, c8, c7, 0 @ invalidate TLBs 118 mcr p15, 0, r0, c7, c5, 0 @ invalidate icache 119 mcr p15, 0, r0, c7, c5, 6 @ invalidate BP array 120 mcr p15, 0, r0, c7, c10, 4 @ DSB 121 mcr p15, 0, r0, c7, c5, 4 @ ISB 122 123 /* 124 * disable MMU stuff and caches 125 */ 126 mrc p15, 0, r0, c1, c0, 0 127 bic r0, r0, #0x00002000 @ clear bits 13 (--V-) 128 bic r0, r0, #0x00000007 @ clear bits 2:0 (-CAM) 129 orr r0, r0, #0x00000002 @ set bit 1 (--A-) Align 130 orr r0, r0, #0x00000800 @ set bit 11 (Z---) BTB 131#ifdef CONFIG_SYS_ICACHE_OFF 132 bic r0, r0, #0x00001000 @ clear bit 12 (I) I-cache 133#else 134 orr r0, r0, #0x00001000 @ set bit 12 (I) I-cache 135#endif 136 mcr p15, 0, r0, c1, c0, 0 137 138#ifdef CONFIG_ARM_ERRATA_716044 139 mrc p15, 0, r0, c1, c0, 0 @ read system control register 140 orr r0, r0, #1 << 11 @ set bit #11 141 mcr p15, 0, r0, c1, c0, 0 @ write system control register 142#endif 143 144#if (defined(CONFIG_ARM_ERRATA_742230) || defined(CONFIG_ARM_ERRATA_794072)) 145 mrc p15, 0, r0, c15, c0, 1 @ read diagnostic register 146 orr r0, r0, #1 << 4 @ set bit #4 147 mcr p15, 0, r0, c15, c0, 1 @ write diagnostic register 148#endif 149 150#ifdef CONFIG_ARM_ERRATA_743622 151 mrc p15, 0, r0, c15, c0, 1 @ read diagnostic register 152 orr r0, r0, #1 << 6 @ set bit #6 153 mcr p15, 0, r0, c15, c0, 1 @ write diagnostic register 154#endif 155 156#ifdef CONFIG_ARM_ERRATA_751472 157 mrc p15, 0, r0, c15, c0, 1 @ read diagnostic register 158 orr r0, r0, #1 << 11 @ set bit #11 159 mcr p15, 0, r0, c15, c0, 1 @ write diagnostic register 160#endif 161#ifdef CONFIG_ARM_ERRATA_761320 162 mrc p15, 0, r0, c15, c0, 1 @ read diagnostic register 163 orr r0, r0, #1 << 21 @ set bit #21 164 mcr p15, 0, r0, c15, c0, 1 @ write diagnostic register 165#endif 166 167 mov r5, lr @ Store my Caller 168 mrc p15, 0, r1, c0, c0, 0 @ r1 has Read Main ID Register (MIDR) 169 mov r3, r1, lsr #20 @ get variant field 170 and r3, r3, #0xf @ r3 has CPU variant 171 and r4, r1, #0xf @ r4 has CPU revision 172 mov r2, r3, lsl #4 @ shift variant field for combined value 173 orr r2, r4, r2 @ r2 has combined CPU variant + revision 174 175#ifdef CONFIG_ARM_ERRATA_798870 176 cmp r2, #0x30 @ Applies to lower than R3p0 177 bge skip_errata_798870 @ skip if not affected rev 178 cmp r2, #0x20 @ Applies to including and above R2p0 179 blt skip_errata_798870 @ skip if not affected rev 180 181 mrc p15, 1, r0, c15, c0, 0 @ read l2 aux ctrl reg 182 orr r0, r0, #1 << 7 @ Enable hazard-detect timeout 183 push {r1-r5} @ Save the cpu info registers 184 bl v7_arch_cp15_set_l2aux_ctrl 185 isb @ Recommended ISB after l2actlr update 186 pop {r1-r5} @ Restore the cpu info - fall through 187skip_errata_798870: 188#endif 189 190#ifdef CONFIG_ARM_ERRATA_801819 191 cmp r2, #0x24 @ Applies to lt including R2p4 192 bgt skip_errata_801819 @ skip if not affected rev 193 cmp r2, #0x20 @ Applies to including and above R2p0 194 blt skip_errata_801819 @ skip if not affected rev 195 mrc p15, 0, r0, c0, c0, 6 @ pick up REVIDR reg 196 and r0, r0, #1 << 3 @ check REVIDR[3] 197 cmp r0, #1 << 3 198 beq skip_errata_801819 @ skip erratum if REVIDR[3] is set 199 200 mrc p15, 0, r0, c1, c0, 1 @ read auxilary control register 201 orr r0, r0, #3 << 27 @ Disables streaming. All write-allocate 202 @ lines allocate in the L1 or L2 cache. 203 orr r0, r0, #3 << 25 @ Disables streaming. All write-allocate 204 @ lines allocate in the L1 cache. 205 push {r1-r5} @ Save the cpu info registers 206 bl v7_arch_cp15_set_acr 207 pop {r1-r5} @ Restore the cpu info - fall through 208skip_errata_801819: 209#endif 210 211#ifdef CONFIG_ARM_ERRATA_454179 212 cmp r2, #0x21 @ Only on < r2p1 213 bge skip_errata_454179 214 215 mrc p15, 0, r0, c1, c0, 1 @ Read ACR 216 orr r0, r0, #(0x3 << 6) @ Set DBSM(BIT7) and IBE(BIT6) bits 217 push {r1-r5} @ Save the cpu info registers 218 bl v7_arch_cp15_set_acr 219 pop {r1-r5} @ Restore the cpu info - fall through 220 221skip_errata_454179: 222#endif 223 224#ifdef CONFIG_ARM_ERRATA_430973 225 cmp r2, #0x21 @ Only on < r2p1 226 bge skip_errata_430973 227 228 mrc p15, 0, r0, c1, c0, 1 @ Read ACR 229 orr r0, r0, #(0x1 << 6) @ Set IBE bit 230 push {r1-r5} @ Save the cpu info registers 231 bl v7_arch_cp15_set_acr 232 pop {r1-r5} @ Restore the cpu info - fall through 233 234skip_errata_430973: 235#endif 236 237#ifdef CONFIG_ARM_ERRATA_621766 238 cmp r2, #0x21 @ Only on < r2p1 239 bge skip_errata_621766 240 241 mrc p15, 0, r0, c1, c0, 1 @ Read ACR 242 orr r0, r0, #(0x1 << 5) @ Set L1NEON bit 243 push {r1-r5} @ Save the cpu info registers 244 bl v7_arch_cp15_set_acr 245 pop {r1-r5} @ Restore the cpu info - fall through 246 247skip_errata_621766: 248#endif 249 250 mov pc, r5 @ back to my caller 251ENDPROC(cpu_init_cp15) 252 253#ifndef CONFIG_SKIP_LOWLEVEL_INIT 254/************************************************************************* 255 * 256 * CPU_init_critical registers 257 * 258 * setup important registers 259 * setup memory timing 260 * 261 *************************************************************************/ 262ENTRY(cpu_init_crit) 263 /* 264 * Jump to board specific initialization... 265 * The Mask ROM will have already initialized 266 * basic memory. Go here to bump up clock rate and handle 267 * wake up conditions. 268 */ 269 b lowlevel_init @ go setup pll,mux,memory 270ENDPROC(cpu_init_crit) 271#endif 272