1 /* 2 * nRF51 System-on-Chip general purpose input/output register definition 3 * 4 * QEMU interface: 5 * + sysbus MMIO regions 0: GPIO registers 6 * + Unnamed GPIO inputs 0-31: Set tri-state input level for GPIO pin. 7 * Level -1: Externally Disconnected/Floating; Pull-up/down will be regarded 8 * Level 0: Input externally driven LOW 9 * Level 1: Input externally driven HIGH 10 * + Unnamed GPIO outputs 0-31: 11 * Level -1: Disconnected/Floating 12 * Level 0: Driven LOW 13 * Level 1: Driven HIGH 14 * 15 * Accuracy of the peripheral model: 16 * + The nRF51 GPIO output driver supports two modes, standard and high-current 17 * mode. These different drive modes are not modeled and handled the same. 18 * + Pin SENSEing is not modeled/implemented. 19 * 20 * Copyright 2018 Steffen Görtz <contrib@steffen-goertz.de> 21 * 22 * This code is licensed under the GPL version 2 or later. See 23 * the COPYING file in the top-level directory. 24 * 25 */ 26 #ifndef NRF51_GPIO_H 27 #define NRF51_GPIO_H 28 29 #include "hw/sysbus.h" 30 #define TYPE_NRF51_GPIO "nrf51_soc.gpio" 31 #define NRF51_GPIO(obj) OBJECT_CHECK(NRF51GPIOState, (obj), TYPE_NRF51_GPIO) 32 33 #define NRF51_GPIO_PINS 32 34 35 #define NRF51_GPIO_SIZE 0x1000 36 37 #define NRF51_GPIO_REG_OUT 0x504 38 #define NRF51_GPIO_REG_OUTSET 0x508 39 #define NRF51_GPIO_REG_OUTCLR 0x50C 40 #define NRF51_GPIO_REG_IN 0x510 41 #define NRF51_GPIO_REG_DIR 0x514 42 #define NRF51_GPIO_REG_DIRSET 0x518 43 #define NRF51_GPIO_REG_DIRCLR 0x51C 44 #define NRF51_GPIO_REG_CNF_START 0x700 45 #define NRF51_GPIO_REG_CNF_END 0x77F 46 47 #define NRF51_GPIO_PULLDOWN 1 48 #define NRF51_GPIO_PULLUP 3 49 50 typedef struct NRF51GPIOState { 51 SysBusDevice parent_obj; 52 53 MemoryRegion mmio; 54 qemu_irq irq; 55 56 uint32_t out; 57 uint32_t in; 58 uint32_t in_mask; 59 uint32_t dir; 60 uint32_t cnf[NRF51_GPIO_PINS]; 61 62 uint32_t old_out; 63 uint32_t old_out_connected; 64 65 qemu_irq output[NRF51_GPIO_PINS]; 66 } NRF51GPIOState; 67 68 69 #endif 70